4- Which is not a main function of filter in damsa)Direct the flow pathb)Prevent erosionProvide safety against pipingd) O Reduce uplift pressures

Answered: 4- Which is not a main function of…

4- Which is not a main function of filter in dams a) Direct the flow path b) O Prevent erosion c) Provide safety against piping d) Reduce uplift pressures

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 14. Use the open auger hole procedure to determine a numerical value of permeability for a…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: : Given e-o5 ,0.8% 1:0 a Sand coith Gro267- for Required what is thearitial hydraulic gradient (Ce)…

Q: Given: Rate of infiltration, in/hr 3.5 Final capacity, in/hr 0.4 Horton k, hr 1 0.3 Solve for the…

A: Given data in question Rate of infiltration Final capacity Constant value Time To find out…

Q: A municipal WWTP receives 20,000m3/d of flow. They use two circular primary clarifiers operate in…

Q: (b) Given data : K =0.3 hr¹, K₂ =0.3 hr¹; fo =0.75 in/hr, fc = 0.25 in/hr. 0.1 0.2 2 1.0 3 0.8 t(hr)…

A: Given: fc=infiltration capacity at any time t,=0.25 in/hr fo=initial infiltration capacity=0.75…

Q: There are two different areas A and B to be trained by means of closed tile drainage KA = 2; LA 2…

A: Given data- k=permeabilitykAkB=2L=spacingLALB=2Q=discharge

Q: Determine the hydrologic risk

Q: A bar screen is used to treat 10 MGD of menicipal wastewater. The vertical bars are 1.27 cm wide and…

Q: . To provide safety against piping failure, with a factor of safety of 5, what should be he maximum…

A: A piping failure case-

Q: 15m length concrete dam with water level 5 meter at the upper level and 1m at lower level three…

A: Here for lowest flow line , Keq=K3= 1 x 10^-6 m/s

Q: 2.34. Water flows in a 100-m long pipe at 3 m/s. If the water temperature is 20°C, determine the…

A: The given values are as follows, Pile length(L)=100mTemprature(t)=20°CTo determineMinimum valve…

Q: Rapid Sand Filter - Example • Determine the minimum number of rapid sand filters necessary to treat…

Q: Design a composite pipe drain of parallel grid system to be installed, ten laterals are joint a…

A: To design a composite pipe drain of parallel grid system, we need to determine the spacing between…

Q: Given the following parameters, give the required diameter of reinforced concrete pipe needed for…

Q: Describe about the consolidated–drained (C–D) shear test.

A: Shear test is used to determine the shear parameter of the soil.

Q: Given: Rate of infiltration, in/hr 2.4 Final capacity, in/hr 0.3 Horton k, hr 1 0.4 Solve for the…

Q: 3. Determine the geometry that must be given to a trapezoidal channel with minimum infiltration that…

Q: The main requirement of permanent structures to control and conserve water is: Select one a . Using…

A: A permanent structure refers to any building or structure which is constructed as per norms and…

Q: Design a composite pipe drain of parallel grid system to be installed, ten laterals are joint a…

A: We need to determine the dimensions and layout of the laterals and the collector. The design should…

Q: Why does infiltration rate decrease with time under constant rainfall?

A: Infiltration rate decrese with time under constant rainfall because Water that percolates into the…

Q: (a) Discuss the basic concept used in making operation of an outlet as “Flexible” and “Rigid”. What…

A: A small structure that is constructed at the head of the watercourse to make the connection with a…

Q: A 1.5 hr storm of intensity 25 mm/hr occurs over a basin for which the Horton’s equation is…

A: Given:- Intensity = 25 mm/h for 1.5 hr Horton's equation is f=6+16e-2t To find:- Depth of…

Q: a plastic tile drain pipe is installed to carry a design flow from 3000ft of tile spaced 140 ft . if…

A: The Design discharge for tile drainage is given by: Where, L = Tile spacing i = Drainage rate

Q: At a wastewaterdischarge point, 2500 L/s of effluent must be conveyedin a straight rectangular…

A: Q = Discharge = 2500 L/s = 2.5 m3/sy = Depth of flow = 0.55 m.b = Width of base = 1.8 mThe channel…

Q: Sandstone reservoir rock that has porosity 19% and flow zone indicator 0.0247 um.Calculate the…

A: Given- ϕ=19%FZI=0.0247μmValue of permeability for sandstone=10-10m/s

Q: h' ORIGIN R2 Hd L1 given Design head =4.2 Height of dam = 37,0 Calculate b and L1 O A. b= 0.73 , L1…

A: Given:- Design head h'=4.2 mHeight of dam Hd=37.0 m

Q: Given: Rate of infiltration, in/hr 3.1 Final capacity, in/hr 0.3 Horton k, hr1 0.4 Solve for the…

Q: A storm system includes a composite gutter section with a design spread of Tw = 8 ft, a cross-slope…

Q: What is zero tillage?

A: The mechanical manipulation of soil to produce the desired effect in which certain tools are used to…

Q: Discuss three factors that could affect evaporation rates

A: This question is related to the Hydrology Engineering from Civil Engineering. In this question ask…

Q: Design a wastewater treatment primary clarifier for an average flow rate of 1.10 MGD, and a peak…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Why are vertical drains used with preload? a. Reduces total consolidation settlements b. Increases…

A: Why are vertical drains used with preload? We have to find out the correct answer from the given…

Q: 5. When deslgning hydraulic structures, like brldges, what procedure might reduce total costs? a.…

A: There exist many criteria in design of hydraulic structures that need to be optimized simultaneously…

Q: A horizontal impervious floor of length 20 m is provided with a cutoff of a 4 m depth at its…

A: A horizontal impervious floor having, Length, b = 20 m. Depth at its downstream end, cutoff, d = 4…

Q: There is a guyed tower stack as shown. The weight of the guyed tower stack is 66,723 N. It is…

A: The seismic source is equipment that generates controlled seismic energy that can be used to perform…

Q: 4- Which of the following formation 2 points does not contain any ground water? Aquifer Aquitard…

Q: (c) A sewage treatment plant is designed for an a circular primary clarifiers are arranged in…

A: cWe know weir length = πD for one clarifierso2πD=70mD=11.1408m

Q: Select the filter material sizes of sub-drain at a highway embankment for the surrounding soil grain…

A: Given DataD15=0.063 mmD85=2.36 mmdiameter of preforated pipe is 9.5 mm% fineness=0.063+2.36100%…

Q: Q3 a) A primary clarifier is 3 m wide, 15 m long, and has a side water depth of 2.5 m. The clarifier…

A: Solution Given Data L=15m = 49.21 ft B= 3 m= 9.84 ft Side water depth= 2.5 m = 8.20 ft

Q: Which of the following material would you prefer to manufacture bridge approach fills in a more…

A: Which of the following material would you prefer to manufacture bridge approach fills in a more…

Q: drainage system. KA If = KB 1 SA 1 SB 1.5 Find the ratio = Find the ratio There are two different…

Q: Q4-A) Design a Grit chamber for the following condition: 2max=4000 m³/day Qavg= 1500 m³/day,Qmin 0.3…

Q: 2. The sedimentation portion of the in-line treatment plant is to be designed. The proposed design…

A: Given Width of sedimentation tank = 130 ft Length of sedimentation tank= 180 ft Depth of…

Question

4- Which is not a main function of filter in dams
a)
Direct the flow path
b)
Prevent erosion
Provide safety against piping
d) O Reduce uplift pressures

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Municipal solid waste characteristics and quantities

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

TW DISCHARGE the solution for this case is Select one: O A. Build a sloping apron O B. A simple concrete apron O C. A secondary dam or sill provide a satisfactory jump at high discharge and baffle piers may be used to break up the flow. D. A secondary dam or stilling pool. O E. Provide a sloping apron between the main and secondary dams. NATER LEVEL
What should be the drainage capacity of the collector pipe? K=5 x 10-4 cm/s
Match Column X with Column Y: Column X (P) (Q) Horton equation (I) Penman method (II) (R) Chezy's formula Lacey's theory (III) (S) (IV) Infiltration (T) Dicken's formula (V) Flow velocity Which one of the following combinations is correct? A Column Y Design of alluvial char Maximum flood discha Evapotranspiration B с (P)-(IV), (Q)-(III), (R)-(V), (S)-(I), (T)-(II) (P)-(III), (Q)-(IV), (R)-(V), (S)-(I), (T)-(II) (P)-(IV), (Q)-(III), (R)-(II), (S)-(I), (T)-(V) (P)-(III), (Q)-(IV), (R)-(I), (S)-(V), (T)-(II)
Calculate the quantity of seepage from upstream to downstream Calculate the uplift force and its location under the dam Calculate the safety factor for uplift force.
What is the minimum diameter at section (1) in the pipe below to avoid cavitation at that location? Take D2 = 15 cm. Neglect friction head loss in the pipe.
Figure 1 below are portions of flow nets. State "what is wrong" with the flow nets. Filter b) Figure 1
ANSWER URGENTLY
Direction: Choose A- When both statements are true; B - When both statements are false; C- When the first statement is true and the second statement is false; D- When the first statement is false and the second statement is true. First Statement: Springs form when the water table crosses the rooting depth from the ground surface. Second Statement: Saltwater intrusion is one of the causes of land subsidence. B
A circular clarifier has diameter of 75 feet with an in-board launder (2 feet wide) set at 65 feet diameter. The Clarifier receives 2.9 mgd. What is the Overflow rate (OFR) and what is the Weir Loading Rate. If the Clarifier also has a depth of 14 feet, what is the detention time. LIGHT POLE BRACKET SET NO LAS COLE PAHALLD (P) P922 INFLUENT FEEDWELL ClALIER DIA Launder Dia WALKWAY BRIDGE SLUDGE DOLLECTOR WECHANISM -TAKE ARM CLUDGE HOPPER B SECTION 1/81-0 TAS100 LAUNDER SAFETY LIFE LAUNdee ASSUME CIRCULAR 24 SE EL 200 LEX GROOVED END (PLG (TYP)
HIGHWAY ENGINERING
NaOCI pumping rate, Qss = () L/s? (*No unit) Qin = 8000 GPM Cin = 0.0 mg/L Slip Stream Qss = ? L/s Css = 200 mg/L Main service line Qout = 8000 GPM Cout = 4.0 mg/L %3D
A concrete gravity dam is 100 ft long from upstream to downstream end. It is constructed on a stratum of sand–silt soil 40 ft thick. The coefficient of permeability for this soil is 0.1 ft per day. Rock underlies the soil stratum. The bottom of the dam is 6 ft below the soil surface. (a) For the condition where the height of water against the upstream face of the dam is 45 ft above the soil surface and the water level at the downstream end is just at the soil surface, draw the flow net for seepage beneath the dam and calculate the quantity of seepage in gallons per day per foot of width of dam. (b) For the condition where the height of water against the upstream face of the dam is 35 ft above the soil surface and the water level at the downstream end is 5 ft above the soil surface, draw the flow net for seepage beneath the dam and compute the seepage in gallons per day per foot of width of dam.