20 V 15 V LOV. - IOV -15V -20V 125μs 1 ms] t a. Draw in frequency domain the amplitude signal given in the above figure. b. Compute for the carrier power, sideband powers, and total transmitted power, load resistance is 50 ohms c. Compute for peak current of the unmodulated carrier, peak current of the modulated signal, peak voltage of the modulated signal, peak voltage of the unmodulated carrier. Load resistance is 50 ohms

Q: In Fig. 5, R-40 Ohm, L-4 H, and C-1/4 F, calculate the characteristics roots of the circuit. Is the…

A:

Q: (a) Given the circuit in Fig. 14.67, determine the transfer function ( V.W (b) If R = 40 ks2 and C=…

A: The transfer function is defined as the ratio of the Laplace transform of the system's output to the…

Q: (a) Design and implement the give expression from given de voltage Vdc-10v using op-amp.R2=100ohm…

A: An operational amplifier, often abbreviated as op-amp, is a versatile and widely used analog…

Q: For this question :…

A: As given AM circuit shown below,We need to discuss the issue behind the incorrect output.

Q: 1B. A 4 kVA, 200/400 V, 50 Hz, single-phase transformer gave the following test figures: No load…

A: open circuit test (LV side)200V0.7 A70 Wopen circuit test (LV side)15 V10 A80 WAsked to find the…

Q: Q4/ for the system shown below: 1. Change the block diagram to a signal flow graph. 2. by using…

A:

Q: a. Explain with the aid of diagrams, the operation of the circuit with the switch first in position…

A: In the given questions we need to calculate the time required to current drop to its 20 % of initial…

Q: Set up the differential equations with f(t) as input and y1(t) and y2(t) as outputs in the circuit…

A: In this question, we need to determine the differential equations with f(t) as input and y1(t) and…

Q: Please calculate the current i(t), when the external voltage is set to uI(t) = 10 V cos(w t) for the…

A: Given circuit,Supply voltage u1(t) = 10 V cos(w t)U1 = 10 V rmsAsked to find the current I in the…

Q: Explain the construction, working principle and characteristics of Rhombic antenna with  necessary…

A: It is asked to explain the construction, working principle and characteristics of Rhombic antenna…

Q: b) F

A: The power system is given asBefore the fault system will look likeNow, the system parameter is given…

Q: Activity 1: You are examining a series RLC load driven by a 50-Hz, 230-Vac (RMS) source. R= 12 Q2, L…

A: The objective of the question is to analyze a series RLC circuit driven by a 50-Hz, 230-Vac (RMS)…

Q: Answer the following: 1. In AM-DSB-LC, describe the possible values of the modulation index. Which…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: 2) LOMA 1.6 H m tro disw > 20kn SAF After being open for a long time, the switch in the circuit is…

A: The given circuit isThe switch is open for a long time before it has been closed at t = 0.We need to…

Q: Why is the magnetic field vector perpendicular to position vector?

A: The question is asking why the magnetic field vector is always perpendicular to the position vector.…

Q: A 220 V DC machine has an armature resistance of 1 Q. If the full load current is 20 A, what is the…

A: Given data:Required information:

Q: 3.5 Given vectors A = x +ŷ2-23, B = x2 - ŷ4, and Cŷ224, find the following: (a) A and â (b) The…

A: Given Data:The vectors of,To Find:The component of along

Q: For the given figure find (6, 7, and 8) x(S)L (a) Damping ratio = √12 A 12 (S²+45+12) (b) B 2/√12…

A:

Q: What is a radio frequency spectrum? Give major propagation characteristics of VHF and UHF bands.

A: The radio frequency spectrum is a part of the electromagnetic spectrum that is used for wireless…

Q: For the following design, write Verilog code to describe it. Write testbench program to test the…

A:

Q: Example 2 Two coils are connected in series across a voltage supply (V) as shown in the figure…

A:

Q: If the green dots represent not only inputs but also outputs, how many transistors would be required…

A: A MOSFET (Metal-Oxide-Semiconductor Field-Effect Transistor) is a type of transistor commonly used…

Q: 2: It is required to generate de voltage 100KV by using a small(25KV,1KVA) transformer. Name and…

A:

Q: The charges and coordinates of two charged particles held fixed in an xy plane are q₁ = 3.47 μC 92 =…

A: We are given that :The charges and coordinates of two charged particles held fixed in an xy plane…

Q: A transformer supplies load of 360KW at 0.6 p.f lagging. Calculate  The KVAr rating of the loss…

A:

Q: The given Boolean expression X = A.B.C.D+ A. BCD + ABCD + ABCD + ABCD + ABCD + ABCD + ABCD + ABCD +…

A:

Q: Derive the formula for maximum usable frequency and skip distance assuming earth is perfectly flat.

A: The objective of this question is to derive the formula for maximum usable frequency (MUF) and skip…

Q: System type? Steady-state error when the input is 10 u(t)? Steady-state error when the input is 10 t…

A: In the given questions we need to identify the type of system.Also we need to calculate the steady…

Q: 4) In a data transmission Hamming coding is used for drug correction (n=5){(k=2) code word is…

A: In a Hamming code with n=5, k=2, data word is as, We need to determine:i) how many bit error can be…

Q: 2 1 0.8 0.6 04 02 0 0 figure are the magnitude of the transfer function of passive filters. fig 1…

A: in this question, we need to fill the blank. figure of transfer function of the passive system is…

Q: Q1/ Find Laplace Transformation for: 2 1. f(t) = t + sinyt + 3 e 2- f(t) = Sin²t

A:

Q: B-2-1. Simplify the block diagram shown in Figure 2-29 and obtain the closed-loop transfer function…

A: The term "block reduction technique" can refer to a variety of methods in different fields. In…

Q: List the major characteristics of Marconi antenna with necessary figures

A: In the given questions we need to discuss about the Marconi antenna.The Marconi antenna can be draw…

Q: Explain the special features of reflector antenna and discuss on different types of feed used with…

A: It is asked to explain the special features of reflector antenna and discuss on different types of…

Q: Q4/ Find the transfer function C(S)/R(S) for the circuit shown below: Ris) G₁(s) H,(s) Gy(s) Gy(s)…

A:

Q: 210: Given points M(-1, 2, 1), N(3, -3, 0), and P(-2, -3, -4), find RMN ; RMN + RMP .. Evaluate RMN;…

A: Given Data:The points,To Find:The unit vectors for

Q: Create the circuit implementation and truth table for the following Boolean equation: F =…

A: Given function is Asked to find the truth table and logic diagram for the above expression.

Q: B Y IB ly B Y ZB. ZR 19 la Figure 1: Star Balanced Load ZB Zx Unbalanced Load ZR # ZB # Zc ZY

A: In a three-phase power system, the words "balanced load" and "unbalanced load" describe how current…

Q: [Q5A] A 3-phase, 6-pole, 400V, 50Hz, I.M., its rotor winding is star connected, with Rze= 0.1 and…

A:

Q: How did we get sin(25.842) on part a?

A: Power factor is a measure of the efficiency of electrical power utilization in an AC circuit. It is…

Q: How is aperture type of antennas different from the conventional antennas? Explain the theory of…

A: The objective of the question is to understand the difference between aperture type of antennas and…

Q: Describe the construction and operation of a DC Motor. How is speed controlled and can the motor be…

A: Asked to explain the construction of DC motor?Operation of DC motor?Speed control and motor reversal…

Q: 8.59 The Zener regulator shown in Figure P8.59 holds the load voltage at V. = 14 V. Find the range…

A:

Q: Shar esign a ten-stage impulse generator generate a 1.2/200 (usec.) lighting impulse. Assume that…

A:

Q: Using the node voltage equations method for the circuit seen in fig. 1, (a) Write down the nodal…

A:

Q: 2. Given the following analog signal, use delta modulation (DM) to convert the analog signal to…

A: Given:An analog signal x(t), which is being converted to digital signal signal using delta…

Q: Q3/ find the output C(S) of the block diagram shown below : D(s) R(S)+ G1(s) G2(s) G3(s) H1(s) Ha(s)…

A: The given block diagram is shown below.We need to determine the output .

Q: A voltmeter reads 100.5 V. The error taken from an error curve is 5%. Find the true value of the…

A: Given data:Required information:

Q: Solve für Vx. 405 100 +- lov 2 Vü 508. +> 20.1 ✓ Iu + VX

A:

Q: A 220 V (Phase value), 50 Hz, 3-phase, 4-pole, Delta-connection, class B, Induction motor gave the…

A: In this question, we need to determine the stator resistance per phase of the induction motor.

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.