3.0 A cold storage is to be maintained at - 5C while the surroundings are at 35°C. The heat leakage from the surroundings into the cold storage is estimated to be 28 kW. The actual C.O.P. of the refrigeration plant used is one fourth that of an ideal plant working between the same temperatures. Find the power required to drive the plant.

3.0 A cold storage is to be maintained at - 5C while the surroundings are at 35°C. The heat leakage from the surroundings into the cold storage is estimated to be 28 kW. The actual C.O.P. of the refrigeration plant used is one fourth that of an ideal plant working between the same temperatures. Find the power required to drive the plant.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A refrigeration unit utilises ammonia as the refrigerant. The diagram for the circuit isshown in Figure Q3 below, with the following conditions: point (1) is a saturated liquidat –30 oC, points (3), (4) and (7) is a saturated liquid at 10 oC and point (5) is a saturatedvapour at –30 oC. The isentropic efficiency of the compressor and pump is 80% and itis assumed there are negligible heat losses to the surroundings. The liquid ammoniahas a specific volume of 0.0015 m3 kg-1. (a) Discuss which factors must be considered when selecting an appropriate refrigerant?(b) Calculate the coefficient of performance (COP) of the cycle.(c) If the effect of refrigeration is 10 kW, determine the required mass flow rate.
A cold storage plant of 30 tonnes of refrigeration capacity runs with its performance just th of its 25% of Carnot COP. Inside temperature is -10°C and atmospheric temperature is 25ºC. Calculate the power required to run the plant. [Note: 1 ton of refrigeration = 3.52 kW]
A tank of water has a shaft rotating at 60 rpm with a torque of 40 N-m that is stiring the water. A heater is also present that operates at 120V and draws 4A of current. Heat is then removed from the water such the the total energy content of hte water is constant. How much heat is removed?
Find the COP of heat pump operating between 300 K and 600K temperature. If the same temperature ranges are used in heat engine, find the efficiency.
A refrigerator cycle uses refrigerant R-134a and operates between a low-side pressure of 1.5 Bar and high side of 10 Bar. The power input to the compressor 1.88 Kw. find the refrigerant mass flow rate, condensing heat load, and COP of this machine
I need the answer quickly
A refrigeration system has a heat rejected of 430 kw.If COP is 7,find the mass chilled water in the evaporator for a temperature decrease of 16°℃.
A belt-driven compressor is used in refrigeration system that will cool 10 liters per second of water from 130C to 10C. The belt efficiency is 98%, motor efficiency is 85% and the input of the compressor is 0.7kW per ton of refrigeration. Find the actual COP if the overall efficiency is 65%.
An indoor heater operating on the Carnot cycle is warming the house up at a rate of 30 kJ/s to maintain the indoor temperature at 72 ºF. What is the power operating the heater if the outdoor temperature is 30 ºF
can you please solve this for me (the fraction of steam extracted from theturbine for the open feedwater heater)