3. The temperature of an iron bar is 36°F. It is placed in an oven, after 1 and 2 minutes, respectively, it reads 60°F and 82°F . What is the temperature in the oven?

Q: Using Euler's equation, calculate critical buckling load in (kN) of a maple wood column (rectangular...

A:

Q: f the center of gravity of a ship in the upright position is 10 m above the center of gravity of the...

A: There is a ship whose center of gravity is given. the displacement of the ship is also provided. the...

Q: Draw the normal or axial, shear and moment diagram

A:

Q: A simple curve has an external distance of 10.54 m and a middle ordinate of 11.28 m. The tangents in...

A:

Q: An open horizontal tank 2 m high, 2 m wide and 4 m long is full of water. How muchwater is spilled o...

A:

Q: The magnitude and direction of the reactions at support B. EM„A =0 -R, × L+| q(x)·xdx = 0 %3D R, =-q...

A:

Q: Q./A beam having a tee-shaped cross section is subjected to equal 12 kN.m bending moments, as shown ...

A:

Q: Watershed River Banks O Wetlands O Straw deep

A: It is a topographically delineated area of land where rainwater is collected through a river system ...

Q: A 400 mm square column carries a dead load (Gk) of 1050 kN and imposed load (Qk) of 300 kN. The safe...

A: Given Data: Size of square column = 400x400mm GK= 1050kN QK=300kN safe bearing capacity = 170 kN-m2 ...

Q: A car starts from rest and accelerates uniformly over a time of 5.21 seconds for a distance of 110 m...

A:

Q: Draw the shear and moment diagram for the given loadings below (USING METHOD OF ARE (Note: The conce...

A:

Q: The cantilever beam AB shown in the figure is subjected to a triangular load acting over one-half of...

A:

Q: d= 50mm T= 1 KN-W -5KN 500mm asomm 6KN A Find all stresses: axial, torsion, and shear Makes stress s...

A:

Q: The lines on a map through places having equal depth of evapotranspiration is called A hydrograph B)...

A:

Q: Q2: The plan of a group piles is shown below. Assume that the piles are embedded in a saturated homo...

A: We have to determine the allowable carrying capacity of the pile group as per the given data like di...

Q: 3. Draw the internal force diagrams (and include all significant values) for the following system. 3...

A:

Q: 2-032 Ф12 2-020 400 mm -175mm- B SECTION 1525 mm ACANTILEVER BEAM ELEVATION B

A: Given Fc 28 MPa Fy  415 mpa Fyt  275 mpa Width 175 mm Depth 400- 60 = 340 mm Effective cover 60mm   ...

Q: gth L = 4 m and rectangular cross section with a width of 90 9(x) B

A:

Q: Draw the B.M.D for the following, (El) is constsnt 5kN 10kN/m D 21 B A 2m 6m 21

A: Given:- The magnitude of the uniform load = 10 kN/m  The magnitude of point load at D = 5 kN  To det...

Q: m Problem 6: The top wall moves with velocity Vtop = 1" and the bottom wall is S stationary. Inside ...

A: Two walls are there in the question as per the question top walls move with a certain velocity while...

Q: The moisture content of a soil at which the moisture is no longer available in sufficient quantity t...

A: The moisture content of a soll at which the moisture is no longer available in sufficient quantity t...

Q: he wind velocity at a height of 2 m a n above ground can be expected to

A: Wind velocity at a height of 2m above ground = 5 km per hour. To find the wind velocity at a height ...

Q: A T-intersection has a total of 2,400 collision incidents over the last 5 years. Given that the annu...

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the exac...

Q: 3.16 A motorist entering the exit ramp of a highway at 40 km/h immediately pplies the brake so that ...

A:

Q: A circular column of length 2 m has Euler's crippling load of 1.5 kN. If the diameter of column is r...

A: The given data is: Length of circular column=2 m Crippling load=1.5 kN Reduction in column diameter=...

Q: A watershed 600 ha in area experienced a rainfall of unifom intensity 2.0 cm/h for duration of 8 hou...

A:

Q: The distance between center of gravity and center of pressure on a submerged gate is decreasing as s...

A: step 1-

Q: Question 4 The following are the ways to reduce evaporation loss except for A reduction of depth of ...

A: Answer:- 1. Reduction of depth of the water body Explanation - Method to reduce the evaporation fro...

Q: A carpentry crew consists of one foreperson, four carpenters, and four laborers. The bare hourly wag...

A: ASKED: To compute the weighted average burdened wage rate for the crew.   Given, Class Bare hourl...

Q: Which is not a sources for Highway Funds? Gasoline Tax * Adopt A Highway Program Tolls Traffic Fines...

A: Solution- General Income Tax is not Highway Funds.  

Q: Vena contracta forms due to viscous fluid flow; forms at a short distance d/s of the orifice to have...

A: Orifice meter is a circular plate with concentric hole at centre. It is an obstruction type discharg...

Q: a) Determine the location of the centroid with respect to the point P; y = mm Submit part Unanswered...

A:

Q: 4. Determine the natural frequency of a pendulum whose length is 5 m. 5.

A:

Q: DISCHARGE BY VELOCITY-AREA METHOD. At a certain section of the river the left and right water edges ...

A:

Q: A 400 gm/lit. solution of common salt was discharged into a stream at a constant rate of 45 lit./sec...

A:

Q: Of what use are pump characteristics curves? Illustrate your answer.

A:

Q: A 335-lb block is resting on a rough horizontal surface for which the coefficient of friction is 0.3...

A: A pulling mechanism is given and it has been asked to determine load P required. Please refer step 2...

Q: The bracket shown is welded by an E70 electrodes fillet weld and is subjected to a factored load Pu=...

A:

Q: DETERMINE THE FORCE (Ib) IN MEMBER BD OF THE ROOF TRUSS SHOWN GIVEN THE DATA BELOW: F1 = 81 lb F2 = ...

A:

Q: The weight of the dry soil per unit volume is known as Bulk Unit Weight Saturated Unit Weight O Dry ...

A: 7. The weight of the dry soil per unit volume is known as Dry Unit Weight Bulk Unit Weight Saturate...

Q: A cylinder vessel filled with water with a 2m diameter and 5m high. It was rotated with uniform angu...

A:

Q: DETERMINE THE UNCONFINED COMPRESSIVE STRENGTH OF SOIL IN BOTH CONDITIONS. S.N. Discription In-situ s...

A:

Q: Determine the total metacentric height MBo when its rolled on one side in meters B) determine the an...

A:

Q: 3.6-5 Choose a pipe to be used as a tension member to resist a service dead load of 10 kips and a se...

A:

Q: 3. An 8-in.-wide by 12-in.-deep redwood timber beam (S4S) is used as a 20-ft-long simply supported b...

A:

Q: Please put down the Reasoning Behind This Vision (like the world is continuously evolving so enginee...

A: Engineering is a vast field in which it is consisting of various interdisciplinary departments like ...

Q: For surveying, is the mean sea level is always the reference level for elevation? a. True b. False

A: Given that is mean sea level always used as reference level for elevation of points in surveying.

Q: Q3/ Define (.. Consistency of concrete, Segregation of concrete, bleeding of concrete, Bond strength...

A: a) Consistency of concrete:- The manner a material remains together is described by its consistency;...

Q: An open tank 3 m wide by 3m long weighs 3.6 kN and contains water to a depth of 1 m. It is acted by ...

A: To find out the,  a) The acceleration of the tank.b) The height of the tank so that no water will sp...

Q: If the wind velocity at a height of 2 m above ground is 5.0 kmph, its value at a heigh 9 m above gro...

A: Wind velocity at a height of 2m is 5kmph   

Temperature as a Fundamental Dimension

There are certain rules to write dimensions of a physical quantity using the fundamental dimensions. They are outlined below.