37 - 39. Determine VO and ID. 20 V Si 2.2 k 4 V
Q: A capacitor having a capacitance of 20 microFarad is connected in series with a non-inductive resist...
A:
Q: QUESTION 9 Calculate the reactive power of a circuit that has a total impedance of 41kOZ41; and diss...
A:
Q: For what values of K is the DC gain of the closed-loop system less than 0.9 seconds? R(s) E(s) U(s) ...
A:
Q: Find the Apparent Power (rounded to 2 significant digits) for the following circuit: VT = 120V RMS, ...
A: The solution is given below
Q: If three Impedances each of (8-j 6) N are connected in mesh across a three-phase 400 V ac supply, th...
A:
Q: Given the circuit fed by 50HZ voltage source Vs, knowing that Z, is an inductive load with 0.8 power...
A:
Q: A three-phase, 30-hp, 60-Hz, 2200-V, 600 r/min, salient-pole synchronous motor has direct-axis and q...
A:
Q: Determine the speed in rpm of the mator at ful laad with the folowing circuit elements per phase rat...
A: The rated power of the motor is 500 hp. Number of poles are 6. frequency is 60 Hz Core loss is 2000 ...
Q: series circuit consists of a resistance of 10 ohms and a reactance of 5 ohms. Find the equivalent va...
A: We need to find out conductance and susceptance
Q: 50 Ω 20 2 | SO v40 2 50 ν : 10 Ω E100 V
A:
Q: Question 2 From the circuit, answer the following questions: a) Find the transfer unction H(s) =Vo(s...
A:
Q: test is used to measure the iron losses of the transformer. A6
A: We need to tell about name of test which is used to measure iron losses.
Q: The load on a 250 V supply system is: 12 A at 0.8 power factor lagging; 10 A at 0.5 power factor lag...
A:
Q: 3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test curren...
A: The solution is given below
Q: a R2 R4 R6 Rg R1 R3. R5 R, b
A: When multiple resistance are given in the circuit and we need to find the equivalent resistance then...
Q: transmission model interaction model transtion model ? which one of these takes place in our mind wh...
A: The transition model of communication describes communication as a process in which communicators ge...
Q: Calculate the current and voltages of C1, C2, L1, R1, R2 with use of the node voltage method With a...
A:
Q: If both the series and the parallel configurations draw the same amount of total power at their resp...
A:
Q: Find the power dissipated by 1-ohm resistor. Find the power in 6 V source. Find the current throu...
A:
Q: Calculate the current and voltages of C1, C2, L1, R1, R2 with use of the node voltage method With a...
A:
Q: write verilog code for following 2 to 4 decoder
A: For the given 2x4 Decoder the Verilog code can be written in any modeling type. The one of the model...
Q: Question #3.2 Consider a compensated n-type silicon at 300K having a conductivityo=16 /NCm and Na=10...
A:
Q: An inductive reactance of 10 W is connected in parallel with a capacitive reactance of 30 W. If the ...
A:
Q: Please show a complete solution to the problem A three-phase,50-Hz, 480-V system supplies the follo...
A:
Q: Find the no-laad phase and line valtapge of a star- Comected. 4-pole altemator having flux per pole ...
A: GIVEN: double layer winding flux=0.15 slots per pole per phase (m)=4 ...
Q: Given the potential difference between the terminals of a battery as 6 Volts, calculate the number o...
A: Given the potential difference between the terminals of a battery as 6 Volts, calculate the number o...
Q: Y (s) T(s) R(s) s2+5.8s+210.25 210.25 = 1. What type number is the system? What is ess|step? What is...
A: In this question, Transfer function is given. Find the type of the system, steady state error for ...
Q: The value of transformation ratio (K) for the step up transformer is a) equal to 0 b) less than 1 c)...
A: Answer: greater than 1 Explanation: a) It is not a valid option. If k=0 then the secondary turns ...
Q: Three infinite uniform sheets of charge are located in free space as follows: -7 nC
A:
Q: e.) Find the voltage output V.(t) of this circuit with the given values: Voltage input Vin = sin(2n ...
A: In this question we have to find the value of output voltage
Q: L1 el 9.7µ 7.8m V1 C2 R1 5.4µ 5.1k AC 0.4 0 R2 =>f = 20 kHz 760
A:
Q: I2> や、 Is Res"
A:
Q: A 100-kVA, 3,000-V, 50-Hz, 3-phase star-connected alternator has effective armature resistance of 0....
A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...
Q: What is the MUX1 select input while the "sltu" instruction is executing? 01 00 10 ...
A: Answer - C - 10
Q: two watt meter
A: Given- Alternator voltage rating= 500 VTotal input power = 10kWPower factor= 0.3 lagging
Q: the time period of a periodic signal is about a few seconds . to measure the frequency of this signa...
A: given: periodic signal
Q: 3. Refer to the appendix B. What is the current direction through R5 due to the current sour .03 A b...
A:
Q: 2. Write simultaneous Laplace-transformed loop equations for the electrical net- works of Figure P1....
A:
Q: 800 V R2 R3 2000 N 100 N .500N
A:
Q: 1. One of the complicated parts of solving for the input impedance is the hyperbolic tangent of the ...
A:
Q: 'B = 20 Si + Vin = 6 V R = 30 N
A:
Q: write verilog code for following 2 to 4 decoder yı yo 3. 2 tou91 decoder 0 0 -
A: In this question we have to write the verilog code for 2 to 4 decoder
Q: D5.49 The NMOS transistors in the circuit of Fig. P5.49 have V, = 0.4 V, µ„Cox=400 µA/V², 2 = 0, and...
A:
Q: Find the incremental change in iA for a 2% increase in the value of R.
A: Given: The circuit below contains a nonlinear element N whose v-i relationship is given by: iA=c2vA2...
Q: L T2 dx
A: Resistance: This is the property of the material that resists the flow of the current.
Q: Two alternators A and B operate in parallel and supply a load of 15MW at 0.5 power factor lagging. a...
A: It is given that: Total load=PT=15 MW=15×106 WPower factor=cosϕT=0.5 laggingso, ϕT=cos-10.5=60°
Q: 22 Refer to the following circuit and solve the following: a. Total Capacitance b. Find the total...
A:
Q: C. Use this graphic for questions 7 and 8. R = 4k2. %3D R2 A R1 6k2 9kN R3 RL 3k2 150V B Hi
A: To find Thevenin Voltage , remove the resistance RL and find voltage across VAB .
Q: Find the Fourier Series of the signal, obtaining the Fourier coefficients a,, an, bn and detailing 8...
A: It is given that: A=10T=2π
Q: Find the power in the 10 A source. Find the power dissipated by 20-ohm resistor. Find the po...
A: The given circuit diagram is shown below:
please show solutions
Step by step
Solved in 3 steps with 2 images
- A. Determine V1 without C B. Determine V1 and VR with C C. From aB Determine V2, IL, PD D. From B determine the efficiency of the regulator (OUR SUBJECT IS INDUSTRIAL ELECTRONIC)Which substrate does an p-channel made device possess? O a. None of options O b. Both P & N-type O c. P-type O d. N-type14 10 Ω 2 Q 15 2. 1290 16 C D 11 V 1Ω 1 5Ω 10V 13 Ω Dr. Ben Blalock asks that you solve for the currents as shown. If th opposite direction as shown, specify it as a negative current. EQUATION CHECK
- Q1) What is Megger.? Write five uses of Megger.? Discuss Working Principle of Megger.? i. ii. iii. Q2) What is Grounding.? And Why Ground.? Q3) Difference Between Neutral and Grounding.? Write Five Application of Grounding.?Q2/A- what are the main cases of insulator failures? B-what are type testing of insulator?1) The term Bi is defined as Select one: O a. Negative change in reference bus power to the power change DPi on bus i O b. All of these 1/Pfi Clear my choice
- 12. i) Consider a PV Module with 12 solar PV cells with the Size of each 15cm x 10cm are connected in series. Choose the correct statement for the above. (Assume necessary data) a. The output voltage is 6 V, the output power is 275W b. The output voltage is 6 V, the output power is 0.275W c. The output voltage is 6 V, the output power is 27.5W d. The output voltage is 24 V, the output power is 2.25W 12. ii) For the above given same PV Module, Choose the correct statement. (Assume necessary data) a. The output power is 2.75W and the output current is 0.458A b. The output power is 27.5W and the output current is 4.58A c. The output power is 54W and the output current is 4.5A d. The output power is 275W and the output current is 45Ai) | For the network shown in Figure B22 , assume E = 18V, Diode Di as silicon and D2 Germanium, R1-3KQ and R2-2KQ. Calculate, Current I1, Current Ip2 iii. Voltage across resistor R2 R1 D1 D2 R. +.The drawback to using this equivalent circuit, however, is that it is defined for a set of operating conditions that might not match the actual operating conditions. a.pi b.hybrid-pi c.hybrid d.re
- Rectifier Circuit. 1. What is V1 reading? a. 110V b. 220V c. 0V d. 146.67V 2. What is V2 reading? 146.67V 207.42V 0V 103.7V 3. What is V3 reading? 132V 104V 207.42V 147V Thank u.Consider a PV Module with 24 solar PV cells with the Size of each 15cm x 10cm are connected in series. Choose the correct statement for the above PV Module. (Assume necessary data) a. The output power is 2.25W and the output current is 0.09A b. The output power is 540W and the output current is 45A c. The output power is 54W and the output current is 2.25A d. The output power is 54W and the output current is 4.5AA semiconductor is formed by a. Covalent b. Ionic c. Co-ordinate d. None of the above bonds. A semiconductor has a. Positive b. Zero C. Negative d. None of the Above temperature coefficient of resistance. The most commonly used semiconductor is a. Silicon b. Nitrogen c. Carbon d. Iron