30 cm Turbine Generator 25 cm AP = 1.2 m Hg

Q: well water is pumped into a thank that is 25 meters high through a pipe with an inner diameter of…

A: Given data:

Q: Inside of a room, the atmospheric pressure measures out to be 100 kPa. A pipe with a diameter of 0.5…

A:

Q: An oll pump is drawing 18 kW of electric power while pumping oil with density 860 kg/m³ at a rate of…

A: Here, given data power(We)=18kWdensity(ρ)=860kg/m3flow rate(Q)=0.1…

Q: Consider an underground water source whose free surface is 60 m below ground level. The water is to…

A: For solution refer below images.

Q: The electrical power consumed by the pump, in kW b) What is the daily electricity consumption (in…

A: We need to calculate the  pump power

Q: A pressurized tank of water has a 10-cm diameter orifice at the side bottom corner of the tank,…

A: Let us consider that the free surface of water as point 1 and the exit of the orifice to the…

Q: A river flowing steadily at a rate of 180 m3/s is considered for hydroelectric power generation. It…

A: Data given-  Flow rate Q• = 180 m3/s  H = 60 m

Q: Water is pumped from a lake to a storage tank 15 m above at a rate of 70 L/s while consuming 15.4 kW…

A: The electric power supplied to the pump is The power supplied to the water by the pump can be…

Q: onsider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 570 m/s etermine…

A: In the question we have,water density, ρ=1000 kg/m3velocity, v=3 m/srate of discharge, Q=570…

Q: The pump of a water distribution system is powered by a 15-kW electric motor whose efficiency is 90…

A: Given that → Power inputW.=15 kW                    nmotor=0.9                    V.=50LS=50x10-3…

Q: Water in the rural areas is often extracted from underground water source whose free surface is 65m…

A: To Find :  The power input to the pump in kW . Given :  The height of free surface of water below…

Q: In a hydroelectric power plant, water flows from an elevation difference of 400 ft to a turbine…

A:

Q: when operating. If the pressure differential between the outlet and the inlet of the pump is…

A: Given:  Power developed by the pump, P=6 hp Pressure difference, p=1.2 psi Flow rate, Q=15 ft^3/s

Q: A 78-percent efficient 12-hp pump is pumping water from a lake to a nearby pool at a rate of 1.7…

A: The useful pumping power  is expressed as follows-Pumping head-

Q: Consider water flow in a piping network. The pressure, velocity, and elevation at a specified point…

A: Write the Bernoulli's equation between points 1 and 2. Here, P1 is the pressure at point 1, v1 is…

Q: Water is being pumped from a large lake to a reservoir 25 m above at a rate of 25 L/s by a 17-KW…

A: According to the given data V˙=25L/s=25x10-3m3/s Wshaft=17 kW z2-z1=25m hL=5m We need to find…

Q: Water enters a hydraulic turbine through a 35-cm-diameter pipe at a rate of 0.8 m3/s and exits…

A: Bernoulli's equation relates the pressure energy, kinetic energy and potential energy of a fluid…

Q: Underground water is being pumped into a pool section 10 ft x 14 ft while water is discharged…

A: V2=Mean velocity =16.5 ft/secD2=diameter of orifice= 2 in=16 ftproperties of  pool section=10 ft× 14…

Q: A dam with a hydraulic turbine–generator located 40 m below the water surface has a rate of 4600…

A: Given that: Elevation = 40 m Mass flow rate = 4600 kg/s Electric power output = 1400 kW Generator…

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Consider a river flowing toward a lake at an average speed of 3 m/s at a rate of 500 m3/s at a…

A: Given: The average speed of the river is v=3 m/s. The rate of the flow of the river is V=500 m3/s.…

Q: Water passes through a turbine at a rate of 10 kg/s. If the decrease of specific mechanical flow…

A:

Q: Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L's while consuming 22.4 kW…

A: Given data Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L/s while…

Q: Oxygen enters a nozzle steadily at 2 kg/m3 and 35 m/s and leaves at 0.76 kg/m3 and 180 m/s. If the…

A:

Q: At a certain location, wind is blowing steadily at 9 m/s. Determine the mechanical energy of air per…

A:

Q: The shaft power of a turbine operating with 80 percent efficiency is 450 kW. If the mass flow rate…

A: Given data: η=80%Pact=450 kWm˙=625 kg/sg=9.81 m/s2 Need to determine the amount of head removed from…

Q: A mini hydro power station takes in 3 cubic meters per second of water from a wide open reservoir…

A: The given information in the problem is represented in the following attached image:

Q: n oil pump is drawing 35 kW of electric power while pumpi

A: Given: The power of motor is, Pmotor=35 kW. Density of oil is, ρ=860 kg/m3. The flow rate is, Q=0.1…

Q: Underground water is being pumped into a pool whose cross section is 3m x 3m while water is…

A:

Q: In a pumping system handling water, the surface level of water in the open suction tank is 3m below…

A: The suction level below the pump center is hs=3 m. The delivery level above the pump center is hd=21…

Q: An 80-percent-efficient pump with a power input of 20 hp is pumping water from a lake to a nearby…

A:

Q: diameter tube at a rate of 0.6 m3/s and leaves through a 25 cm diameter tube. cm in diameter With a…

A:

Q: Water is pumped from a lake to a storage tank 18 m above at a rate of 70 L/s while consuming 20.4 kW…

A: Density of water = 1000 kg/m3 Height of tank H = 18 m flow rate V = 70 L/s = 0.07 m3/s Pump Power =…

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A:

Q: Water is pumped from a lake to a storage tank 15 m above at a rate of 70 L/s while consuming 15.4 kW…

A:

Q: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to…

A: In order to proceed with the given problem, the following assumptions need to be taken into…

Q: 6. Water enters a hydraulic turbine through a 25-cm diameter pipe at a rate of 0.6 m³/s and exits…

A: Given:Pipe diameter upstream to the turbine, D1=25 cm=0.25 mWater flow rate, Q=0.6 m3/sPipe diameter…

Q: 1.  Water horsepower of the pump 2.  Brake horsepower of the pump 3.  Power input to drive the…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.