Answered: 3 An alternating voltage is given by v=…

3 An alternating voltage is given by v= 75 (sin_200nt - 0.25) volts. Find: (a) The amplitude (b) The peak-to-peak value (c) The rms value (d) The periodic time

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: Determine the voltage (Vo) 4 ΚΩ www a 10 ΚΩ

A: Circuit diagram is given as,

Q: For the circuit shown in the figure below: Voo EM₂ Vin V₂M₁ M₂₁ Vout Transistor M3 is operating as…

A: Transistor M3 is an diode connected transistor. It will always operate in saturation region.

Q: The following circuit has a switch that is closed at t = 0. The initial energy in the inductor is…

A: The given circuit is shown below.The switch is getting closed at . The initial energy stored in the…

Q: What is the total resistance and current in the circuit?

A: It is given that

Q: Find K and a by examining the frequency response curves

A: Given:Frequency response of a system with To find:The values of K and a by examining the frequency…

Q: Find the current across the resistor 8 22 while the switch S is open for a long time. A) (A) B) (A)…

Q: (a)plot 2x[n]+2. 12 (B)- find an even and odd parts of the signal in xa(n) . (C) determine the…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 2. soru) (v 1025 30V SA 16-2 a WIL LIX Find the current Ix in the following circuit by using…

A: Circuit diagram

Q: Support the solutions with corresponding figures/diagrams. Let Q₁ = 8 uC be located at P1(2, 5, 8)…

A: It is given that:The force expression for two charges place at different points in co-ordinate…

Q: 19 v зл зыл 1 10V зл

Q: An npn transistor is accidentally connected with col- lector and emitter leads interchanged. The…

A: given here emitter and base currents of normal transistor and asked to find the

Q: Res Ĵ 19 HA Hy 2 i Hat Gul گانا

Q: Closed loop speed control of a direct current motor is shown in the block diagram below. Design a…

A: The forward path transfer function of a unity negative feedback sysetm isWe need to design a PI…

Q: A memory IC has all its input and output pins shown in the figure.

A: Given memory IC have 10 address lines = A₀ to A₉Given memory IC have 64 data lines = D₀ to D₆₃Find…

Q: Nominal gerilimi VT- 100 V olan uzun sönt kompunt motorun endüvi devresi toplam direnci Ra-3 92,…

Q: Find the transfer function C(s)/R(s) for the system given below.

A: Find the transfer function C(s)/R(s) for the system given below.

Q: Consider the following circuit R Us +v₁ (t)- vilt) + 3L Vo(t) For this circuit, the input voltage is…

A: Given Circuit:Angular frequency = 450 rad/sInductance L = 50 mH = 0.05 HSource voltage To…

Q: Vin 5k 30n 5k M -15V LM324 +15V Vo Vin 100k ww 1,5n HE 100k -15V LM324 +15V Vo

Q: In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6 kΩ, RE = 1.5 kΩ and RL =…

A: given circuit is resistances are capacitances…

Q: A three-phase circuit is balanced. The source voltage for the a-phase has a magnitude of 100 volts,…

Q: Calculate the diversity factor for the following group of consumer 10 commercial customers, each…

A: Number of costumers n = 10.Individual maximum demand of each costumer = 10 MW.Sum of total…

Q: Ri= 42 حمد 123=101 VL R2 =21 um ++ t EV P4= In &V Rs = Sn

A: it is asked to find the currents through each load resistors

Q: Q1. The diode in the circuit shown is ideal. 2V 10 sin(t) + B Vo + 4.22 What is the shape of the…

A: Diode will conduct when anode voltage is greater than cathode voltage and stops conducting when…

Q: Question 4. The transfer function of an uncausal LTI system is given as H(2)= (z-3)(z-1)

Q: Find F-¹{II4/3(Fg * III2/3)} for g(t) = = COS s(2πt).

A: Here, we have to determine the Inverse Fourier transform of the given function.The given function…

Q: Solve this using superposition theorem

A: to find the response through the resistance 6 ohms using super position theorem

Q: Impulse response of a discrete time system h[n] and an input x[n] has been given for a linear shift…

Q: Consider the LTI system described by the following differential equations, ²+15-5y = 2x, dt which of…

Q: Q2. An infinitely long solid conductor of radius a is placed along the z-axis. The conductor carries…

A: We can apply Ampere's law. Since the conductor is infinitely long and carries a current I in the +z…

Q: Q2.Apply star delta transformation wherever necessary to determine the following a. The Total…

A: For this circuit we need to calculate the a) total resistance across ab terminalb) total current I…

Q: The provided one-line diagram illustrates an industrial distribution system consisting of a small…

Q: Determine Gain margin and phase margin =?

A: Given:To find:Gain Margin and Phase margin. Note:We'll calculate gain margin and phase margin using…

Q: 12 V 6Ω Μ 1-0 4 30 Ω 1F

A: The given problem is from circuits. The problem can be solved by using Laplace transform. The…

Q: For T = 0.5 sec, write the element of the discrete sequence corresponding to the function f(t) = t2…

A: Sampling: It is the process of converting an analog signal into a discrete-time signal.For sampling,…

Q: Given a continuous-time system: 5500 x(t)[8(t – t) − 8(t+t)]dt − y(t) = 0.5 Explain what this system…

A: Given:Explain about the system:Is the system BIBO stableIs the system LinearIs the system…

Q: Consider the circuit shown below. Leq 1140 L L 1. Assume that I = 35mH. Using the concept of…

A: It is the passive electronic component, which stores energy in the form of magnetic energy. The…

Q: Determine the frequency of the modulating signal which is producing an FM signal having a bandwidth…

A: here we have to find the frequency of the modulating signal

Q: 04 Draw the alternate representation of the following circuit. 20 Ω υχ 10 Ω I 20 Ω όλη κατά 10 Ω 41,

A: A circuit consisting of dependent current source.

Q: Find Thevenin equivalent circuit for the terminals across 2Ω resistor. ΤΩ Φ Find Norton equivalent…

Q: d) 3-A 500 ohm resistor is connected in series with a coil with a self-inductance of 800 mH and the…

Q: y Design a buck converter to convert 114 V dc supply voltage to -45 V output voltage across a 21 ohm…

A: DC supply, Output voltage,Load Resistor,

Q: What is the internal voltage gain of a single CE stage when ß = 220, r = 3612, Rc = 1 km, Rx = 502,…

Q: Q3//In the power system shown in Figure 2 below, bus 1 is a slack bus. 1-Determine the dimension of…

A: 1) Dimension of Jacobian Matrix:The Jacobian matrix represents the partial derivatives of a set of…

Q: Apply the Mason's gain formula to the signal- flow graphs shown in figure below to find the transfer…

A: With the help of Mason's gain transfer function formula singnal flow graph can be obtained. To…

Q: ZENT ja 752 j3 j It -ja 52 1052 j5

A: Given Circuit:To determine:The Input impedance

Q: 120 Tunee #2 Encontrar la potencia t 1K LK 2K 3K 3K- 1K 4K en la carga Re Si 5K R₁ TIT

Q: Answer all parts of the question. 1. For the given RLC circuit, answer the following questions.…

A: In this questionWe need to determine the transfer function, pole zero diagram, type of the output…

Q: Given the following 4 state diagrams. Choose which of the state diagrams describe the operation of…

Q: Draw the circuit associated with the Boolean Expression given below. You may use landscape mode on…

A: The given Boolean function is,Here, P, Q, R and T are the inputs of the circuit.

Q: V₁ R₁ V₂ R₂ R3 V3 R4 V₁=10V, V₂ =9V, V3 −IV, R₁=59, R2 =10 Q₂ R3=50, R4=5 Q Calculate the power…

Concept explainers

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.

Question

3 An alternating voltage is given by v= 75 (sin_200nt - 0.25) volts. Find:
(a) The amplitude
(b) The peak-to-peak value
(c) The rms value
(d) The periodic time

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation :

VIEW

Step 3: Calculation :

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is reduced to the half value? 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms. 1.7677 Vrms O 5 Vrms . 5 Vrms ...... O 10 Vrms . 10 Vrms ......
49. The sinusoidal waveform is the fundamental type of waveform used in AC and is commercially distributed. True False 51. Peak factor of a signal is the ratio of the peak or maximum value to the RMS (root-median-square) value. True False 52. Periodic signals are signals that recur at a irregular time interval True False
An alternating voltage is given by: v=75 sin(200TTt-0.25) volts. Find the following: I. (a). The amplitude (b). The peak-to-peak value (c). The rms value (d). The periodic time (e). The frequency (f). The phase angle (in degrees and minutes) relative to 75 sin 200tt
Q2. For the Periodic Waveforms shown in the Figure, determine for each : Frequency, Average Value over half a cycle, RMS Value, Form Factor, and Peak Factor. 100 75 Voltage (V 50 25 20 40 Time (ms) 10 30 -100
A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth harmonic, both of the harmonics being initially in phase with each other. (a) Determine the rms value of the fundamental and each harmonic. (b)Write down an expression to represent the complex voltage waveform if the frequency of the fundamental is 31.83 Hz.
Given the RMS value of the following voltage waveform is sqrt(8/3) , determine the maximum value, B, of the waveform.
A certain waveform has a form factor of 2.3 and a peak factor of 3.5. If the maximum value is 100 find the rms value and average value...
17 In a symmetrical sinusoidal waveform, the negative peak is more than than positive peak. Select one: True False
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......
The summation of continuous- time sinusoids is Select one: a. Periodic under certain conditions O b. Always periodic O c. Never periodic O d. Periodic only if all the sinusoids are identical in frequency and phase
A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 30 µs/cm and the volt/cm switch is on 20 V/cm. The width of one complete cycle is 3.8 cm and the peak to peak distance is 4.8 cm. Determine the following: The frequency is? The magnitude of the sine voltage is? The amplitude is? The R.M.S voltage is?
3 Find average value, RMS value and form factor of waveform shown in figure. [BV 2017] i(t) 5A 2.5 time -5A