3) A small block with mass m is placed inside an inverted cone that is rotating about a vertical axis such that the time for one revolution is T. The walls of the cone make an angle e with the vertical. The coefficient of static friction between the block and the cone is µ.. If the block is to remain at a constant heigh h above the apex of the cone, what are the maximum and minimum values of T? 4xr sin 0+u̟,cos e cos 0-u, sine (1 miei Tmax not given)

3) A small block with mass m is placed inside an inverted cone that is rotating about a vertical axis such that the time for one revolution is T. The walls of the cone make an angle e with the vertical. The coefficient of static friction between the block and the cone is µ.. If the block is to remain at a constant heigh h above the apex of the cone, what are the maximum and minimum values of T? 4xr sin 0+u̟,cos e cos 0-u, sine (1 miei Tmax not given)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Two blocks are supported by a pulley along an incline as shown. The lower block B has a weight of 30 lbs and the higher block A has a weight of 20 lbs. Assume that there is friction between the blocks with Hs = 0.15 and assume no friction between block Band the incline. Determine the angle z for which motion is impending. 201b 301b A Tension in block A as a function of z can be written as TA %3D Tension in block B as a function of z can be written as Tây Thus, impending motion is at z = degrees.
A weight W rests on a rough horizontal plane. If the angle of friction is θ, the least force that will move the body along the plane will be ___________ a) W cosθ b) W tanθ c) W cotθ d) W sinθ
A student applies a 100 N force at an angle 30° below the horizontal to a block causing the block to move at a constant speed along a level ground. Which statement regarding the kinetic friction on the block is most accurate? 100 N 30 The kinetic friction force is negligible and can be rounded to 0 N. The kinetic friction force is equal to 100 N. The kinetic friction force is greater than 100 N. The kinetic friction force is less than 100 N. O O O O
Part of a roller-coaster ride involves coasting down an incline and entering a loop 7.30 m in diameter. For safety considerations, the roller coaster's speed at the top of the loop must be such that the force of the seat on a rider is equal in magnitude to the rider's weight. From what height above the bottom of the loop must the roller coaster descend to satisfy this requirement? m
Can you help me solve for tension? Assume there is static and kinetic friction and normal force is dependant on friction
G:37) Determine the maximum and minimum values of the weight"W" that the block on the left can have withoutthe 100 N block on the right side to slide.The coefficients of static friction between the block andthe inclined plane, and between the rope and the drum Dare: u1 = 0.2 and is u2 = 0.3, respectively.By what percentage would the maximum value of W vary?if both coefficients of friction are doubled?
Question 11. A person is trying to judge whether a picture (mass positioned by temporarily pressing it against a wall. The pressing force is perpendicular to the wall. The coefficient of static friction between the picture and the wall is 0.650. What is the 2.59 kg) is properly minimum amount of pressing force that must be used? Ans: 39 N Question 12 A 1
Right before a shoe starts sliding down an iclined ramp, θ reaches a maximum which means the force of gravity down the ramp is also at a maximum. This force is balanced by the static friction acting up the ramp. By reducing the angle of the ramp by a factor of 2 ?? does not change, yet the object remains stationary. As the angle of the ramp decreases, the normal force increases. Explain why the object remains stationary.
1. The crate has a weight of W = 150 lb, and the coefficients of static and kinetic friction are µs 0.3 and µx = 0.2, respectively. Determine the friction force on the floor if 0 = 30° and P = 200 lb. %3D P
A child of mass 30 kg sits on a sled of mass 10kg which is pulled along the ice at a constant speed by a rope inclined at 30 °to the horizontal. The coefficient of friction for the ice and sled, HK, is 0.05. Calculate the pulling force in the rope. Pulling force F, pull 30° Gravity FG Normal i Friction f
1. A crate is being push by a horizontal force P to cause movement upward along the 15° incline without tipping. The crate has a mass of 30 kg. Type only the numerical values. Please indicate positve sign (+) for values in upward or rightward direction and negative sign (+) for values in downward and leftward direction. L P В A D 15° Your answer a) Determine the largest allowable coefficient of static friction between the crate and the incline. Your answer b) the corresponding magnitude of force Pin Newtons. Your answer
2) A disk (40mm diameter and 0.2 kg mass) is dropped in the air. Consider g = 10 m/s² and the density of air 1.2 kg/m³. Assume that the drag coefficient of the disk is 1.17. At t=0, the disk speed V = 0. a) What is the acceleration and distance when the ball speed reaches to 1/4V₁, where V, is the terminal speed? b) What would be the answer for part (a) if the falling object is hemispherical (40mm diameter and 0.2 kg mass)? Explain