The plant runs at 300r.p.m. and each cylinder has a volumetricThe specific heat capacity of liquid ammonia =diagrams and showing all given and calculated values;QUESTION 31.5kJ/kgKCalculate:4.2 the mass flow rate of refrigerant per second;4.3 the refrigeration effect per second;4.4 the power to drive the compressor if the mechanical efficiency is 80%.

Answered: Image /qna-images/answer/4e1ea036-4bcd-4510-ab45-95a2d3b8e847.jpg

4.1 the coefficient of performance and sketch the P-H and T-S diagrams and showing all given and calculated values; efficiency of 75%. At exit from the compressor, the refrigerant is The plant runs at 300r.p.m. and each cylinder has a volumetric The specific heat capacity of liquid ammonia = 1.5kJ/kgK QUESTION 3 Calculate: 4.2 the mass flow rate of refrigerant per second; 4.3 the refrigeration effect per second; officiency is 80%.

4.1 the coefficient of performance and sketch the P-H and T-S diagrams and showing all given and calculated values; efficiency of 75%. At exit from the compressor, the refrigerant is The plant runs at 300r.p.m. and each cylinder has a volumetric The specific heat capacity of liquid ammonia = 1.5kJ/kgK QUESTION 3 Calculate: 4.2 the mass flow rate of refrigerant per second; 4.3 the refrigeration effect per second; officiency is 80%.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. The actual specific evaporation of a certain boiler is 10. Factor of evaporation is 1.05. If the heating value of fuel is 30,000 kJ/kg, find the boiler efficiency. 3. Two boilers are operating steadily on 91000 kg of coal contained in a bunker. One boiler is producing 1591 kg of steam per hour at 1.2 factor of evaporation and an efficiency of 65% and another boiler produces 1364 kg of steam per hour at 1.15 factor for evaporation and efficiency of 60%. How many hours will coal in the bunker run the boilers if the heating value of coal is 7590 kcal/kg?
14. Air is contained in a piston - cylinder arrangement. The following data were gathered: P= 700 KPa,V -010 m/kg.m, and u, = 160 KJ/kgm. The air expands slowly with the pressure remaining constant until the specific volume becomes, V2= 0.20 m³/kg. and the internal energy becomes, u2 = 310 KJ/kgm- Calculate the work done by the gas and the heat transferred.
Exactly 10 kg of steam entered a heat exchanger at 100 bar and 560o C. At the exit the Steam was at 30 bar and a quality of 0.47. Please determine a. The exit temperature in oC. b. The mass of the liquid water in kg.
Refrigerant-134a is in an insulated canister with temperature 25 C. There is a partition in the canister so the refrigerant is a saturated liquid and takes up 1/100 of the volume of the canister. The rest of the volume is evacuated. When the canister is activated by squeezing (no work done activating) the partition breaks and the refrigerant fills the total volume. Final pressure is 100 kPa. a.) What are two assumptions needed for the problem? What properties are needed to solve part b.) and c.) b.) What is the change in specific enthalpy within the canister? c.) What is the final quality of the refrigerant within the canister?
1. Outside air of an air conditioning system is 25% of recirculated air. Determine the mass of outside air if mass of supply air is 15kg/s?
Q-1(c): Consider a case in which the air inside the pressurized cabin of a jet transport flying at some altitude of pressure, 0.9 atm and of temperature, 15°C. The total volume of air at any instant inside the cabin is 1800m3. If the air in the cabin is completely recirculated through the air conditioning system every 20 min, calculate the mass flow of air in kg/s through the system. I Answer:
The pressure of the air in a starting vessel is 40 bar and the temperature is 24°C. If a fire in the vicinity causes the temperature to rise to 65 °C. Neglect anyincrease in the volume of the vessel which is 5 liters. Please answer the following a. The thermodynamic process the problem representsb. the pressure, temperature, and volume after the processc. change in internal energy, change in enthalpy and change in entropyd. work nonflow and heat transferred
1. Two kilograms of air at a pressure of 2.25 MPa and temperature of 27C is heated atconstant volume to a final pressure of 2.5 MPa. Compute for the:a. Change in internal energyb. Change in enthalpyc. Change in entropyd. Heat transferrede. Non-flow work 2. In a constant pressure process, 325 KJ of heat are added to 6.55 kg of ideal gas(R=208 J/kg-K and k = 1.65) initially at 290 K. Calculate:a. Final Temperatureb. Change in enthalpyc. Change in internal energyd. Change in entropye. Non-flow work
Steam enters the steam-generating unit at a pressure of 20 bar and dryness of 0.96 and leaves at the same pressure at a temperature of 350°C. Mass flow rate of steam is 5 kg/s. Find the percentage increase in volume (%) due to drying and superheating.
3. A water-tube boiler having a heating surface of 325.23 m² evaporates 6349.21 kg of water in an hour from a feed temperature of 66 °C. Boiler pressure is at 1.04 MPaa and the steam quality at the boiler outlet is 99 %. What percent of its rated Bo. Hp was the boiler developing?
a rigid 3ft ^3 vessel contains R-134 a originally at -20 F and 27.7 percent quality. The refrigerant is then heated until its temperture is 100 F. Calcuate the heat transfer required to do this. Use data from the refrigerant tables. The heat transfer required to heat the refrigerant is _____ Btu.
A volume flow of air at 500K, 20 bar passes in a long pipe through a temperature reservoir that is kept at a temperature of 1000°C. The air exits at 1000K and 1.8 MPa. Air as ideal gas with variable specific heats, R = 0.287 KJ/Kg-k a) Draw a sketch of the system, and draw the process into a T-s-diagram with respect to isobaric lines. b) What is the heating rate per unit mass of air passing through? c) What is the entropy generation rate per unit mass flowing through?