2. Discuss the difference between impedance, admittance and susceptance

Q: Consider the following circuit consisting of an AC generator V-V.sin(et), a capacitor C, an inductor…

A: Given circuit diagram is shown below. Here the AC generator is V=Vosinωt Volts. We need to find the…

Q: A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle…

A: In the question,  Find the source voltage if output current waveform is given.  Duty cycle=50%…

Q: (a) Consider the single-phase AC circuit shown in Figure Q1(a) below. Analyze the circuit by…

A: Given,V=100cos104t=1002∠0° Vω=104 rad/sL=20mHXL=ωL=20×10-3×104=200ΩXc=1ωC=12×10-6×104=50Ω…

Q: 2. What are the differences between MATLAB functions (i) round and floor? (ii) mod and rem (iii)…

A: (i) Round Floor The function of round is used to rounds the number up rely on 2nd argument…

Q: what would happen to the angular delay of Leading Power Factor if we change the capacitor to…

A: The solution is given below

Q: . An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The combination…

A: 6) Given: An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The…

Q: 3. Find the characteristic frequencies of the coupled electric circuits of the figure below.…

A: The circuit diagram is shown below,

Q: Which methods can be used to estimate or calculate the maximum power point on an I-V curve?

A: The maximum power point is the point at which the product of voltage and current is maximum on an…

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

A:

Q: Write the general voltage equation for a 250-Hz source whose peak voltage is 300 V.

A: In this question,  We need to Write the general voltage equation If frequency f=250-Hz source  peak…

Q: Please explain how you got the rms.

A:

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: The solution is given below

Q: ΕΧΑMPLE A single-phase ac voltage controller has a 120-Vrms at 60 Hz, R = 10Q, L = 50 mH, and a=…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac…

A: MPT theorem: This is used to find the maximum power in the load.

Q: The offset voltage describes the dc component of a dc electrical signal. True False

A: Offset voltage (Vos) is defined as the voltage that must be applied to the input to cause the output…

Q: 4. What is ripple factor of the Full-waverectifier? 5. What are the applications of arectifier? 6.…

A: 4.  The ripple factor for a full wave rectifier is= 0.482.

Q: What's RMS and it's average value in AC circuit? Usually which value we measure in AC circuit?

A: RMS: It stands for Root Mean Square. It is a way of expressing an AC quantity of voltage or current…

Q: a) What is the capacitance you would choose for the snubber? b) What is the total power loss of the…

A: Given data is -        RCD  snubber circuit  is -        Stray inductance  = 50 nH…

Q: - (a) Considering pure inductance in an ac cireuit element, show that the alternating current lags…

A: Given  Pure inductance in an accident circuit.

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: Series R, L, and C circuit comprises of the resistor R, inductor L and the capacitor C. Let the…

Q: Q.3 Figure Q.3 shows an AC bridge used to measure an unknown inductance with a known capacitance. C,…

A: (a) In the above bridge, the unknown inductance and the resistance in the same branch is to be…

Q: Lesson: Resistance, Reactance and Impedance  At 50-Hz supply, the impedance of a coil is 25.28…

A: From given impedance value at different frequency we will find out inductance and resistance value…

Q: State the phase difference between voltage and current of an inductor in an AC circuit with one…

A:

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

A:

Q: 1) The AC bridge shown below in the figure has an Z₁ = 10092 + j2009, Z₂ = 600N - j300N, Z3 = 50092…

A:

Q: What is the difference between dc source and ac source

A: AC source or current 1.Electrons in AC keep changing its directions – backward and forward 2. The…

Q: what is a difference between AC AND DC load line

A: Load line- Load line is a line which is drawn in a plot between current and voltage. It denotes the…

Q: The ripple factor for pure dc is Answer:

A: Ripple factor is ratio of ripple voltage to average voltage Ripple factor =ripple voltageaverage…

Q: Note: (please write only words in detail Without plagiarism from the Internet) 5. Explain the phase…

A:

Q: APPLICATION  OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION  OF  IMPEDANCE  AND ADMITTANCE IN AC CIRCUIT .

Q: Q1: For the circuit shown below, determine Re

A:

Q: A two-wire DC splitter of 1Km length and resistance of each conductor (m/00030.0) and feeds the…

A:

Q: ortion issues in a mechatronic system, otherwise known as an Impedance Matching Circuit. Figure…

A:

Q: What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a 480 nF…

A: This is the series RLC circuit and concept of resonance  Use fundamental formulas

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

A: Given data are:       f=400 Hz       R=16 Ohms       L= 0.0119 H       C = 16.6 Micro Farad   The…

Q: Construct a graph to represent the recurring nature of partial discharge pulse sequences under…

A: In general principle, Partial Discharge happens in zones of the protection or on the outside of the…

Q: A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance…

A: Given, a cable has Inductance, L= 0.22 mH Capacitance, C= 0.202 μF

Q: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

A: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

Q: Determine the total equivalent impedance of the circuit as shown. Note: the student must put the…

A: In this question, choose the correct option  All are parallel branches so What is equivalent…

Q: What are the applications of IMPEDANCE and ADMITTANCE OF AN AC CIRCUIT

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For the ac network of Figure Q5, calculate the following; i. The total impedance; ii. The inductance…

A:

Q: Another name for reactive power is?

A:

Q: equation

A:

Q: coil and capacitor are in parallel, with jBL = j0.05 and jBC = j0.03. What is the admittance vector,…

A:

Q: What is the relationship between R, L, and C components in a series AC circuit?

A: The solution is given below

Q: 11. What is the name of this circuit given below? (LSB). B. (MSB) 1507

A: As per BARTLEBY GUIDELINES, I answered one question (Q-11) and repost other question separately.…

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.