2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above 2B. Which of the following is/are a basic type of DC generator connection? a) series b) shunt c) compound d) all of the above

2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above 2B. Which of the following is/are a basic type of DC generator connection? a) series b) shunt c) compound d) all of the above

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.26MCQ: In per-unit equivalent circuits of practical three-phase transformers, under balanced thr-phase...

See similar textbooks

Related questions

Q: Q5-(A)- Explain briefly the following questions What are the reasons for connecting transformers in…

A: The transformer is an electrical device which is used to convert the voltage magnitude in a…

Q: In over compounded generator, full load terminal voltage is equals to no load voltage greater than…

A: In this question, choose the correct option What is full load voltage if generator operate at over…

Q: A type of cumulatively-compounded dc generator where the full-load terminal voltage is the same as…

A: Correct option is (b) flat. To understand this first understand what is cumulative compound dc…

Q: What are the characteristics of delta and star connected generator?

A: Characteristics of star connected generator: The voltage in each phase is less than the given line…

Q: The following figure shows load characteristics of dc generator. Match the characteristic with the…

A: Given characteristics curve or load curve of DC generator,

Q: 2- Why it's imporctical carry out actual load test on large rating transformers ?

A: Since 2 and 3 are two different questions, as per the guidelines, only the first question (2) has…

Q: type of generator is used as boosters on dc feeders

A: Series wound DC generators are restricted for the use of power supply because of their increasing…

Q: Question 1: Figure 1 shows a single-line diagram of a three-phase, 60-Hz synchronous generator,…

A: The given single line diagram is shown below:

Q: A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing…

A: In this question, We need to determine the emf induced in each phase winding and the terminal…

Q: 6. A 3 phase fault occurs at point F as shown in figure. Determine the critical clearing angle for…

A: Given figure, 3 phase fault occurs at point F as shown in the figure. The generator is delivering…

Q: The _____________________ of transformers are neglected to draw the reactance diagram. a-Shunt…

A: This is based on the fill the blank The _____________________ of transformers are neglected to draw…

Q: compound dc generator is supplying a load of 120A and 120V. The shunt field,series field and…

A: In this question we will find induced emf in short shunt and long shunt generator...

Q: 2 Define the term open circuit (no load) and short circuit of a synchronous generator in general.

A: Open circuit of a synchronous generator : When the load on a synchronous generator is open circuit…

Q: scuss the importance, advantages and disadvantages of generator.

A: The explanation is as follows.

Q: wo shunt generators, A and B, are to be operated in parallel to supply a common load. Generator A…

A: Given Generator A has a no-load voltage of 245 v and a voltage of 220 v when it delivers a load of…

Q: 4. Why we adopt open delta test instead of direct loading test to calculate the efficiency of large…

A: Transformer tests are performed to determine the performance of transformers. they are of two types,…

Q: A three phase synchronous generator with negligible resistance and Xs=20 ohm has induced voltage as…

A: Given: Per phase quantities, Induced voltage E=230 VTerminal voltage V=230 VSynchronous reactance…

Q: The one line diagram of power system is shown in Figure Q.1. Use a common base MVA of 100 MVA and…

Q: 2. Does the external chara. Of series generator represent its load chara? Why?

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: Load characteristic of DC generator is a graph between Il and Vt. True or False

A: The load characteristics of a dc generator gives the relationship between the line current and…

Q: The DC generator in Figure 4 on Worksheet 4 is a_______ a) cumulatively connected short-shunt…

A: Although in the figure 4 armature winding is connected with series field in the series combination.…

Q: Why oncoming generator’s frequency needs to be slightly higher than running system frequency in case…

A: Whenever the load on the system increases, one generator is insufficient to meet the demands and…

Q: Two shunt generators, A and B, are to be operated in parallel to supply a common load. Generator A…

Q: Q2) put ( v) or (x) for the following and correct the wrong : 1-the connection Delta-Delta is the…

A: As per the guidelines given, We can only provide the solution of the first three questions in…

Q: (A)- Explain briefly the following questions What are the reasons for connecting transformers in…

A: TRANSFORMER : A device that distributes electric energy from one alternating-current circuit to one…

Q: Question 6 What is phase angle of voltage induced in primary and secondary windings of transformers…

A: Given Phase voltage of primary and secondary due to mutual flux is

Q: Two alternators rated 400 MW and 600 MW are operating in parallel. The droop characteristics of…

A: In this answer we will find the load shared by both the alternators and also find the frequency at…

Q: The one-line diagram of a simple power system is shown in Figure below. The neutral of each…

A: In this question we need to find a 3 phase fault at bus 3 .

Q: Explain the Brush less excitation scheme of Synchronous generator with Pilote excitor. Also identify…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: The impedance transformation equation for 3-winding IT.

A: Three winding transformer- Three-phase transformer work on the principle of Faraday's law of…

Q: polyphase system is generated by______? a.Both a and c b.Having two or more generator windings…

A: poly phase AC circuits:Poly phase circuits are important because of all electric power is generated…

Q: Explain vector grouping of transformers with suitable diagrams. Mention its usefulness.

A: The three-phase transformer can be imagined as a three single-phase transformer having a common…

Q: Question 4 In case of N-R method of power flow solution at the generator bus one column and one row…

A: 4) Newton- Raphson method of power flow solution at the generator bus

Q: 1. Draw the N.L characteristics and external characteristics Of series generator, draw the different…

Q: 1- What is the no-load characteristic of d.c. generator? ic?

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: * Answer by true or false False True The core reluctance proportional directly with the length of…

A: As per the guidelines of bartleby we can answer 1st 3 sub - parts for rest of the question you…

Q: In DC shunt generator, the load characteristics is drawn between

A: In DC shunt generator,load characteristics is drawn between the terminal voltage and load current.…

Q: With a D.C. generator which of the following regulation is preferred ?

Q: Under normal conditions of the RCD, the phase, and neutral currents are equal and opposite so flux…

A: Under normal conditions of the RCD, the phase, and neutral currents are equal and opposite so flux…

Q: In Back To Back Test on Two Similar Single Phase transformers. What will be the current in the…

Q: UDng a ITIe Core in high frequency transformers. c- Discuss, different applications of iron cores of…

A: C)For magnetizing or demagnetizing a iron material, some energy is expended. The energy expended…

Q: What are the components of generator?

A: we want to know What are the components of a generator?

Q: Plot generator output voltage versus load current for operating conditions with and without…

A: Voltage regulator is a circuit designed to maintain constant voltage at the output. The following…

Q: The flux density distribution in the air-gap of a certain generator is such that it contains a…

A: It is given that: Flux per pole due to the fundamental harmonic distribution=ϕ1=9×10-3 WbFlux per…

Q: The DC generator in Figure 3 on Worksheet 4 is a_______ a) cumulatively connected short-shunt…

A: DC generator classification. DC generator is classified base on the field winding connection.…

Q: What are the reasons of fall of terminal voltage of d.c shunt generator ?

A: There are many reason of fall of terminal voltage of dc shunt generator.

Q: 4. What for brushes are employed in DC generator?

A: DC Generator: The device that converts mechanical energy into electrical energy is called DC…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

100%

2A. What is another term for "shunt"?
a) in series b) in parallel c) compounded d) none of the above
2B. Which of the following is/are a basic type of DC generator connection?
a) series b) shunt c) compound d) all of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

in distribution transformers; What is 30 degrees phase shift in delta-star connection? What are the disadvantages? (can you explain with drawing?)
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
What are FACTS (Flexible Alternating Current Transmission Systems), and how do they improve the control and efficiency of power transmission?
The internal characteristics of DC shunt generator can be obtained from *
What is the difference between star connection and delta connection for three-phase transformers?
Consider the three single-phase two-winding transformers shown in Figure. 3. The high-voltage windings are connected in Y. (a) For the low-voltage side, connect the windings in A, and label the terminals a, b, and c in accordance with the American standard. (b) Relabel the terminals a', b', and c' such that VAN is 90° out of phase with V₂'b' for positive sequence. DI H₂ Figure. 3: Three-Winding Transformer
What are the conditions for the parallel operation of 1-phase transformers?
Three single-phase two-winding transformers, each rated 3kVA,220/110volts,60Hz, with a 0.10 per-unit leakage reactance, are connected as a three-phase extended autotransformer bank, as shown in Figure 3.36(c). The low-voltage winding has a 110 volt rating. (a) Draw the positive-sequence phasor diagram and show that the high-voltage winding has a 479.5 volt rating. (b) A three-phase load connected to the low-voltage terminals absorbs 6 kW at 110 volts and at 0.8 power factor lagging. Draw the per-unit impedance diagram and calculate the voltage and current at the high-voltage terminals. Assume positive-sequence operation.
Three single-phase, two-winding transformers, each rated 450MVA,20kV/288.7kV, with leakage reactance Xeq=0.10perunit, are connected to form a three-phase bank. The high-voltage windings are connected in Y with a solidly grounded neutral. Draw the per-unit equivalent circuit if the low-voltage windings are connected (a) in with American standard phase shift or (b) in Y with an open neutral. Use the transformer ratings as base quantities. Winding resistances and exciting current are neglected.
In per-unit equivalent circuits of practical three-phase transformers, under balanced thr-phase operation, in which of the following connect ions would a phase-shifting transformer come up? (a) Y-Y (b) Y- (c) -
Q5-(A)- Explain briefly the following questions What are the reasons for connecting transformers in parallel operation? Why are the brushes of d.c machine always placed at the magnetic neutral axis? 3-Why the iron losses are constant during load and no-load?
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --