Concept explainers
2. Jason also makes a home-made power supply to illuminate battery-powered glowing lightsabers.
a. He realized that if he can make a magnet, then he could use it to create the power supply. First, he needs to make the magnet. Jason has a spare loop, and can temporarily borrow a 3 V battery, and an unmagnetized ferromagnetic rod. He can potentially use these materials to magnetize the rod by looping the wire around the rod and hooking the ends of it to the battery to run current through the loop. True or False
b. If he figured out how to create a magnet from a piece of unmagnetized ferromagnetic material, the magnetic moments the rod are:
i. not aligned at all before being magnetized and all aligned after being magnetized
ii. not aligned at all before being magnetized and aligned within grains after being magnetized
iii. aligned within grains before being magnetized and all aligned after being magnetized
c. Jason makes a permanent magnet and wants to figure out how to use it and a
Step by stepSolved in 5 steps
- Question 1: #65 The 10-cm-wide, zero-resistance wire shown in Figure below, is pushed toward the 2.0 Ω resistor at a steady speed of 0.50 m/s. The magnetic field strength is 0.50 T. a. What is the magnitude of the pushing force? b. How much power does the pushing force supply to the wire? c. What are the direction and magnitude of the induced current? d. How much power is dissipated in the resistor?arrow_forward3. Induced Forces: Two conducting coils are arranged parallel to each other. The first coil is connected to a power supply so that the current is in at the top and out at the bottom. The voltage on the power supply is being decreased. a. What is the direction (left/right/zero) of the magnetic field (due to the first coil) as it goes through the 2nd coil? b. Is the magnetic flux increasing or decreasing? c. What is the direction of the induced magnetic field through the 2nd coil required to resist the change in magnetic flux? THK ε d. What is the direction (in at top/out at bottom or out at top/in at bottom) of the induced current in the 2nd coil required to produce the induced field needed? e. What is true of the magnetic force between the two coils? • The coils will attract each other. • The coils will repel each other. • There is no magnetic force between the coils. f. What is the direction of the induced current in the 2nd coil if the voltage of the power supply for the first coil…arrow_forward1. A DC power line for a light-rail system carries 950 A at an angle of 33° to the Earth’s 5.00 × 10-5 T magnetic field. What is the magnitude of the force (in N) on a 125 m section of this line? 2. Consider a 150 turn square loop of wire 15.5 cm on a side that carries a 56 A current in a 1.6 T field. What is the maximum torque on the loop of wire in N⋅m? What is the magnitude of the torque in N⋅m when the angle between the field and the normal to the plane of the loop θ is 14°? 3. Consider two two long, straight, parallel, current-carrying wires, separated by a distance d = 4.5 cm, as shown in the figure. The left wire is directed out of the page with current I1, and the right wire is directed into the page with current I2. The point P is a distance d from both wires, so the wires and the point form an equilateral triangle. If both wires are carrying a current of 3.5 A, what is the magnitude of the magnetic field, in teslas, at point P? If the current from the left wire is 3.5 A…arrow_forward
- A cylindrical solenoid that is 40-cm long generates a uniform magnetic field of strength 1.4 T inside the solenoid when the current is 7.0 A. How many turns of a single coil are present in this solenoid? a. 40,000 turns b. 64,000 turns c. 56,000 turns d. 48,000 turns e. 32,000 turnsarrow_forwardTwo high-current transmission lines carry currents of 45 A and 78 A in the same direction and are suspended parallel to each other 28 cm apart. If the vertical posts supporting these wires divide the lines into straight 16 m segments, what magnetic force does each segment exert on the other? _N. Exponential format with 2 SẺ. QUESTION 14 An induced emf will occur if A. the strength of the magnetic field is changed. B. the coil's area is changed. C. the angle at which the magnetic field and the coil's area meet is changed. D. all of the above.arrow_forwardYou put a magnet inside a coil of wire. Why is there not a current produced in the coil when the magnet is sitting in the wire? Select one: a. The magnet has to be very strong to cause current to flow. b. There has to be motion to cause current to flow. c. The wire has to have low resistance for current to flow. d. The magnetic field inside the coil isn't changing.arrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON