3. A truck drives off a cliff with horizontal velocity of 8 m/s. The cliff is 138 m high. How much time has elapsed when it hits the ground? What is its horizontal displacement? What is its final velocity just before impact?

3. A truck drives off a cliff with horizontal velocity of 8 m/s. The cliff is 138 m high. How much time has elapsed when it hits the ground? What is its horizontal displacement? What is its final velocity just before impact?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A piston-cylinder device contains 1.5 kg of steam at 300°C and 0.4 MPa. Steam is cooled at constant…

A: The initial conditions are: The specific volume of the steam can be determined from the steam table…

Q: 355 coupe for some maintenance check. Before proceeding to your regular maintenance routine, it is…

A: Odd matric number:

Q: Answer by true or false for the following Specific heat is a measurement of the ability of the…

A: The specific heat of a substance is defined as the amount of heat to increase the temperature of the…

Q: D Question 2 Express the force TBC as a vector (in terms of i, j, k). Show all calculations on your…

A: Express the force TBC as a vector (in terms of i, j, k). Show all calculations on your paper and…

Q: Suppose that A24 . Eaun) • Part C Determine the coordinate direction angie of the resutant force of…

Q: Choose one of the following statements which is not true.

A: for solution refer below images.

Q: Forces and moments are scalar Forces are moments are vector quantities.

A: Forces and moments are both physical quantities that can be used to describe the behavior of objects…

Q: 1500 liters/s of ammonia gas at 100°F and pressure of 30 in.Hg has a specific heat ratio of 1.304.…

A: Given data Q=1.5 m3/sT1=100°FT2=180°Fγ=1.304 Here, Q is the flow rate and T1 is the initial…

Q: Using Combination set, The angle shown by the arc can be measured. hand written plzzz Select one:…

Q: I o2s+lo4 s+1. .96 2. L'st ++T?

Q: A 2.10kg pole is attached to a wall with a hinge as shown. A 5.80kg sign is suspended at the other…

A: Given data: mp=2.10 kgM=5.8 kgD1=1.3 mD2=3.2 mα=19.0° Need to determine the torque on the pole due…

Q: A hammer is balanced at the point "A", close to the metal part. If this hammer is then cut along the…

A: Consider the diagram shown below for the hammer with the center of masses for each side.

Q: RIS R12 frant sew R32

A: Given 3D model To find Three views

Q: The radial stress in thin cylinders 2 points can be neglected because: the thickness of thin…

A: Radial stress is stress due to fluid pressure in the cylinder acting radially outwards, it is…

Q: Part B - Analyzing the force-couple system on a bracket For the bracket shown below, Fi = 165 lb, F…

A: As per the guidelines of BARTLEBY we are subjected to solve only one question at a time. please…

Q: A 70 kg skier that moves from rest at A is shown in Figure Q2. Suppose friction can be neglected…

A: Given:m=70 kgθ=30°θ=40°Height AB=12mTo find:-1) Velocity VB2) The istance S

Q: R M P

A: given; lets take tension force in member NJ=T1lets take tension force in member NM=T2lets take angle…

Q: I needed it to be solved using differential equation

Q: FA -X B FB Alpha = 34 degrees

Q: Calculate y, the distance from the base to the position of the Neutral Axis of the T-section shown…

Q: Answer in 4-10

A: Given: →h1=3387.31 KJ/Kg→h2'=3074.5 KJ/Kg→h3=3457.04 KJ/Kg→h4'=3109.82 KJ/Kg→h5'=2384.82…

Q: A hollow steel has an outside diameter of 5in. and it's inside diameter is 4in. What is the…

A: Outside diameter, do=5 inInside diameter, di=4 in

Q: What is the radius equivalent to Mohrs Circle?

A: Method to construct Mohr's circle, First Plot point A σx,-τxy, & B σy,τxy on σ - τ plane. Now…

Q: Find the value of x5 in 1 decimal places (positive value) using Newton-Raphson Method f(x) = 2x2 + x…

Q: Fy = 16 kN O Fy = 4 kN O Fy = 2 kN O

Q: Give a steps by steps answer of the solution

Q: Isn't the area of the circle equal to pi times the square of its radius?

A: Explanation: Since the diameter ( d ) of steel bar is given, area of the circle is in terms of…

Q: At a certain instant, the particle of mass m has the position and velocity shown in the figure, and…

Q: Where did you get the 3 from for the distance of q?

Q: Find y shown in Figure below. 3 cm 0.5 cm - 0.5 cm A 1 cm B 0.5 cm D 6 cm E 0.75 cm F 0.75 cm 0.75…

A: Solution:

Q: Question 3) On the plate in the figure, the length L is given as L = 18 m . According to this; y 2L…

A: Given data: Image with relevant details To determine: X and Y coordinate of the geometric center

Q: 8ェ4 2 w/

A: the value of (4x-4)/2= (4*(-1)-4)/2= -12/2 =-6

Question

Help question 3

1. In a projectile motion problem, what is the maximum number of unknowns that can be solved?
a. 1
b. 2
c. 3
d. 4
2. The time of flight of a projectile, fired over level ground, with initial velocity v. at angle 9, is
a.
(v. sin 01/g
b.
(2v, sin 9)/g
c.
(v. cos 0)/g
d. (2vo cos 9)/g
3. A truck drives off a cliff with horizontal velocity of 8 m/s. The cliff is 138 m high. How much time
has elapsed when it hits the ground? What is its horizontal displacement? What is its final
velocity just before impact?
4. The skier leaves the ramp at A at 8, = 25°. She strikes the ground at B. What is the initial speed
and the speed she strikes the ground at B?
m
100 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data.

VIEW

Step 2: Calculations for time, horizontal displacement and velocity just before impact.

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Question 3) The length L is given as L=34 m on the plate in the figure. According to this;Question 3-A) Find the X coordinate of the geometric center of the plate. (Enter your result without writing m units. Write at least three digits after the comma.)Question 3-B) Find the Y coordinate of the geometric center of the plate. (Enter your result without writing m units. Write at least three digits after the comma.)
2 ft 3 ft Z 4 ft B
Pls help with questions no.24
Q1/3-The B Rep. Scheme for the box consists of: * O 8 faces, 8 edges & 12 vertices O 6 faces, 8 edges & 12 vertices 8 faces, 12 edges & 12 vertices O 6 faces, 12 edges & 8 vertices
Q2. A 70 kg skier that moves from rest at A is shown in Figure Q2. Suppose friction can be neglected while the direction of the launching velocity at B and the orientation of the underneath ground are 30° and 40° from a horizontal axis x, respectively, determine: (a) the launching velocity of the skier at B using the formulation of conservation of energy. (b) the distance, s where the skier lands at C by considering motion in x and y axes.
Please do the last three questions (2, 3 and 4)! Thank you in advance! A seesaw that weights 45lbs and its 5m long is balanced on the fulcrum in the center. 1- Two children are sitting on opposite sides of each other on the seesaw. One child weights 50lbs and is sitting 0.7m on the left end. Where should the other child sit in order to be balanced on the seesaw if they weigh 42lbs? 2- Now, a third child wants to sit on the seesaw and weighs 30lbs and is sitting 1.25m in front of them and is closer to the fulcrum on the right side. What are the CW and CCW moment of the seesaw now? What is the net moment and direction? 3- Then, a fourth child wants to play on the seesaw and is on the left side of the plank in order to bring the system to equilibrium. How much does the child weigh (Calculate the pounds of force needed in order for rebalance?) 4- Now the fourth child leaves the other three children sitting on the plank. If the three children are sitting in the same potions as they did…
Question 1