3-1. A certain op-amp has the following de and very low-frequency parameters:dc open-loop gain 80,000differential input resistance 0.4 ΜΩoutput resistance50 ΩIt is used in a noninverting amplifier circuit with R; = 3 kN and Rƒ = 47 k. At de and lowfrequencies, calculate the values of the a. feedback factor, b. loop gain, c. exact closed-loopa) B type your answer...b) Loop Gain = type your answer...c) Ac =type your answer...d) Rin=type your answer...type your answer...=gain, d. closed-loop input impedance, and e. closed-loop output impedance. f. Use the resultof (3-8) to determine the approximate gain and compare with the result of (c).e) Rout=f) Acl =-type your answer...

Answered: Image /qna-images/answer/652337ed-bbf2-4809-bcdc-bf8808911479.jpg

3-1. A certain op-amp has the following de and very low-frequency parameters: dc open-loop gain 80,000 differential input resistance 0.4 ΜΩ output resistance 50 Ω = = a) B = type your answer... b) Loop Gain type your answer... c) Ac type your answer... d) Rin type your answer... e) Rout= type your answer... f) Acl = type your answer... = = It is used in a noninverting amplifier circuit with R; 3 k2 and R = 47 k. At de and low frequencies, calculate the values of the a. feedback factor, b. loop gain, c. exact closed-loop gain, d. closed-loop input impedance, and e. closed-loop output impedance. f. Use the result of (3-8) to determine the approximate gain and compare with the result of (c).

3-1. A certain op-amp has the following de and very low-frequency parameters: dc open-loop gain 80,000 differential input resistance 0.4 ΜΩ output resistance 50 Ω = = a) B = type your answer... b) Loop Gain type your answer... c) Ac type your answer... d) Rin type your answer... e) Rout= type your answer... f) Acl = type your answer... = = It is used in a noninverting amplifier circuit with R; 3 k2 and R = 47 k. At de and low frequencies, calculate the values of the a. feedback factor, b. loop gain, c. exact closed-loop gain, d. closed-loop input impedance, and e. closed-loop output impedance. f. Use the result of (3-8) to determine the approximate gain and compare with the result of (c).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

7 7 76% Q4. Figure 4 shows a circult diagram of the Wien-bridge oscillator. ASsume that the amplifier employed is an ideal op-amp. a) State the Barkhausen criterion for sustained oscillation. b) Explain briefly how the phase shift requirement for sustained oscillation is met in this circuit. c) The feedback ratio of the circuit shown in Figure 4 is given by, %3D 3R +j(2afCR-C) 27/ Derive the expression for the oscillation frequency, f. R. Figure 4 Colpitts oscillator - 7x-
For a given opamp circuit, the value of CMRR is 40 dB. If the differential gain is Ad=105, then what will be the value of the common mode gain Ac?
1- Mention any two non linear applications of op- amp. 2- For the circuit given below : Vin is a sine wave Vinpp=9 V and Vref=2.4 V , Assume Vsat=±12V Name the circuit and draw the input and output waveforms . Vo Vin Vref 3- Explain why open-loop op-amp configurations are not used in linear applications? Draw the block diagram of opamp and define the function of each block
25. Each RC circuit in an op-amp (a) causes the gain to roll off at -6 dB/octave (b) causes the gain to roll off at -20 dB/decade (c) reduces the midrange gain by 3 dB (d) answers (a) and (b) 26. If a certain op-amp has a midrange open-loop gain of 200,000 and a unity-gain frequency of 5 MHz, the gain-bandwidth product is (a) 200,000 Hz (b) 5,000,000 Hz (c) 1 X 1012 Hz (d) not determinable from the information 2-8 27. The bandwidth of an ac amplifier having a lower critical frequency of 1 kHz and an upper critical frequency of 10 kHz is (a) 1 kHz (b) 9 kHz (c) 10 kHz (d) 11 kHz 28. The bandwidth of a de amplifier having an upper critical frequency of 100 kHz is (a) 100 kHz (b) unknown (c) infinity (d) 0 kHz 29. When negative feedback is used, the gain-bandwidth product of an op-amp (a) increases (b) decreases (c) stays the same (d) fluctuates 30. If a certain op-amp has a closed-loop gain of 20 and an upper critical frequency of 10 MHz, the gain-bandwidth product is (a) 200 MHz (b) 10…
1. The upper critical frequency of an op-amp's open-loop response is 200 Hz. If the midrange gain is 175,000, answer the following: a. What is the ideal gain at 200 Hz? b. What is the actual gain? c. What is the op-amp's open-loop bandwidth? 4 (Ctrl) - 44
Problem C It is desired to have a gain of 20 for frequencies up to 180 kHz. Determine the minimum unity gain frequency specification for the op amp. The gain should be within at least 98% Vsig Rin + Rf Vcc/-Vcc +12v/ -12V Vout
Q. One advantage of having feedback in op amp circuit is A. low gain B. low bandwidth C. can control gain D. high output voltage E. less input signal F. less complicated
0.3/(5) Marks Derive the closed loop gain of the op-amp circuit illustrated in figure below. Then find the gain when R₁ 10 ΚΩ, R2 5kn, and R3: 15ΚΩ. = = = Vs R₁ R2 R3
One way to measure the slew-rate limitation of an op amp is to apply a sine wave (or square wave) as the input to an amplifier and then increase the frequency until the output waveform becomes triangular. Suppose that a 1-MHz input signal produces a triangular output waveform having a peak-to-peak amplitude of 4 V. Determine the slew rate of the op amp.
3ZJ The voltage at the node (between feedback resistance and in capacitor) of a differentaitor circuit is a.almost zero b.infinity c.approaching infinity d.maximum
1. Determine the CMRR and express it in decibels for an amplifier with a differential voltage of 8500 and a common-mode gain of 0.25. 2. Determine the CMRR and express it in dB for an op-amp with an open-loop differential voltage gain of 85,000 and a common-mode gain of 0.25. 3. When a pulse is applied to an op-amp, the output voltage goes from -8 V to +7 V in 0.75 µs. What is the slew rate? 4. Differentiate the working principle of differential and operational amplifier and its operation. Discuss your answer in at least 5 sentences.
B. Design an inverting amplifier based on real Op-Amp with a gain of 20 and bandwidth of 2MHz?