2000 kg cast iron hoisin at 350 degree Celsius is quenched in 4000 kg of water at 15 degree Celsius. Find the amount of heat transferred to the water bath, entropy change for water and cast iron, use the entropy generation to prove that the entire system does not violate the second law of thermodynamics. Water specific heat of 4.18kj/kg.k, cast iron specific heat of 0.42kj/kg.k

Q: moles of a diatomic gas are subjected to a thermal cycle as shown in the figure   calculate:…

A:

Q: Ammonia exits the stream of a process as saturated liquid at a pressure of 11bar, and is reduced to…

A:

Q: A- Define the following with mathematical expression if needed: 1- Closed system, 2- Cycle, 4-…

A: The given question is

Q: #7. Suppose I am outside grilling on a 0 °C day. I grill a 0.64 kg steak for 7.0 min. Suppose my…

A: we will solve this by basic calorimetry , once we get the final temperature we can guess the type of…

Q: A fluid at 0.8 bar occupying 0.06 m is compressed reverably to a prossure of 113 bar and specific…

A: we are to find out the work done during expansion process in this cycle , the unknowns are the mass…

Q: Boiler evaporates 31500 kg / hour of water at a pressure of 165 bar and temperature 350 C and the…

A: Boiler efficiency can be defined as the as the ratio of heat absorbed by the water to increase it's…

Q: 715 Q.2. A boiler delivers 5500 kg of steam/h at a pressure of 750 KN/m² and with a dryness fraction…

A: (a) To find: The thermal efficiency of the boiler. Given: The mass flow rate of steam is m˙s=5500…

Q: Superheated steam at 652 psia and 608 Fis generated in an Oil-fired boiler at the rate of 100,000…

A: Write the enthalpy of superheated steam. hg=1290.72 Btu/lb Write the enthalpy of feed water.…

Q: A- Define the following with mathematical expression if needed: 1- Closed system, 2- Cycle, 4-…

A:

Q: Water in a tank can be heated from T; to T by: case (1) Adding heat from external source or case (2)…

A: Solution:

Q: 4) Air is compressed in a steady-state compressor from 150 kPa and 16 °C to 650 kPa. The mass flow…

A: As this is a multiple question , so as per the guide lines I would be answering only one question.…

Q: 6. An inventor comes to you with a device that produces work. She tells you helium gas at 10 atm and…

A:

Q: Please consider a power producing device that was taking in steam at the 5. rate of 2.1 kg/sec and…

A:

Q: 11. Ammonia vapor is compressed in a closed system from 15 psia, 3 cu ft, to 150 psia, 0.4 cu ft.…

A: GIVEN DATA -

Q: e tsat2, dryness, and enthalpy change. (69.10C, 90.4%, -657.34 kJ/kg) 1.05 (182.04) (t Sat.) LO…

A: Answer is attached below:

Q: 7. Air to H20 heat exchanger: Air enters a heat exchanger at (2000 F, 15 psia) and exits at (500 F,…

A:

Q: 02/ A metal with 1.5T, k cooled to 300 k by transferring heat to environment at T = 27" Describe the

A: givenInitial temperature of the T1=1.5TK=1.5×300=450KEnvironment temperature T=300Kweight of metal…

Q: Process during heat addition and heat rejection for Carnot cycle and Rankine cycle?

A:

Q: Explain the "burst potatoes in the boiling water" with thermodynamic viewpoint.

A: Whenever potatoes are boiled in the water, there is heat transfer from the hot water to the potato.…

Q: Q6) A stream of water at 85°C, flowing at the rate of (5 kg. s is formed by mixing water at 24°C…

A:

Q: Q/ A piston/cylinder arrangement, contains oxygen at 200 kPa, 350°C. The 40-kg piston has a diameter…

A:

Q: ) An open type heat exchanger (feed water heater) operates at 7 bar pressure. Compressed liquid…

A: Given data: For feedwater heater entry: At (1): Compressed liquid, P1=7 bar, T1=35 °C, At (2):…

Q: . How much heat must be released p completely turn 1.0-kg steam with n initial temperature of 120°C…

A:

Q: A Prandtt tube (Pitot-static tube with C-1) is used to measure the velocity of water The…

A: Given:Pitot-static tube with C-1differential manometer reading, x=10 mm of liquid =0.01 m of…

Q: A Copper ball at 40°C is dropped in a mug containing water at 40°C. The heat will Select one: O…

A: In solids heat interaction takes place by virtue of temperature difference.

Q: The saturated steam R-134a (Case 1) initially at 900 kPa is subjected to the following processes. a)…

A: Given data: Initial state of the refrigerant R-134a: P1=900 kPa and saturated vapor. From the…

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.