Question #3, but it has to do with question #1 but with a reservoir elevation of 71.98 3)reservoir elevation 71.98m. How much of a reduction in flow was there when theelevation in the reservoir is reduced by over 60%? 1) A 150-mm-diameter, square-edged orifice conveys flow from a reservoir with water level at elevation 79.25m. Thecenter of the orifice is at elevation 66.10m. Find the discharge for free flow. Note: The orifice flow equation is set upalready for feet or meters.- Calculate the height of the water above the orifice.- Calculate the area of the orifice.- Assume the coefficient of discharge based on what was learned in class.- Use the appropriate equation to solve for the flow through the orifice.- Compare your answer: 0.176 m^3/s

Answer (3) We know that discharge equation for an orifice is given by Q = Cd*A*2gh where Cd is…

Answered: 3) reservoir elevation 71.98m. How much…

3) reservoir elevation 71.98m. How much of a reduction in flow was there when the elevation in the reservoir is reduced by over 60%?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 3. A spillway, 12.90 m long, releases flood runoff from a reservoir of 5 hectares in area. If the…

A: Given Data Spillway length (L) = 12.9m Area (A) = 5 ha = 5 × 104 m2 Elevation drop from 55m to…

Q: The Gimlet Creek watershed has a drainage area of 5.42 mi²; the length of the main channel is 4.45…

A: Consider the given data A=5.42 mi2L=4.45 milesLCA=2.0 milesCt=2.0Cp=0.625D'=30 min Calculate the…

Q: A horizontal, frictionless channel of circular cross-section and diameter equal to 5 feet flows at a…

A: Diameter = 5 ftDepth = 3ftVelocity = 2 ft/sFind:Maximum upward step height (max ) that this flow…

Q: fter You have calculated the outflow from the reservoir on the first part Now, your goal is to route…

A: Time (hrs)Inflow…

Q: A flood occurs in a main channel having a trapezoidal section (side slope on both sides: 2H to 1V)…

Q: Calculate discharge through a straight triangular notch having height of 0.36 m. Take Cd=0.67.

Q: Estimate the lag time (hr) for the following watershed: Hydraulic length (km) - 3.04 Curve number 60…

A: Given data:Hydraulic length(L)=3.04 km=9973.753 ft.Curve number(CN)=60 Average land slope(S)=1.1%

Q: 7.21. Determine the storage capacity of a reservoir between the RL of 200.00 and 245.0 from the…

A: We have to determine the value of storage capacity of a reservoir between the RL of 200 to 245 from…

Q: The drainage area of a watershed is 50 km2. The index is 0.5 cm/hour and the base flow at the outlet…

A: Given data Watershed area (A) = 50 km2 Φ-index = 0.5 cm/hr Base flow = 10 m3/s 1hr UH have time…

Q: Two reservoirs are connected by 198ft of 2-in diameter tubing. What is the flow rate when the…

A: Answer We know that Flow rate in tube is given by Q = A*V A = cross section area of tube V =…

Q: Q: The table below represents the elevation-area curve for a reservoir, the maximum storage is 32…

A: Note: As per our policy for a multipart question only three parts can be solved for other parts…

Q: of spillway crest, rater over the spillway, e storage volume,

A: we will use horizontal formula h = interval of elevation

Q: in a border irrigation run, Q= 8 /s, n= 0.15, and S=0.45%. The water depth at the inlet can be…

A: given data: discharge at depth=Q=8 lsn=roughness coefficient=0.15slope of border strip=0.15

Q: Calculate the critical depth corresponding to a discharge of 8.5m³/sec in a rectangular channel of…

A: Given: Discharge, Q = 8.5 m3/sec Rectangular channel width, B = 3.6 m

Q: Assuming that 30% of the rainfall runs off, the volume of runoff (acre-feet) from a storm with a…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Draw the downstream water profile for the following step-up and step-down conditions.

A: Given Water flow diagrams and it is asked to draw downstream water profile of Sub-critical and…

Q: Determine the useful storage depth that used in hydroelectric power plant according to the…

A: The water levels in a reservoir are divided into: Maximum flood level(MFL): It is the highest water…

Q: Water flows from a lake into a steep rectangular channel 3 m wide. Determine the lake level above…

Q: (a) Setup the continuity equation at the junction. (b) What is the total head loss, in meters (give…

Q: A small stream has a trapezoidal cross-section with a base width of 12 m and side slope 2…

A: Upstreamwater surface elevation h1 = 102.70Area = B +(B+2y)2yy = 102.70-100.20 = 2.5Area A1 =…

Q: Develop the following triangular inflow hydrograph through a linear reservoir: Peak inflow R = 4737…

A: To find outflow

Q: in a border irrigation run, Q= 10 1/s, n= 0.2, and S=0.41%. The water depth at the inlet can be…

A: The water depth at inlet can be calculated using the following formula: Y0=(Q×n60×S0.5)0.6 Where, Q…

Q: Design an irrigation channel by Kennedy’s theory to carry 5 cumecs of discharge with critical…

Q: 30 mi² reservoir is fed by two streams that carry an average discharge of 350,000 cfs and 20,000…

A: According to given data A 30 mi² reservoir is fed by two streams that carry an average discharge of…

Q: 9.4. A small farm reservoir behaves as two identical CFSTRs in series. Flow into the reservoir…

A: Given,Influent BOD, C0=50 g/m3Flow rate, Q=0.5 m3/sVolume of reserviour, V=2.16×106 m3k=0.2…

Q: If I have Q peak 403.89 m3/s and the catchment area is 152.022 km2 and the lognest length of stream…

Q: 2. Lewis-Kostiakov equation 3. Horton equation

Q: Hydraulic mean depth of a rectangular channel having Width as 2 m and flow depth 50 cm 0.333 0.222

A: H=Wetted AreaWetted PerimeterWetted Area=2m×0.5m=1m2Wetted Perimeter=0.5×2+2=3m

Q: You are tasked to work on a groundwater project in Nadi. The Nadi aquifer is a confinedhorizontal…

Q: 3.2. For a CI gravity main (Fig. 3.2), calculate flow in a pipe of length 300 m and size 0.2 m. The…

A: Given:- The length of the pipe (L) = 300 m The diameter of the CI pipe (D) = 0.2 m The elevation…

Q: A hydrogen generation facility is proposed 5km west of an existing steel mill in downtown Hamilton.…

A: Apply concept of specific energy. Specific energy before hump and after hump will be equal

Q: A steep wide rectangular channel takes off from a reservoir having an elevation of 101.2 m. At the…

Q: Provided below is the cross-sectional area, verticals, depths, and velocities of a lake. Assuming…

Q: A 3-hr unit hydrograph U₁ of a catchment of area 245 km² is in the form of a triangular with peak…

A: 3-hr unit hydrograph U1 - Catchment area of U1 = 245 km2, Peak discharge=35 m3/s And 3-hr unit…

Q: O -index is 0.5 cm/h and the base flow at the outlet is The drainage area of a watershed is 50 km2 D…

Q: An S-curve hydrograph has been obtained for catchments of 270 km2 from a 3 hour unit hydrograph. The…

Q: it is a water level that is measured at any point during pumping. It is also refered to as a…

A: it is a water level that is measured at any point during pumping. It is also refered to as a…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Question #3, but it has to do with question #1 but with a reservoir elevation of 71.98

3)
reservoir elevation 71.98m. How much of a reduction in flow was there when the
elevation in the reservoir is reduced by over 60%?

1) A 150-mm-diameter, square-edged orifice conveys flow from a reservoir with water level at elevation 79.25m. The
center of the orifice is at elevation 66.10m. Find the discharge for free flow. Note: The orifice flow equation is set up
already for feet or meters.
- Calculate the height of the water above the orifice.
- Calculate the area of the orifice.
- Assume the coefficient of discharge based on what was learned in class.
- Use the appropriate equation to solve for the flow through the orifice.
- Compare your answer: 0.176 m^3/s

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Give me both 100% right solutions. If you don't know the solution please leave it
A trapezoidal channel carrying water with area section = 40 m^2, wetted parameter =30 m, bed slope is 3 m for each 10000 m and C= 145, the discharge in the channel is = ---?
Elev. 38 m Reservoir Elev. 30 m (Not to scale) FIGURE P2.8 Levee Sand seam 200 m Ditch Elev. 28 m
A wide river with a water surface elevation 1/8000 of depth of flow D. If the depth of flow in the river is decreased by one third and the surface slope is decreased by 40%. If he ratio of the discharge is 2.58. Determine the percentage change in discharge. A 70.25% B-61.24% C 61.24% D -70.25%
Please choose the correct one
The three-reservoir system is being utilized to supply water for the metropolitan city. The elevations of Reservoir A, Reservoir B, and Reservoir C are 200 mamsl, 150 mamsl, and 40 mamsl, respectively. Pipe A which connects Reservoir A to a junction has a length of 5000 m, diameter of 1200 mm, and C-value of 100. Pipe B which connects Reservoir B to a junction has a length of 1000 m, diameter of 600 mm, and C-value of 90. Pipe C which connects Reservoir C to a junction has a length of 8000 m, diameter of 2000 mm, and C-value of 80. Determine the (a) head loss in meter along Pipe A, Pipe B, and Pipe C, and (b) flow rate in m3/s along Pipe A, Pipe B, and Pipe C.
I need the answer as soon as possible
A flow of 10 cfs enters a 1-mi? vertical walled reservoir. Find the time required to raise the reservoir level by 6 in.
In the vertical wall of a reservoir (A) there is a drowned hole that it flows into another reservoir (B) with a real discharge speed of 4,5m/s. This one reservoir (B), in turn, has a square orifice with free discharge of the form shown in the figure. It requires a flow of 0,089 m³/s and there is no overflow of the system. Determine determine the area and edges of orifice 2. (See the image) Data: Orifice diameter 1 = 0.2m; Discharge coefficient for orifice 2 = 0.604; contraction coefficient for orifice 2 = 0.64. Consider both holessmall in relation to the depth of the reservoirs.
initial capacity of 25,000 acre-ft if the average annual inflow is 40,000 acre-ft ,The useful life of the reservoir will terminate when 75 percent of its initial capacity is filled with sediment. Capacity inflow ratio for orange layer is Select one: O A. 0.468 O B. 0.625 O C. 0.38 O D. 0.58
None
A clean-earth river is 50 ft wide and averages 600 ft3/s. Itcontains a dam that increases the water depth to 8 ft, toprovide head for a hydropower plant. The bed slope is0.0025. (a) What is the normal depth of this river?(b) Engineers propose putting flashboards on the dam toraise the water level to 10 ft. Residents a half-mileupstream are worried about flooding above their presentwater depth of about 2.2 ft. Using Eq. (10.52) in one bighalf-mile step, estimate the new water depth upstream.