[29] ø1.14 ø1.73[44] .43[11] [14] .55 [14] .55 [41] [28] 1.08 [4.5] 17- .74[19] 1.61 1.89[48] [19] L.74 (H) (F [19] .74 .71[18] 1.22[31] - 2x 0.255[6.51] V.421.11] G) ø1.120[28.5)- R.74[19] [3] .12 [65] R2.55 R.51[13] [13] .51 2X 0.629[16] IN LINE 43° 4.64[118] NOTE: UNLESS OTHERWISE SPECIFIED 1. FILLETS & ROUNDS R.12[3] 2. FINISH ALLOWANCE R.12[3] 3. DIMENSIONS IN [] ARE mm 4. MACH FINISH .000063[1.6] 2X ø.531[13.5] UNSPECIFIED TOLERANCES MATERIAL THIRD ANGLE PROJECTION GRAY IRON 2-PL DEC IN.C.XX) ±,02[0.5) DWN BY REDRAWN BY SCALE CHKD 3-PL DEC IN.C.XXX) 1,004[0.11 H.N. IRVINE M. ŽOKVIĆ NTS LS TITLE DRILLED HOLES 0 025 DWG NO. PIVOT ARM 31A063 ANGLE 10° 30' 270

In gear designs, geometric numbers, I and J will be needed to calculate bending and contact stress numbers per per AGMA standards. Please select all the answers that apply.     Geometry factor I will be different for the pinion and for the gear.      Geometry factor J will be the same value for both the pinion and for the gear.      Geometry factor J will be the different for the pinion and for the gear.      Geometry factor I will be the same value for both the pinion and for the gear.

Define the term nominal dimensions?

Consider a thread callout of Dia 0.375-10 UNF-2B. How far will the thread travel if it is subjected to 3 full rotations? (Assume infinite thread lengths for simplicity)?  Units are in Inches List your answer in a decimal format.

Solve correctly

State any THREE conventions in dimensioning.

3. If there is a 0.10 mm accuracy error for all measured parameters at Instruction 1, determine the true volume of the allen bolt. Also, comment on the difference between volume calculated by measured data and volume calculated by true data.

Refer to drawing 21A033, what is dimension G?  (Please note that you can't just assume the hub protrudes equally on both sides as it may not)   All abbreviations are standard

Bolt material is 304 stainless steel. frame material is Aluminum. kindly assume all the other values and find the bolt size / diameter for bolt. write all formulas and explain the procedure. there are 2 bolts 1 on left and 1 on right.

Please fast answer