4.4 2525. A capacitor (0.02 F) is charged to 1 V and then connectedin series with an inductor (10 H) and a resistor (40 S2). Ini-tially, there is no current in the circuit. Find the amplitude,frequency, and phase of the charge on the capacitor andplot its graph.

Answered: Image /qna-images/answer/db06b860-e7ec-4a13-859a-6233f786fff1.jpg

25. A capacitor (0.02 F) is charged to 1 V and then connected in series with an inductor (10 H) and a resistor (40 52). Ini- tially, there is no current in the circuit. Find the amplitude, frequency, and phase of the charge on the capacitor and plot its graph.

25. A capacitor (0.02 F) is charged to 1 V and then connected in series with an inductor (10 H) and a resistor (40 52). Ini- tially, there is no current in the circuit. Find the amplitude, frequency, and phase of the charge on the capacitor and plot its graph.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: 2.The specification sheet for a JFET shows the following values: VGS(off) = -8V, IDSS = 5mA.…

Q: 12.27 There is no energy stored in the circuit shown in Fig. P12.27 at the time the switch is…

Q: f(A, B, C, D, E) = Σm(3, 11, 12, 19, 23, 29) + d(5, 7, 13, 27, 28

Q: Question 10 00 answer. The following shift-register based sequential system detects the following…

A: Giventhe shift register base sequence system detects sequence 0001,0011,0101,0111

Q: 1) Discuss principle of Conductivity Modulation. 2) Discuss the influence of Conductivity Modulation…

A: 1. Conductivity modulation is a principle used in electronic devices to control the flow of…

Q: 5. 3-phase full converter, fed from 3-phase, 400V, 50Hz source is connected to load R=102, E=350V…

Q: Can analog and digital communication be used together in a communication system?

A: Yes, analogue and digital communications can be used together in a communication system. In many…

Q: 8 a) Find the average power, the reactive power, and the apparent power supplied by the voltage…

A: Given the data, Vg=40cos106t v

Q: Let x(t) = rect(t − ₂) and y(t) = e−²tu(t − 1). Find the sketch the convolution, z(t) = x(t) * *…

A: Given the rectangler sihnal xt=rectt-12 output the exponentail signal, yt=e-2tut-1 then,

Q: 5* Find Y (Jw) for the system if x (+) = cos (+) h (t) = a (+) - u (+-2) X(+) ²₂h (+) 9(4)

A: In this question we need to find the y(iw) of the given system.

Q: F(s) = e. F(s): f. F(s): 3s s²-s-6 2s +2 s² +2s +5 2s 3 s²-4

Q: VS Is R www 오늘 + jXL IR VR ㅜ

Q: (a) Power factor angle (b) Total current (c) Current of the capacitor (d) Value of the capacitance…

A: Introduction Parallel RLC circuit An electrical circuit is known as a parallel RLC circuit when it…

Q: From the image below choose witch boolean functions are dual, and How many of the functions are…

A: In the question Given some Boolean expressions and asked to match with their duals. Why transfer and…

Q: 152130 222 Ⓒ520° Fj² Find voltage drop Mutual induetanee • do # + = Majt SIR V. 12 resistance Nex…

Q: (c) A single-phase electricity distribution system shown in Fig. 19(c) is used to provide exclusive…

A: Given data Primary Source voltage, vs=1 kV r m s Primary side resistance, R1=100 Ω Turns ratio,…

Q: 3. For the circuit shown in Figure below, TH is triggered reference to each zero cross over point,…

A: Given is a converter

Q: 1.4. The charge cycle shown in Figure P1.4 is an example of a three-rate charge. The current is held…

A: Given data The graph of the battery current and battery voltage is given in the problem. Battery…

Q: Find the impedance of the circuit in Figure 16.2 (RandLin series, and thenCin parallel with them).…

A: Given that R is in series with inductor L. And that combination is in parallel with capacitor C.

Q: 3.26 A pn junction for which the breakdown voltage is 12 V has a rated (i.e., maximum allowable)…

A: I have written this solution as handwritten solution.Hope you find the solution clear.

Q: Three-phase electricity is delivered to a factory 7 km from a distribution company. The factory…

Q: A battery had a short-circuit current of 30 A and an open-circuit voltage of 24 V. If the battery is…

Q: Consider the circuit below. Cik Complete the timing diagram for F. A B F AD 1 B A D Q n 10 3

Q: Draw block diagram representations of the DSP filters represented by the difference equations: (i)…

A: Here we can represent each delay by z-1 as shown in below figures.

Q: Consider the circuit in (Figure 1). Suppose that i-60 A. Figure 50 V 50₂ 20 V 51 1 of 1 25 A Part A…

A: Answer : given that current i= 60A voltage across the current source i is vi. voltage across…

Q: Could you please show the solution step by step without skip any steps for this kind of…

A: For the two subparts of Question 1c given, input x[n] and output y[n] are shown, and they are…

Q: Question 49 The Boolean expression for the logic circuit drawn is: A B OY= (A + B)(A + B) OY=AB+ AB…

A: In this question we need to choose a correct option.

Q: 1. A 4-pole, 100-volt shunt motor with 200 conductors wave connected is developing 6HP output power…

A: In this question we need to find the stray power loss and the flux per pole of the given shunt…

Q: (b) Given x(t) = e-tu(t) and X(ao) = F(x()]= of: (i) GO x(t-4) r(-2t-4)

Q: find the VL (0+)

A: It is given that: I=5 AR1=6 ΩR2=4 ΩL=2 Hi10-=2 A

Q: A parallel RLC circuit shown in Fig. has R = 1000mega, L = 20 mH and C-10 μF. The supply voltage is…

Q: An RC high pass filter consists of a 1000 Ohm resistor, what is the value of C so that the cut off…

A: Given, AN RC high pass filter has, Resistance, R=1000 Ω. Cutoff frequency, fc=10 kHz.

Q: A 150 KVA 480 to 120/240-volt, 3Ø, 4-wire transformer has Z = 2.07% on its nameplate. The available…

A: Given, A 150 KVA 480 to 120/240-volt, 3Ø, 4-wire transformer has Z = 2.07% on its nameplate. To…

Q: Solve the Thevenin and Norton equivalents for the network connected to the 1 Ohm resistor and…

A: In this question We need to determine the Thevenin equivalent and norton equivalent across the…

Q: 2. Which wave a larger intrinsic impedance in a waveguide: a TE wave or a TM wave?

A: The strength of the magnetic and electric fields in free space is described by intrinsic impedance.…

Q: 7.) Use the principle of superposition to find the current i shown in Figure 7. 3H 8cos (10) V 0.5mF…

Q: A certain system has the transfer function = 2 On 2 s²+25ws + n where <1 Determine : (i) The…

Q: Assume that R4 is the load of the circuit, What value of R4 will maximize the power transfer when…

Q: 2. Calculate Fourier series coefficients for the following periodical function with fundamental…

A: 2.Answer: give that fundamental period T = 4 sec…

Q: SECTIONS Calculate the distribution factor for a single layer 18 slots 2-pole three-phase stator…

A: Given: A single layer stator winding with, Number of phases = 3 Number of poles, P = 2 Number of…

Q: c) I, fort >0 di b) du (ot) 0<7 г і со Comment of my oupees бух още का

A: It is given that: iL0=4 A

Q: a) Find the Thevenin equivalent circuit from the perspective of RL. b) Using the equivalent circuit…

A: As per the guidelines of bartleby we supposed to answer first three subpart only for solution of…

Q: In the circuit above; E = 9.86 (V), R₁ = 108 (ohm), R₂ = 145 (ohm) and L = 30.3 (mH). The switch was…

Q: Four point charges of equal magnitude are arranged at the corners of a square as shown in the…

A: answer: given that to find the electrical potential at a, b, c points doe to four charges…

Q: how to find Vo?

A: In this question We need to determine the output voltage Vo as shown the circuit. We know Forward…

Q: 1.1 Use superposition to determine the voltage V in the circuit below. The current U is an arbitrary…

A: Given an electrical circuit (a) To use the superposition theorem to determine the voltage V in the…

Q: 3.) Use node voltage analysis to find the node voltages va, Vb, and vc for the circuit shown in…

Q: Consider the circuit shown below. E R2 R3 I ZN www R6 R5 R7 R8 a CO Ro Ri R1 and R2 R3 and R4 R3,…

A: In this question we need to choose a correct option.

Q: Re=1kohms Rb=560 ohms R1= 22k ohms R2= 6.8K ohms (R1 nd R2 in series) Beta= 175, For the…

A: Answer: given that resistances of the amplifier that are Rb= hie = 560 Ω R1=22 KΩ R2= 6.8 KΩ common…

Q: The current (amperes) through the 6-Ω resistor is most nearly: 6VΞ 4Ω {3Ω 6Ω

A: Given data, Circuit diagram is given as,

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

4.4 25
25. A capacitor (0.02 F) is charged to 1 V and then connected
in series with an inductor (10 H) and a resistor (40 S2). Ini-
tially, there is no current in the circuit. Find the amplitude,
frequency, and phase of the charge on the capacitor and
plot its graph.

Expert Solution

Step 1

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
List the five capacitor replacement rules.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
Show that the voltage division rule for two capacitors in series as in the figure
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
Energy stored in capacitor. Answer it in 30 mins. Draw/sketc the problem thank you. Write the basic equation before the soln. Thank you
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7