2. The simple beam is subjected to loadings: w= 100 kN/m, F= 500 kN, M= 5000 kN-m. The lengths are: a = 10 m, b = 5 m, Neglect the weight. Replace the loadings by a single resultant force (magnitude and angle), and specify the location of the force measured from point 0. Determine the horizontal and vertical components of reaction at the a) b) supports. M

2. The simple beam is subjected to loadings: w= 100 kN/m, F= 500 kN, M= 5000 kN-m. The lengths are: a = 10 m, b = 5 m, Neglect the weight. Replace the loadings by a single resultant force (magnitude and angle), and specify the location of the force measured from point 0. Determine the horizontal and vertical components of reaction at the a) b) supports. M

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The pin-connected structure consists of two cold-rolled steel [E = 28,000 ksi] bars (1) and a bronze [E = 14,000 ksi] bar (2) that are connected at pin D. Each steel bar has a cross-sectional area of 0.375 in.?. A load of P = 18 kips is applied to the structure at pin D. Using a = 3.2 ft and b = 6.3 ft, calculate the area required for bar (2) so that each bar carries the same force. B (2) (1) (1) b D Answer: A2 = i in.2
Completely solve and box the final answers.
To (a) Find the forsional stiffness of the chanel section Shown, Polov (STIDEES ridots WON (6) consider a structure for which +₁ = 3/4 inch, t₁ = 1/2 inch, 6=4 inches, a = 6 inches and G = 3X107 psi. Determine the angle of twist per unit length when the structure is subjected to a torave of 25,000 1b-ins. C) If the total length of the structure of Part (b) is 6ft, and the shaft is fixes at one end, determine the maximum angle of twist. What is the angle of twist at half-span?
Need right solution. Find : Reaction@ Supports A and B. Here EI constant
The cantilever beam carries a combination of a uniformly distributed load and a trapezoidal loading as shown. Determine the maximumn moment in kN-m. Given: wi = 3 kN/m, w2 = 8 kN/m, a = 3 m, and b = 6 m. Neglect the mass of the beam. w2 kN/m w1 kN/m A BI am b m
B6
A snow load of 3 kPa rests on a roof whose trusses are spaced 3m on center. Find: 1. Determine the magnitude of the equivalent concentrated load acting at point C.2. Determine the force at member BF. Specify if tension or compression.3. Determine the reaction at E
100 mm M 60° B 100 mm 50 mm 50 mm 200 mm The beam is subjected to the internal moment of M = 2.6 kN?m Determine the maximum bending stress developed in the beam.
Determine the forces in members BE and CE of the loaded truss. The forces are positive if in tension, negative if in compression.
Determine the force in member AC using stiffness method. Take A =0.75 in² and E =29 (10³) ksi.
Answer fast and draw diagram.
Determine the support and pin reactions of the beam shown below.