252 Q.22: For the circuit shown beside, find v and V2 for t > 0 if the circuit is in steady-state at t <0. (Ans.: v(t)=8-2e v & v2(t)=10-4e * V) + 6V 252 10V IA 252 F: V2 +

Q: In the circuit below, if at time t,, the outputs Q and Q were equal to 0 and 1, respectively, what…

A: Answer: Q=1 and Q=0   Explanation: a. It is not a valid option. the value of Q and Q are inverse…

Q: 1. For the system shown below: 2 1 R, R2 es C (a) write the state equations of motion for the system…

A: Given: The electrical system is shown below: To find: (a) write the state equations of motion for…

Q: Obtain the dynamic model (differential equation) of the electrical system below with input vs and…

A:

Q: 8. Find the charge and current in an RLC circuit with R = 11 ohms, L= (0.1 TOU) H and C (0.01 +)F,…

A: For an RLC circuit, the circuit parameters are given as R=11 Ω,L=0.1+n100=0.1+3100=0.13…

Q: Given is the parallel connected RLC network as depicted in the figure below. L R 1)I(t) iz(1) The…

A: As mentioned Matlab is not needed so we are solving theoretically. A parallel RLC network is given.…

Q: Problem 3: Consider a second-order system described by the following transfer func- tion: 0.04 G(s)…

A: The solution is given below.

Q: In the circuit shown to the right, is is a current source. The Op Amp is ideal and has infinite…

A: a) The differential equation in terms of Vo is found below: If we take ideal op-amp case:…

Q: Since the simplified model of the bumper of this vehicle is as follows, x(t) m F.(t) b a- Find the…

A: (a) When the car is pushed a distance x(t) in the right direction. Write the expression for the…

Q: Suppose that the impulse responses of the sub-systems S1, S2 and S3 that are connected as shown in…

A: Code for above problem

Q: The voltage source in the circuit is changed to a unit impulse; that is, vg=δ(t). 1. a) How much…

A: Given data: Apply source transformation, A) For impulse current source, the capacitor acts as a…

Q: 8. Find the charge and current in an RLC circuit with R = 11 ohms, L (0.1 )H and C (0.01 + F, which…

A:

Q: step response to the system described by the linear constant cted below: 6y[n] – 5y[n – 1] +y[n – 2]…

A:

Q: 1- Prove that RTh=-5KN at t20 with respect to the сарасcitor. 2- Drive the expression of ve(t) for…

A: We will find out the resistance across capacitor and voltage across capacitor .

Q: The op amp in the circuit seen  isideal. Find the steady-state expression for vo(t) when vg=2 cos…

A: Circuit diagram is given,

Q: A series RLC circuit has the following parameters: R = 0.2 2, L = 200 mH, C = 8 mF and V(t) = 10 sin…

A: Given data: R=0.2 Ω L = 200 mH C = 8 mF v(t)=10sin(8πt) V (a)The differential equation for the…

Q: 4. The steady-state current I flowing in a circuit that contains a resistance R 5, capacitance C=…

A: Write the given values in the question with their standard units.

Q: Given the plant transfer function, G(s) = 90/ s(s+4) and H(s) = 1. Obtain (i) characteristic…

A: In this question we will solve second order system.... Note:- as per our guidelines , I am supposed…

Q: .For the circuit shown in Fig determine (a) (b) vC(0+); (c) the circuit time (d) vC(3 ms) t=0…

A:

Q: b. A system with open loop T.F given by, 100 G(S)H(S) = S(S + 4)(S + 5) i. Is the stability or the…

A: GivenGSHS=100SS+4S+5characeteristic Equation1+GSHS=01+100SS+4S+5=0SS2+9S+20+100=0S3+9S2+20S+100=0

Q: The circuit shown in Fig below has a step input voltage v(t)-10., a resistance R1 of 3.1 Q. an…

A:

Q: Practice Problem 8.11 In the op amp circuit shown in Fig. 8.34, v, = 10u(t) V, find v.(t) for t > 0.…

A: Given:vs=10u(t)R1=R2=10kΩC1=20μFC2=100μF

Q: i) A series circuit contains a resistance, R 2, a capacitor, C F, a coil L H; supplied by a d.c.…

A: A series circuit having a resistance R, a capacitor C, a coil L supplied by a d.c. source E is shown…

Q: I. Find the current in an RLC circuit with R = 11 ohms, L = (0.1 + T) H 100 and C = (0.01 + 00) F,…

A: We need to find the current in an RLC circuit with R=11 Ω, L=0.1+3100=0.13 H, C=0.1+6100=0.16 F…

Q: Find the charge and current in an RLC circuit with R = 11 ohms, L = 0.11 H and C = 0.13 F, which is…

A: For an RLC circuit with R=11 Ω, L=0.11 H, C=0.13 F, Vt=12 V; initial charge q0=0.05 C, initial…

Q: 1- Prove that RTh =-5KN at t20 with respect to the capacitor. 2- Drive the expression of ve(t) for…

A: We will find out the resistance and voltage across capacitor

Q: The sinusoidal voltage source in the circuit shown in Fig. 1 is generating the voltage vg = 20 sin…

A:

Q: Figure 3.1 shows an RLC circuit at t>0 s. Assume a current source of 5A is applied to the circuit.…

A: Critical damping returns the system to equilibrium as fast as possible without overshooting. An…

Q: Figure 2 (c) If K(s) = kp, find the value of kp such that the natural frequency (wn) is 10 rad/sec.…

A:

Q: Q2. The step response at t > 0 of a series RLC circuit is observed to be vc(t) = 15 – 15 e-1000t…

A: (i) Voltage across the capacitor is given in the question Vc(t)=15-15e-1000tcos1000tand we know…

Q: 1- Prove that RTh=-5KN at t20 with respect to the сараcitor. 2- Drive the expression of ve(t) for…

A: We will find out resistance across capacitor and voltage across capacitor

Q: The op amp in the circuit  is ideal.1. Find the steady-state expression for vo(t).2. How large can…

A:

Q: Question 2 Given the following values R = 5 kN, L1 = L2 = 2 H, C1 = 2 nF and C2 = 8 nF. i,(1) i,(t)…

A: RLC parallel circuit

Q: 500N 1000 0 160 nF 100 mH R = 500 N, R2 = 1000 N, L = 100 mH,C = 160 nF,i,(t) = 4 cos 5000t mA %3D…

A:

Q: For the system with forward path gain G(s) s+8 g2+8s+3 and feedback gain H(s) =0 input R(s) = ; will…

A:

Q: 10. Design an Op-Amp based circuit that would solve for v, (1) of the second-order, constant…

A: vot=10-6d2votdt2+0.5.10-3dvotdt+vot=2.ut       =10-6d2votdt2+0.5.10-3dvotdt+vot-2×ut=0…

Q: Assume that the circuit in the image has been connected for a very long time. (a) As time…

A:

Q: 12v ( R₁ لاش +=0 R₂ 1. Determine the initial conditions i₁(0+) and vc(0+) 2. Determine the steady…

A:

Q: An engineering student built a series circuit as shown in the picture. R 12V (If you are curious,…

A:

Q: Given the circuit below, solve for the following: R1 4ohm R2 1ohm 5u(-t) A v. 0.5F 2H а. Derive the…

A: Apply KCL at node and write the capacitor voltage in terms of inductor current and than obtain…

Q: 2.9: For the circuit shown, if (it=5+3sin@t+1.5sin2@t) Amp Write the: 1. Non-sinusoidal current…

A: The capacitor works as an open circuit for DC current, and it allows AC current to flow into it.

Q: Find Vc, IL and the energy stored in the capacitor and inductor in the circuit of Fig. 4 under dc,…

A: Circuit diagram is given as,

Q: 1. v(in volts) and dv/vt(in V/s) at t = 0? 2. i(0+) in Amperes? 3. di/dt(in A/s) at t = 0+? 4.…

A:

Q: 3. Given i () 1.5K L (1) 100 mh 0.01 μ f with input (changing from –5 to +5 at t=0) in (1) - 5 a.…

A:

Q: 10) A system is given as y(n) = 0.5y(n - 1)+ 3r(n) + 2.x(n – 1) with input signal r(n) = 2euon u(n).…

A: As we have given  yn=0.5yn-1+3xn+2xn-1 We know the property of Z transform , xn→Z TransformXzxn-no→Z…

Q: 4. A series RLC circuit consist of 5 2 resistor, 50 mH inductor and 1 mF capacitor. If it is…

A:

Q: The circuit shown in Fig below has a step input voltage v(t)=10, a resistance R1 of 8.9 Q, an…

A: The solution for rise time can be achieved as follows.

Q: Problem 4: Use the mesh-current method to find the steady-state expression for v(t) in the circuit…

A: Use the mesh-current method to find the steady-state expression for v (t) in the circuit shown if…

Q: 5. If R = 10 Ω, L = 5 H, and C = 2 mF, find a, b, and the roots of the characteristic equation. What…

A:

Q: 10 N 25 N t = 0 40 mH 10 V 50 Q 3. Obtain the expressions for iL(t) and v(t) in the circuit shown…

A: In this question we will find inductor current and voltage across resistance....

Q: Consider the L-R-C circuit modeled by ,d°Q ÕP Q = E, sin ox,Q(0) = Q, MO) = Q'(0) = I,. Determine…

A: Write the given expression and Differentiate it.…

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).