2. Now consider the pulley problem shown below. In this problem, both blocks have mass m m m (a) At the instant shown, the block on the horizontal surface is moving to the right with speed v. At this instant, what is the velocity of the other block? (b) What is the acceleration of the block on the right?

2. Now consider the pulley problem shown below. In this problem, both blocks have mass m m m (a) At the instant shown, the block on the horizontal surface is moving to the right with speed v. At this instant, what is the velocity of the other block? (b) What is the acceleration of the block on the right?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Question 1: Consider the system below. At the moment shown, all three blocks are at zero velocity (Fig.1). At the same time a a force (F) of 10N is applied as shown to the grey Black (G). Each block has a mass of 1Kg. Shortly after the force, F, is applied, calculate the following: A. What is the acceleration of the red Block R, with respect to the ground (assume ground is the inertial frame). B. What is the acceleration of the red Block R, with respect to Block B. C. What is the acceleration of the blue Block B, with respect to the inertial Frame (ground). D. What is the acceleration of the grey Block G, with respect to the inertial Frame (ground). E. What should have been the magnitude of force F, such that block R would not move at all with respect to the ground. B 30° G Figure 1: Three-block setup
In the figure below, the ramp and two objects are located inside the elevator. The elevator moves up with acceleration= a. calculate s.. using the D'Alembert principle. The ramp is fixed.
5.) A man is about to throw a stone by rotating his fully extended arm. If the stone moves at v = 2 due to the motion of his arm, what is the magnitude and vector equation of acceleration in for the stone if the man's arm is 550 mm long?
Note: use g=10 m/s2 In your calculations 1,R Two blocks with masses m and mz are connected by a light string passing over a pulley of radius R and moment of inertia I. The kinetic 1. friction coefficient between the boxes and inclined planes are respectively given by 1 and uz. The system starts from its rest position, and motion sets in the direction of mass m2. (a) Write an expression for the linear acceleration a as a function of the parameters m, m2, Hsr Hz, R, I and inclination angles. (b) For the given system parameters: m1(kg) m2(kg) 01(0) 02(*) I(kg.m²) R(m) 1.5 3.5 45 60 3.0 1.5 Fill in the following table for string tension forces and accelerations corresponding to the given two cases: - Case 1: Inclined planes with kinetic friction coefficients u, = 0.2 and uz = 0.8. - Case 2: Frictionless planes and ignorable mass of the disk. Table 1: Problem 1 (Express your answer in three decimal places) T(N) T2(N) a (m/s²) a (rad/s²) Case-1 Case-2
5 Problem For the pulley system show below. Determine an expression for the velocity VA = SA of the cart A in terms of the velocity VB = Śg of the mass B. Hint: you can lump all constants related to the length of the rope into a single constant k that vanishes when differentiating. SA B SB
Q3/ For the figure shown pin C, is constraine d to move in the circular slot AB of radius r= 70 mm. At t = 0 the pin starts from rest and moves with speed increases at a constant rate of 13 mm/s?. (a)/ the velocity when t= 5 s is : D (b) The total acceleration at t= 5 s is: * (c) the direction of total acceleration is : *
To get a flat, uniform cylindrical satellite spinning at the correct rate, engineers fire four tangential rockets as shown in the figure. If the satellite has a mass of 3200 kg , a radius of 4.9 m , 'and the rockets each add a mass of 240 kg , what is the required steady force of each rocket if the satellite is to reach 30: rpm in 5.5 min , starting from rest? End view of cylindrical satellite
Q2. As shown in the image, a ball is confined to move along the smooth vertical slot due to the counterclockwise rotation of the arm OA. The ball contacts only one side of the slot at any instant. There is no need to solve for any answers for this problem: the goal is to demonstrate the strategy to solve the problem using cylindrical coordinates. On paper, draw the directions of the acceleration of the ball in radial and transverse components. Also, draw the FBD of the ball that shows its weight W, the normal force N exerted by the slot, and the force F from the rod, and write the resultant force components (involving W, N, F, and angle 0) in the radial and transverse directions. The accuracy and quality of the drawings are highly important and points will be taken for low-quality sketches. Take g = 9.81 m/s². Write in the answer space below "see notes". 6=2 rad/s 0.5 m A
You want to move a heavy box with mass 30.0 kg across a carpeted floor. You pull hard on one of the edges of the box at an angle 30∘ above the horizontal with a force of magnitude 240 N, causing the box to move horizontally. The force of friction between the moving box and the floor has magnitude 41.5 N . Find both the x and y components of the acceleration of the box.? What is the box's acceleration just after it begins to move?
Example The bob of a 2-m pendulum describes an are of circle in a vertical plane. If the tension in the cord is 2.5 times the weight of the bob for the position shown, find the velocity and the acceleration of the bob in that position. SOL
Bodies A and B shown in the figure are connected to each other by two ropes. Body b is located on the frictionless surface. Acismi moves down from the stop position at T=0 with a constant acceleration of 100 mm/sec2. t = 2 sec how many mm do Bodies A and B move, respectively? в A Please select one: a.200 mm down, 50 mm right b.200 mm down, 200 mm right c.200 mm down, 800 mm right d. None of them e.200 mm down, 400 mm right
An object moves on a horizontal circular trajectory of radius 20m. Find the net force acting on the object after 5s of motion. Consider that the object starts from rest, moves with a constant angular acceleration of 5rad/s? and has the mass of 50kg.