2. What is the rectangular form of (10260°)–(52-45°)? 3. Convert 20sin(6280t-120°) to phasor form (hint: first convert to cosine)

Q: Q3: Calculate voltages between points A,D (V1) and between points B,C (V2) * before and after…

A: VOLTAGE DIVIDER RULE:- in the series circuit, the voltages between the circuit elements are divided…

Q: Table 5.20CC at 800 rpm. Draw occ at 800rpm If EA amperes volts 8 0.3 28 0.5 46 Using the graph,…

A:

Q: cted alongside, the battery has been applied for a long ti

A:

Q: Va O 13V i3 20 2A (4

A:

Q: b) A student sets up an electric circuit like the one shown in Figure Q1(b). i) Describe how a…

A: Given :   Practical current source the student in the laboratory has made the circuit.     The…

Q: For dissipated by R2 I am confused where 225 over 242 is coming from.

A:

Q: If the voltage on pin A3 is 0.806V, what value will analogRead(A3) return from the ADC?

A: Take reference voltage Vref=5V and 10-bit ADC. By using 10bits we can able to represent data  in…

Q: could you please help me with item d please

A: Asked to find (d) The inductor current position with respective to inductor voltage? And what angle…

Q: 1 ΚΩ M R1 120 VAC 13.2 Η L1 Μ 1 ΚΩ R2 60 Hz

A:

Q: 79. Which of the following formulas can be used with Ohm's law to determine the amount of voltage…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Questions: 1. What is the threshold voltage, VTH and minimum current that will turn ON the LEDS?

A: As per our policy i have attempted only one question: LED: The full form of LED is a light-emitting…

Q: What is the ampacity of a #3 AWG Aluminum THWN if there are 3 of them that are considered current…

A: This question requires finding the ampacity of #3 AWG Aluminium THWN with 3 current carrying…

Q: :Find first value (of two). Find second value (of two). :Draw Norton Equivalent with all elements…

A: The sources can be independent and dependent sources. Norton theorem converts a complex circuit into…

Q: What is the box fill volume allowance for conductors that do not leave the box? O depends on number…

A: Here is your answer! I hope this will help you. The correct options are : Option A : depends on…

Q: 3. If voltage of 4160 V (Ep) is applied across primary and 480 V (E.) applied across secondary.…

A: Given Data:An ideal transformer with,Primary voltage Primary current Secondary voltage To Find:The…

Q: (Which of the following statment is FALSE for the switches with Ideal v-i characteristics in the…

A: Given: V-I characteristic of 4 individual switchs

Q: A certain carrier signal is amplitude modulated simultaneously by two sine waves with modulation…

A: We know formula for net modulation index , so we will find out net modulation index. We also know…

Q: Please answer in typing format

A: Wye configurationIn a wye configuration, the three elements are connected in a Y-shaped pattern,…

Q: How can the ammeter range be increased to 1A?

A: In this question we discuss how to increase ammeter range .

Q: 1-33. Given that I,D1 = ID1 = 100 pA. Calculate IDI and VDI. Calculate 15k.

A:

Q: T The match will at 6pm. * kick off kick in get along go on kick about Fertile soil may be by…

A: 1) Option a- kick off  2)  Option e- Get along

Q: Convert the circuit from star Y connection to delta A connection for the following circuit 302 102…

A: Apply the formula for star-delta conversion,

Q: 3. Determine the total impedance and the total current. 400 20/30°V -jsn j30n SA ÚJA

A: The given problem is from circuits. The detailed solution is given in the next steps.

Q: The positive sequence current is Times the current in neutral wire

A: A balanced three-phase system with the same phase sequence as the original sequence is called as the…

Q: 3. Determine P1, P2, and P3 (Powers absorbed) for this circuit. Consider the following cases: a)…

A: Given: Voltage that is responsible for power P1is 8 V Voltage that is responsible for power P3 is…

Q: Find the a parameters for the circuit in (Figure 1). Suppose that R₁ = 0.7 kſ, and R₂ = 40.7 kft.…

A:

Q: Question 22 Complete the table of values for this circuit:

A: For the given circuit the value of voltage, current and power related to all the resistors in the…

Q: 12 15 16 None of the other answers are true

A:

Q: Wb / m2 represents O a. watt O b. Henry O c. Joule O d. Tesla

A: Given, WB/m2 represents=?

Q: ia + 14 - 3kN. 2ia 5 mA( 1kN O A) 2.25 mW O B) 9 mW C) 1 mW D) 0.75 mW

A:

Q: Determine delay angle when system is most efficient.

A: Given R1=20 kΩ R2=0 to 120 kΩ C=0.22 μF Vs =220 V f=60 Hz diac breakdown voltage =18 V

Q: What is the current value of i1 in the circuit given below?

A:

Q: 22 wwww 52 lou Pind I and at 2s2 and 7sr www www Or .

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element…

Q: AREF GND Write a code to blink an LED connected to pin 3 five times with a delay of 500 ms each time…

A: Given the circuit, as shown below:   We need to write a code to blink an LED connected to a pin 3 to…

Q: 18. The melting point of magnesium is 650°C. Express the melting point in (a) °F, (b) °K.

A: given temperature

Q: See the 1k2 R1 1kQ R2 R3 1 k2 100 V R4 1 kQ R5 1 k2

A:

Q: y? didy 2 2Y

A: The above Integration can be solved by using substitution method. The solution is given below.

Q: Question 6 Which of the following is true for a 5-variable Karnaugh map? It does not exist. B It…

A: we need to select correct option regarding 5 variable k-map.

Q: methodology used to know how many people pass through the place where the tiles will be installed…

A: To describe:methodology used to know how many people pass through the place where the tiles will be…

Q: Which of the following statements about the TRIAC is true: O A. None of the other choices are…

A:

Q: What is ohms low

A: Current: It is a flow of electrical charge carriers like electrons. It is time rate of change of…

Q: Find V1(t) O-5 sin (taf + 180°) O-5 cos (car - 10) O 5cos (tar-55") O Scos (Gat + 10) O 5 sin (or +…

A: standard expression for sine wave is                      V(t) = Vm sinwt+θwhere Vm is the peak…

Q: Ql why the out Put For 3 times constant (3T) is not the Same For different cases

A: