20. What are the currents flowing through the 2-2 resistors (Use Kirchhoff's rules) V Allt 252 380 16 V +lit a. 1A b. 2A c. 3A d. 4A

Q: Please answer quickly thank you

A:

Q: 4Ω 400 V DC 10 Ω DC ΣΩν 40 V 19 Μ 10 Ω DC 20 V

A:

Q: In the figure, the current through the wire (shown in cross-section) is into the screen. What will…

A:

Q: +(1-3) How It is required to find the midband gain, the upper and lower -3dB (0707 Av) frequencies…

A:

Q: find Z equivalent if the frequency is 50: R3 R2 R1 552 792 3052 3mF Zeq 4mF 2H

A:

Q: 4. A 3-phase, 50 Hz induction motor is wound for 8 poles. If the full load slip is 2.5%, calculate…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: 3-phase, 220kV, 200km overhead transmission line has its conductors on the corners of triangle with…

A: In this question we need to find a total inductance and capacitance of transmission line.

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

A: Baud rate is rate at which the data is transmitted that is number of bits transmitted per second.

Q: A 1.5-kVA 240/120-volt single-phase transformer is serving a 10-ohm load connected at the…

A: Transformer is a static device which is used to step up/Down the voltage level or current level. It…

Q: The two plates are connected across a 12 V battery of a two flat metallic plates are 0.5 centimeter…

A: given circuit of capacitor

Q: A building supplied by a 230 Vrms source has inductive loads that have an average consumption of…

A:

Q: A straight copper conductor 20 cm long moves across a magnetic field of 10,000 gauss at an angle of…

A:

Q: 5. A single phase full-wave semi-controlled rectifier is used to control a power of 230V, 2kW, DC…

A: In this question we need to find a new heating power output when firing angle is 45°

Q: Measure the V1 V2 and I using ohm's law

A: In this question we need to find a voltage V1 , V2 and current I

Q: Your aunt living in the USA sent an appliance that has impedance equal to 10+ j3 2 at 60 Hz. She…

A: We draw a equivalent circuit diagram of the given system referred to primary side

Q: I = 0.5 A / 0° Χει voo 8 Ω Key 2 Ω Χρη 0000 8 Ω XC₂ 2 Ω R₁ ₁₁ 1 Ω

A:

Q: How It is required to find the midband gain, the upper and lower -3dB (0707 Au) frequencies of the…

A:

Q: (2-3) A series-circuit consist of a foreword biased diode, and tow resistances of 3300 and 4700 are…

A:

Q: digitally modulated carrier if M 8 and channel capacity = 2.7 kHz O 337.5 Hz O 21.6 kHz O 8.1 kHz O…

A:

Q: Q2:- calculate the electrical energy consumed by T.V. (250V) during one Month if this T.V used (3…

A:

Q: I al =↑ + V₂1 1092 ww V

A: The given circuit is as shown below,

Q: D7.2. A current filament carrying 15 A in the a, direction lies along the entire z axis. Find H in…

A:

Q: Consider the RLC circuit shown. The sinusoidal voltage source has a magnitude of IV 1. Answer the…

A: Given is RLC circuit We have to find , a) Voltage gain  expression in terms of ω b) cut off…

Q: A resistor having a resistance of 40 ohms is connected in series with an inductor having an…

A: To find the resonant frequency of the circuit in rad/sec

Q: Find the sine function of: 1. Z = 10 + i

A:

Q: +1 + R VR ĪR + + L V Vs I. IL Consider the RLC circuit shown. The sinusoidal voltage source has a…

A:

Q: Find the Laplace transformation of the following functions: 1. f(t) = t² cos(4t) + 3t4 + 18

A:

Q: c. VCE. d. Vc. For the emitter-bias network , determine: +20 V • 2 ΚΩ 430 ΚΩ 10 με Vi Ε 10 με H β =…

A:

Q: The short-circuit and open-circuit tests were performed high-voltage rating of 7600 volts and…

A:

Q: A multitap transformer has 100 turns on the primary, 100 turns between B and C, 1000 turns between A…

A: Given: Primary turns, N1=100 Turns between BC, NBC=100 Turns between AD, NAD=1000 Turns between AC,…

Q: A tap supplies water at 22 °C. A man takes 1 liter of water per minute at 37 °C from the geyser. The…

A: POWER : The quantity of energy moved or transformed per unit time is referred to as power.. The…

Q: . Find the Branch currents and V₁. ΖΩΣ 10V + ΙΩ τ ΤΩ Α 1.5V Ω

A:

Q: (ii) 111001.112 - 1011.1012 (iv) 10100110.102 by 1002

A: Given data, (ii)111001.112-1011.1012 (iv)10100110.102 by 1002

Q: (26) D7.2. A current filament carrying 15 A in the a, direction lies along the entire z axis. Find H…

A: We need to find out the magnetic field for given current at given point

Q: +1 + R ww VR IR + + Vs VL LV. -I. IL Consider the RLC circuit shown. The sinusoidal voltage source…

A:

Q: Q3:- 1- How much resistance is required to limit the current to 1.5 mA if the potential drop across…

A: We know that  According to ohms law  I =V/R  where  I = current (A) V=voltage(volt) R=resistance…

Q: find Z equivalent if the frequency is 50: R2 R1 R3 ww 552 792 30Ω :3mF Zeq 4mF 2H

A:

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: Thee resistors each has a value of 1k ohm are connected in delta configuration to a three phase…

A:

Q: The operating frequency for UHF RFID is 135 kHz O 2.4 GHz O 13 MHz O 900 MHz O

A:

Q: e. VE. f. VB. g. VBC. For the emitter-bias network, determine: +20 V 430 ΚΩ Vi 10 μF OF 10 kQ2 10 μF…

A:

Q: Need to find the R1 & R2 values for a 2-port network model in a T network attenuator when the…

A:

Q: The power of a heater is 500 W at 800 °C. What will be the power at 200 °C? Temperature coefficient…

A: Given, Temperature, T1=200 °C Power, P200=? Temperature, T2=800 °C Power, P800=500 W Temperature…

Q: 1. R G₂

A:

Q: What would be the magnitude of the induced emf in a conductor of length 2 m moving at a velocity of…

A:

Q: 9. For the following M-ary message, a) What is the value of M? b) Represent the data by binary…

A: Binary values are usually represented by two digits, the digits are 1,0. Where M-ary message M…

Q: Q3: For the following system with T=0.5, T4-0.25, T3=1. determine the range of stability of the…

A: Given data : ζ1=0.5 ζ4=0.25ζ3=1K=k1k2k3

Q: + +1 R ww VR IR + + Vs Ī I. TIL Consider the RLC circuit shown. The sinusoidal voltage source has a…

A:

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

A:

Q: Assume that two hosts are directly connected via a submarine optical fiber cable, which goes from…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.