2. What is the N, V and M values, draw the diagrams. 4m 3 m G1 4 t/m ↓↓↓↓ 2 m 4t

Q: F₁=250 N 300 A -2 r -3 m F₂ = 300 N 60° 4'm F3 = 500 N

A:

Q: USING DOUBLE INTEGRATION, GET THE MAXIMUM DEFLECTION K₁=25/2 J 8/2 25 8/2 x R₂= 25/2

A: "Since you have posted multiple questions,  I will solve first for you as per guidelines"

Q: Using; a) Double Integration Method, b) Area - Moment c) Conjugate Beam Method Method. Solve for the…

A: Given:Required :Slope and deflection at free end using moment area method

Q: Geotechnical laboratory tests were conducted to determine the liquid limit of soils. The data set…

A: Given Geotechnical laboratory tests conducted data for soil- A using Casagrande's apparatus  and…

Q: The data in the table below is for a closed-polygon traverse. Course Azimuth Length (m) Interior…

A: The data for the closed-polygon traverse ABCDEA is given CourseAzimuthLength (m)Interior…

Q: Situation: A conical pendulum has a length of 50 cm. Its bob of mass 100 g performs a uniform…

A: Length of pendulum is 50 cm Mass of bob is 100 g Radius of circle is 30 cm

Q: Draw the shear force, bending moment, and deflection shape diagram. PLEASE AND THANK YOU

A: Simply supported beam with UDL and point load

Q: What is the terminal velocity (m/s) for a 4g particle which is falling in the water with projected…

A:

Q: ) Water is pumped from a reservoir to a packed tower at a volumetric flow rate of 0.02 m³/s. Water…

A:

Q: An unsupported slope of height 15 m is shown in the figure (not to scale), in which the slope face…

A: An unsupported slope with,

Q: The data in the table below is for a closed-polygon traverse. Balance the traverses by coordinates…

A: Preliminary coordinates are XA= 9500 YB = 11000

Q: A straight wire 15 m long is subjected to tensile stress of 2000 kgf/cm². Elastic modulus is 1.5x106…

A: We have to calculate the temperature change to produce the same elongation

Q: Q- If in a district of area 30 hectare has density of population 300 per hectare and quota for water…

A: Area of district = 30 hectarePopulation = The average rate of sewage produced is =?

Q: Question 6 A road section of ength 2km scale 16 cm on a vertical photograph. The focal ength of the…

A: A road section of length, l = 2 kmVertical photograph scale = 16 cmFocal length, f = 320 mm

Q: A sluice gate across a 2 m wide rectangular channel has water depths of 1 m and 0.4m on the opposite…

A:

Q: Prob 1. The rigid bar below is supported by a pin and two rods and must support a load of 100 kN is…

A: Modulus of elasticity of brass, Cross section of brass, Modulus of elasticity of copper, Cross…

Q: A completely mix process is designed with the following data: Qo = 10000 m³/d, BOD after PST = 150…

A: A complete mix process is designed with the following data-Q0 = 10000 m3/day,BOD after PST = 150…

Q: Q2: Design a one-way slab for the framing plan shown below. Use fe 3ksi and grade 60 16…

A: As per Bartleby's guidelines we are supposed to answer only first three questions.Kindly repost…

Q: The assembly consists of two steel rods and a rigid bar BD. Each rod has a diameter of 2m. If a…

A: F = 1000 Nd = 2 cm or 20 mm

Q: You have been asked to the following set of equations that have been obtained from the structural…

A: To solve the set of linear equations using the Gaussian elimination method, let's rewrite the…

Q: 2) The moments of inertia Iu and L. for the shaded region shown in the figure are given below. Find…

A: Given :Iu = 1500cm4Iv = 1300cm4a = (9+3) = 12cmb = (9+2) = 11cmRequired :Area of shaded region

Q: A 2 cm effective rainfall on the Sweet Water Canal at R-Zero station in Basrah produces 1000 m³ of…

A: Effective rainfall is the part of rainfall which is actually contributing to the runoff.The…

Q: For each structure shown, compute the reactions and draw shear and bending moment diagrams. Indicate…

A: Note:- Since you have posted multiple questions, we will provide the solution only to the first…

Q: 32 in. o 36 in. 40 in. 60 in. D 27 in. If the weight of the crate is 1000 lb. and the crate is held…

A: Weight of crate, Tension in cable AD, To find:           Tension in cable AB and AC.           Angle…

Q: 4. the influence line shown in Fig. 1-4 represents the shear at point B, if concentrated loads (40…

A:

Q: The ruling minimum radius of the horizontal curve of a national highway in plain terrain for a…

A: Velocity (V) = 100 km/hr Super elevation (e) = 0.07 Coefficient of friction (f) = 0.15 Plain…

Q: Complete the table below and determine the total % damage contribution for fatigue and erosion from…

A: To calculate the expected repetitions for fatigue analysis (Se = 0.8 MPa), you can use the following…

Q: A flexible pavement is to be designed to last 10 years. The initial PSI is 4.2 and the TSI (the…

A: Design period = 10 yearsIntial PSI = 4.2Final PSI =2.5Soil resilient modulus, MR = 15,000 lb/in²For…

Q: A vast freshwater swimming pool is constructed on the seashore of New South West Australia, where…

A:

Q: Boundary Layer Theory Question 2: A laminar boundary layer has a velocity distribution given by u/U…

A: A laminar boundary layer has a velocity distribution, The displacement thickness  =?

Q: A 10 cm diameter pipe is to carry water at a Reynolds number of 105. The entrance length required…

A: A pipe carrying water-Diameter of the pipe d = 10 cm=0.10 m,Reynold's number Re = 105To Find-The…

Q: 5) Find the support reactions, and draw M, N, V diagrams of the beam shown in the figure. ↓ P M A P…

A: P = 4 + 9 = 13 kNq = 2 + 9 = 11 kNM11 = 5 kN-ma = 3 mb = 2 m

Q: The radius of a horizontal curve can be determined based on the following criteria (select all that…

A: A horizontal curve in a highway refers to a curved section of roadway that allows for a change in…

Q: Draw the Free Body Diagram for the structure below. 5 kips 3' – 0". 7′ – 0" 14 kips 6′ – 0" L =…

A: To FindFree body diagram

Q: A 60° в 6 m 5t 60° C ToYol

A:

Q: A train connection linking Munich airport and Munich city center needs to be optimized. The ride…

A: The number of stops in between the start point and end point = 11 stopsThe time taken = 41…

Q: I have just gotten a new job as city planner. Your first task is hich statement below is INCORRECT.…

A:

Q: In a horizontally held injection syringe, the piston of 0.2 cm² cross-sectional area is pushed at a…

A: We have to determine the force required to move the piston

Q: Prob 2. The cantilever beam shown in the figure is built into a wall 2 ft thick so that it rests…

A: Point loadX = 6UDLTo find: The reactions at point A and B.The reactions are determined using the…

Q: What is the force in member AB in lbs.? What is the force in member BC in lbs.?

A: Taking the pulley to be frictionless.To determine the force in member AB and BC.To solve for force…

Q: The ruling minimum radius of the horizontal curve of a national highway in plain terrain for a…

A: Speed, V = 100 km/hr.e = 0.07f = 0.15The minimum radius of the horizontal curve of anational highway…

Q: A well stirred tank with a capacity of 500 gal originally contains 200 gal of water with 100lbs of…

A:

Q: Q11: A silty sand of density index (ID or D₁) = 59% was subjected to standard penetration tests at a…

A: Given Data:ID=59%d=3mN=15energy =350 Joulesunit weight = 19.3 kN/m3

Q: Problem 3. A 30 cm pipe is connected by a reducer to a 10 cm pipe. Points 1 and 2 are at the same…

A:

Q: If a rock falls from a height of 35 meters on Earth, the height H (in meters) after x seconds is…

A:

Q: For each structure shown, compute the reactions and draw shear and bending moment diagrams. Indicate…

A: Given:Required :Support reactions,  shear force diagram and bending moment diagram

Q: In the figure above, he, hr, z and the measured slope length L were 1.40 m, 1.55 m, 96∘05'33" and…

A: Reference : Survey Engineering, Distance measured by Total stationRefer above figure ; (mentioned in…

Q: What is the elevation of the low point of a curve that connects a grade of -1.1% to 1.5%, is 587…

A: The stationing of PVC = 55+25The elevation of PVC = 732 ftThe curve length, L = 587 ftThe curve…

Q: A distance AB is observed repeatedly using the same equipment and procedures, and the results, in…

A: A distance AB is observed repeatedly using the same equipment and procedures, and the results, in…

Q: 2. Please estimate the number of cycles to failure of a steel specimen under tensile fatigue loading…

A: Sm = 200 MPaSu = 560 MPa R value = 3