Put all the decimal points from the calculator. Item #:4A 100-mH inductor is connected in parallel to the series connection of a variable resistorR and a 20-µF capacitor. The circuit is energized by a 120 Vac, 60-Hz supply. Find thevalue of R such that the total circuit current is 2.302305Z – 86.6782° A.

Answered: Image /qna-images/answer/c224548e-774a-4aee-a983-073e3b6807f6.jpg

4 A 100-mH inductor is connected in parallel to the series connection of a variable resi R and a 20-µF capacitor. The circuit is energized by a 120 Vac, 60-Hz supply. Find value of R such that the total circuit current is 2.302305Z – 86.6782° A.

4 A 100-mH inductor is connected in parallel to the series connection of a variable resi R and a 20-µF capacitor. The circuit is energized by a 120 Vac, 60-Hz supply. Find value of R such that the total circuit current is 2.302305Z – 86.6782° A.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Given A = 4a + a_and vectors B = 2a_ + 3a , find the scalar projection of A on B.

A: The detailed solution is provided below.

Q: For the diagram shown below find fault current If in terms of their fault impedance with their equiv...

A: Given the circuit diagram, The above circuit is a three-phase generator with a fault current across...

Q: Problem 3: For the system with the block diagram shown in Figure 3, assign conditions on control gai...

A: I am attaching detailed solution image of this question.

Q: A 25 Kva ,2500/250 V single phase transformer is designed to have a induced voltage of 2.5 Volts/tur...

Q: Determine the voltage V using Mesh Analysis. 13 4ΩV 1 A 312 0 8 V ± -27 2

A: Given circuit: R=27 Ω To find: Determine the voltage V using mesh analysis.

Q: 230 V A 35 Ohm 35 Ohm B I21 I5 (b) I3 I4t 210 V 25 Ohm) _210V 210 V 15 Ohm 25 Ohm 15 Ohm C

A: Given

Q: .) An incandescent lamp, rated at 100 watts, gives a certain amount of light when placed across the ...

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: 40 kM 10 kN 20 kN 02 A 100 V 4 V 80 kN

A: the total number of nodes is only 1, which is ground node. For node identification in circuit please...

Q: VoD carry out VDD sum B.

A: General examples:

Q: 2l Find the inVerse trans formf (Fs) Fess=( 55+4 25-18

A: Given F(s)=(5s+4s3-2s-18s2+9)

Q: Use the node-voltage method to find how much power the current source extracts from the circuit if i...

Q: Find the two elements in a series circuit (i.e., R an

Q: A 220 V shunt motor has armature and field resistance of 0.2 2 and 220 2 respectively. The motor is ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: The cost of a single phase overhead feeder is OMR 17 a per km (a is area of cross section in sq mm) ...

Q: Ry-6R Riase VabI Ezz 18

Q: QUESTION 38 For the step down transformer below the turns ratio is 7:1, the primary voltage is 91 V ...

Q: Q1/A-What is the total cost of using the following at 4c per kilowatthour? a) 600 W air conditioner ...

A: we have given a) 600 W air conditioner for 8 h b) 2800 W clothes dryer for 45 min c) 850 W coffee ...

Q: 2.5Kh 1.25H 12cos(WE)V huf a) sketen the frequency dontzin iepresen tation af the circ wit. Indicate...

Q: direct current in our transmission lines

A: DC and AC current- Current that which changes its direction frequently is called alternating current...

Q: Given the simple BJT inverter below where R1 = 1kN, Vcc = 5V and VEC, sat = 0.25V Vcc VINO OVOUT R1 ...

A: Given: The simple BJT inverter below: where R1=1 kΩVCC=5 VVEC,sat=0.25 V To find: 1. VOH 2. VOL

Q: rotational mechanical system

Q: Find I, in the circuit. 20 150/20° V 30 ww

Q: Voltages are represented by: e = 20sinwt ez = 30sin (wt – ) ez = 40cos (wt +=) e4 = -15sin wt es = -...

A: Given: The voltages are represented as: e1=20sinωte2=30sinωt-π4e3=40cosωt+π6e4=-15sinωte5=-25cosωt-π...

Q: Describe Schmitt Trigger as one of an OTA applications

Q: A passive RLC filter circuit is given below. Vin V out a. Determine an expression for the voltage tr...

Q: A 6 pole, 3 phase, 50 Hz alternator has 12 slots per pole and 4 conductors per slot. The winding is ...

A: This question belongs to electrical machine . It is based on induced e.m.f. per phase in a three ph...

Q: 2. A wire carries a currenti = 3cos314t A. What is the average current over 6 seconds?

A: Given : t=6s The current in wire is given as : i=3cos314t The average current over t seconds is giv...

Q: Part A Use the mesh-current method to find the total power dssipated in the circuit in (Eigure 1). S...

A: In this question we need to find a power dissipation in the given circuit. To calculate power dissip...

Q: Find the mesh current I, and I2 for the given circuit 3Ω j4 N 4Ω -j6 2 5Ω 6/30 V I2 8-15 V ry 10/65 ...

Q: 2) Find: eo(s)/ei(s), if R1=R3=10kohms, R2=R4=100kohms, Cl=C2=10microfarad. R2 C2 R4 ww R3 R1 eo

Q: AM modulator

A: Amplitude modulation- A process in which a wave signal is transferred by it's amplitude modulation i...

Q: A 1500 W portable heater will use 1.5 kW per hour. In 4 hours, it would use _______ Horsepower

Q: QUESTION 36 For the step down transformer below the turns ratio is 4: 1, the primary voltage is 170 ...

A: This question belongs to electrical machine . It is based on the concept of power developed in singl...

Q: Two similar 6,600-V, 3-φ, generators are running in parallel on constant-voltage and frequency bus ...

Q: 2. Three equal positive charges of 10 statC each are located at the vertices of an equilateral trian...

Q: Vcc DHD 1, 3 1 1 24

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to ...

Q: Use Laplace transform to solve the initial value problem y" + 4y = cos 2t, y(0) = 1, y'(0) = 1.

Q: Draw a layout of a typical supply systems with both 1-phase and 3-phase loads mentioning different v...

A: Single-phase supply system: Most electrical power, when delivered at the power plants, is created as...

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

A: We have given the resistor and capacitor are connected with supply which is 250 V where in first ca...

Q: State the kelvin's law for economic section

Q: For the circuit below, find the current I. 20 j60 ell HE -j20 j20 ell 10 I -j20 j40 24 Va -j20 Figur...

A: The solution is given below

Q: Find Zth and Vth for the Thevenin equivalent of the given circuit 20 2 j25 2 O a 120/40 V () 650 A -...

Q: Question 8 of 8 6 Points Fill in the blanks: 2 ka +10 Vo 2 k2 2 k2 Figure 2.142 Problems 13, 51 13: ...

Q: A 6 pole, 3 phase, 50 Hz alternator has 12 slots per pole and 4 conductors per slot. The winding is ...

Q: whe Q1 2. Qi find the Q1 collector current

Q: CONSIDERING THE CIRCUIT OF FIGURE 2. THE INPUT FUNCTION OF V(T) IS THE VOLTAGE PULSE SHOWN IN FIGURE...

A: First, let us convert the voltage source to current source using source transformation. ...

Q: 1) Find: V.(s)/V(s), if R2=R1=2ohms, R3=3ohms, C1=C2=1F and L=2H. R1 U2 Output R3 o voltage

A: I'm attaching detailed solution images of this question.

Q: Calculate the maximum load current ILmax in mA if E=12V, R=170 ohm, that will ensure that the voltag...

A: We need to find out maximum load current for given voltage regulator .

Q: - Y B- 에 C-

A: Note in the given circuit NMOS C and D are in OR configuration. C+D

Concept explainers

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.

Question

Put all the decimal points from the calculator.

Item #:
4
A 100-mH inductor is connected in parallel to the series connection of a variable resistor
R and a 20-µF capacitor. The circuit is energized by a 120 Vac, 60-Hz supply. Find the
value of R such that the total circuit current is 2.302305Z – 86.6782° A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Finding R

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Arithmetic Operation and Code Conversion in Number System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Three capacitors 6, 10 and 15 uF are connected in series across a 100 volt supply. Find the voltageacross the 10uF capacitor.
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higher
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
Using a positive Clamper Circuit, with an AC voltage of Vi = 13v with a frequency of 60hz, a value of 100u for the Capacitor, a silicon diode and a resistor with the value of 1000 ohms. Find the voltage value on the resistor at a simulation of 20ms. 2Vm Vm Vm Vo -Vm Input Waveform Output Waveform Positive Clamper circuit
Using a positive Clamper Circuit, with an AC voltage of Vi = 100v with a frequency of 30hz, a value of 1000u for the Capacitor, a silicon diode and a resistor with the value of 100 ohms. Find the voltage value on the resistor at a simulation of Oms. Vm 2Vm Mr. Vm Vo -Vm Input Waveform Output Waveform Positive Clamper circuit