(22) 22602 2270 CM) O STONE GERIMI GREW (CAL 165 Fr Ra Ac RI W 164 La Hf Ta 105 Db F1 F 106 107 Sq W Bh LD 190 74 In a) Find the pressure (atm) in the tank using the truncated virial equation. instead of the virial equation? b) What would be the percentage error in the pressure if the ideal gas equation was used c) from the virial equatic res Estimate the value of the compressibility factor for nitrogen at the given conditions M R acentric factor is 0.039. Q3) Nitrogen is stored in a tank at -40 °C, and the molar volume of nitrogen is 0.9 L/mol. The critical temperature and pressure of nitrogen are 126.2 K and 34 atm, respectively. Nitrogen m

Q: The OSHA 8-hour HCN limit is at 10.0 ppm. According to the Merck Index, 300 mg/kg of air at room…

A: Current OSHA 8-hour limit for HCN in air is = 10.0ppmLethal dose of HCN in air is = 300 mg/kg of air…

Q: A multistage counter-current absorber is designed to recover solute A from a nitrogen gas stream.…

A: Inlet gas stream flow rate (VN+1) = 157 kmol/hMole fraction of solute in the inlet gas streamyN+1 =…

Q: A power plant emits 216 g of SO2 every hour. The wind recorded on the same day is 5 m s-1, and the…

A:

Q: Consider a reaction A B C carried out in a plug flow reactor. Initial concentration of A, B. and C…

A: The initial concentrations of A, B and C are given as 4, 2 and 0 mol/m3 , respectivelyMean Axial…

Q: Derive the differential equation that describes the desorption in a plug flow basin (Hint: write a…

A: To derive the differential equation that describes the desorption in a plug flow basin

Q: Air at 15°C and 100 kPa occupies 0.03 m³. The air is heated at constant volume until the pressure is…

A:

Q: 27. Two liquids enter a mixing chamber and are discharged at 80°F at the rate of 50 gal/min. Liquid…

A: outflow rate of liquid from the chamber = 50 gal/mintemperature of out flowing liquid = 80…

Q: Witha 60% efficiency, a cyclone is utilised to capture particles. A second control device is a…

A:

Q: An isothermal reversible reaction (A + B) is carried out in a liquid solution. The reaction is first…

A: In an isothermal reversible reaction, the reaction proceeds in both the forward and reverse…

Q: fruit juice in each of the Identify the amount of concentrated concentrated juice A which contain…

A: xA =mass fraction of solids in  juice AxB = mass fraction of solids in juice BGiven,xA = 0.65…

Q: Read the article (Gimli Glider) in the Details section of the assignment. When you do this problem,…

A: The amount of fuel found in the tanks of the flight using the dripstick check,The mass of fuel…

Q: Estimate the specific enthalpy of ethyl alcohol at 1 bar and 200°C, taking the datum temperature as…

A: As no data are given on the exact variation of the Cp of the liquid with temperature, use an…

Q: 9. Determine the specific volume of saturated vapour by Redlich-Kwong equation for the following,…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: 1- Calculate the mass flow rate of carbon dioxide gas assuming frictionless flow. 2- Calculate Mach…

A:

Q: A water company wants to construct a pumping station, which delivers water from a river source to…

A: Given, discharge line is 4 in Sch. 40 pipe4 in Sch. 40 pipe has an ID of 4.026 inches. Discharge…

Q: Water at 20°C is to be pumped from a reservoir (ZA= 5 m) to another reservoir at a higher elevation…

A:

Q: The mole fraction of oxygen molecules in dry air is 0.186. What volume of dry air at 2.88 atm and…

A: Mole fraction of oxygen in the dry air = 0.186Temperature of dry air = 22.1 0CPressure of dry air =…

Q: 2. A stream is flashed composed of mixture specified below. Given that the upstream of valve is 250…

A: A hydrocarbon mixture is flashed vaporized. The mixture is fed first to a valve and then an…

Q: A 100 kg/min gas stream consisting of 20 mol % hydrogen and 80 mol% carbon monoxide was fed into a…

A: Flow diagram for the process is given below.

Q: You are combining a calcium chloride solution with a 2% W/V alginate solution to form a gel in a 1:1…

A: To determine the percentage w/v of the calcium chloride solution required for crosslinking with the…

Q: 3- Which one/ones are not correct about silicate ceramics? a) b) () OD d) e) In layered silicates…

A:

Q: Q1\A- A filtration test was carried out with slurry on a laboratory filter press of 0.186 m² under a…

A: The concept of specific filtration rate is used to find lab scale and industrial filter relation.…

Q: Determine the rate of flow of water through 300 mm а pipe dimeter placed in an inclined Position…

A:

Q: Q.1. Acetaldehyde is to be decomposed at 5200C and 1 atm. in a CSTR. The reaction is irreversible…

A: Since you have posted multiple questions ,we will provide the solution to the first question as per…

Q: B) Catalyst pelle air at 1 atm and 80 C particles is 960 kg/m sufficient for fluidize viscosity of…

A: Temperature, T= 80 0C = (80+273) K = 353 KPressure of Air, P= 1 atm =101325 PaDensity of catalyst…

Q: 100 kmol-h-1 of a mixture containing 10, 20, 30, and 40 mol % of propane, n-butane, n-pentane, and…

A: A mixture of hydrocarbons is preheated and then fed o a flash separator.The operating temperature of…

Q: (i) The velocities before and after the pump. (ii) The head supplied by the pump. (iii) The power…

A:

Q: A 15 cm (schedule 80, IPS) steam main has a 10 cm thick 'preformed' mineral fibre insulation on it.…

A: h = 10cmk = 0.035 W/m 0Cradius of the bare pipe = 15/2 = 7.5 cmThe outer radius of the pipe…

Q: (c) use solve (d) double the resistance time of the solvent S in 15. An irreversible gas phase…

A: Given Irreversible reaction A= 5B

Q: In a continuously operating distillation column, 5000 kg/h equimolar mixture of CCl4 and CS2 will be…

A: Mass flow rate of equimolar mixture of CCl4 and CS2 = 5000 Kg/hRecovery rate = 3CS2 in top product =…

Q: (1) An asbestos pad is rectangle in cross section, measuring 3 cm x 10 cm on a side at its small…

A: To determine the temperature at the center of the wire (Tmax) and the convective heat transfer…

Q: Exereuse 1. 69 The total combustions of mole of Liquid methanol under Standard pressure and…

A: Moles of methanol = 1 molAmount of heat released during combustion at STP = 725.2 kJ/mol

Q: Provided that the mixture (binary) follows Raoult's Law and Dalton's Law, what is the expression for…

A: Dalton's Law of partial pressure states that the total pressure of the system is given by the sum of…

Q: A fixed volume container contains air at 2 bar pressure. When 100 kJ of heat is removed from the…

A: A fixed volume container contains air at 2 bar pressure. When 100 kJ of heat is removed from the…

Q: (i) Calculate the following parameters that describe the flow through the pipe: the velocity V of…

A:

Q: Derive the equations CA, CB, and tmax (as functions of k1, k2, and CA0) to give the maximum product…

A: Reactions with the rate of reaction areA->B->C-rA = k1.CArB = k1.CAConditionsReactant A…

Q: 1- The thermodynamic device, which uses water as the working fluid and the basic information is…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: The number -average molecular weight of a polypropylene is 1,000,000 g/mol. Compute the…

A: The number -average molecular weight of a polypropylene =1,000,000 g/mol.molecular weight  of…

Q: 1. Natural gas is burnt in a furnace (composition 95% methane, 5% nitrogen) and the following flue…

A: Note: Since you have posted multiple questions, we will provide the solution only to the first…

Q: 8. Xylene has been found in the contaminating the soil below a factory that uses the solvent…

A: Given:Total mass of xylene in the soil (wet weight basis), m= 22 gVolume of soil,V = 150…

Q: 01: 0.5 kg of air executes a Carnot power cycle having a thermal efficiency of 50%. The heat…

A: Given : Mass of air (m) = 0.5 kgCycle efficiency (η) = 50 % Heat transferred during isothermal…

Q: A tank shaped like a vertical cylinder initially contains water to a depth of 9m. The bottom plug is…

A:

Q: 10.16. A binary system of species 1 and 2 consists of vapor and liquid phases in equilibrium at…

A: z1​=0.65lnγ1​=0.67⋅x22​lnγ2​=0.67⋅x12​P1sat​=32.37 kpaP2sat​=73.14 kpaa) Calculate activity…

Q: Air enters a natural draft cooling tower at 100kPa and 15°C and 50% humidity. Cooling-water at 50°C…

A: The Cooling Tower works on the principle of psychrometrics and energy and mass balance…

Q: Q5: In a closed vessel the 100 kg of steam at 100 kPa, 0.5 dry is to be brought to a pressure of…

A: given = mass of steam = 100Kg at 100 kPasteam is brought to a pressure of 1000 kPato find = mass and…

Q: escribe one key decision that was made either in the design of the task, system, or execution of…

A: The implementation of proper safety measures in industrial facilities, especially those that handle…

Q: Problem 1.13 The velocity distribution for flow over a flat plate is given by u=y-y² in which u is…

A: Given Velocity u = (3/4)y -y2viscosity (μ) = 8.6 poise10 poise = 1 N s/ m2(μ) = 0.86N s/ m2

Q: For an elementary reaction: 2AB 2A+B if the volume of the vessel is reduced to one-third of it's…

A: Elementary reaction is given,And rate of the reaction can be written as,…

Q: Consider an ideal gas which is being throttled to pressure of 1 bar at a rate of 100 mol/s The…

A: Molar flow rate of an idea gas = 100 mol/sInitial pressure = 25 barFinal pressure (pressure at the…

Q: A heat exchanger is to consist of a number of tubes each 25 mm diameter and 5 m long arranged in…

A: pressure drop = 2KN/mdiameter, d = 25 mmlength, l= 5mviscosity, = 1 mNs/m2 = 10-3 NS/m2Heat load =…