2.) A room air conditioner has a coefficient of performance of 2.9 on a hot day and uses 850 W of electrical power. (a) How many joules of heat does the air conditioner remove from the room in one minute? (b) How many joules of heat does the air conditioner deliver to the hot outside air in one minute? (c) Explain why your answers to parts (a) and (b) are not the same.

2.) A room air conditioner has a coefficient of performance of 2.9 on a hot day and uses 850 W of electrical power. (a) How many joules of heat does the air conditioner remove from the room in one minute? (b) How many joules of heat does the air conditioner deliver to the hot outside air in one minute? (c) Explain why your answers to parts (a) and (b) are not the same.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A R-134a home refrigerator operates on a simple cycle at pressures 1.8 bar-abs and 7.5 bar-abs. The refrigerant mass flow-rate is 0.005 kg/s. Fill up Tables 3a and 36. Part 3. Calculation: Performance of a Simple Refrigeration Cycle. Table Ja. Selected Thermodynamic properties of R-134a refrigerant according to the given cycle. kJ/ kg a Specific Enthalpy at suction A Specific volume at suction m/ kg kJ /g-K e Specific entropy at suction d Specific enthalpy at discharge Specific enthalpy after expansion hs4 31 kJ/ kg kJ / kg Table 3b. Performance of the home refrigerator according to its cycle of operation. kWatt a. Evaporator cooling capacity b Condenser heat rejection rate Q Cond kWatt Power required by compressor W Comp C. kWatt d Volume displacement of compressor e. Coefficient of Performance-Ref VCamp Li/s COP Ref f Coefficient of Performance-Canot COP RC & Flash-gas formed after expansion X4 kg / kg %3D
Suppose a heat engine is made out of an ideal diatomic gas taken around a cycle represented by the following PV diagram: B P2 A P1 D V1 V2 Volume (a)Briefly explain why this cycle cannot be used in reverse for refrigeration. (b)Calculate the efficiency of an "ideal" engine operating between the same temperature extremes Pressure
3. A reversible refrigeration cycle operates between cold and hot reservoirs at temperatures TC and TH, respectively. (a) If the coefficient of performance is 3.5 and TC = -40 deg F, determine TH, in deg F. (b) If TC = -30 deg C and TH = 30 deg C, determine the coefficient of performance. (C) If QC = 500 Btu, QH = 800 Btu, and TC = 20 deg F, determine TH, in deg F. (d) If TC = 30 deg Fand TH = 100 deg F, determine the coefficient of performance. (e) If the coefficient of performance is 8.9 and TC = -5 deg C, find TH, in deg C.
5. A refrigerator with tetrafluoroethane as refrigerant operates with an evaporation temperature of 247.15 K (-26°C) and a condensation temperature of 300.15 K (27°C). Saturated liquid refrigerant from the condenser flows through an expansion valve into the evaporator, from which it emerges as saturated vapor. (a) For a cooling rate of 5.275 kW, what is the circulation rate of the refrigerant? (b) By how much would the circulation rate be reduced if the throttle valve were replaced by a turbine in which the refrigerant expands isentropically? (c) Suppose the cycle of (a) is modified by the inclusion of a countercurrent heat exchanger between the condenser and the throttle valve in which heat is transferred to vapor returning from the evaporator. If liquid from the condenser enters the exchanger at 300.15 K (27°C) and if vapor from the evaporator enters the exchanger at 247.15 K (-26°C) and leaves at 294.15 K (21°C), what is the circulation rate of the refrigerant?
A steam power plant operates on the cycle given below. T 3' For the following set of operating conditions, determine the steam rate, the heat-transfer rates in the boiler and condenser, and the thermal efficiency of the plant. (For data, use the steam table.) P = P2 = 7000 kPa; T2 = 550°C; P3 = P4 = 20 kPa; n(turbine) = 0.75; n(pump) = 0.75; power rating = 100000 kW. The steam rate is |kg-s-1. The heat-transfer rate in the boiler is MW. The heat-transfer rate in the condenser is |MW. The thermal efficiency of the plant is
As shown in the figure, an air conditioner operating at steady state maintains a dwelling at 70°F on a day when the outside temperature is 103.5°F. The rate of heat transfer into the dwelling through the walls and roof is 30,000 Btu/h and the net power input to the air conditioner compressor is 3.45 hp. Step 1 B Inside, 70° F Determine the coefficient of performance for the air conditioner. = Evaporator i 30,000 Btu/h Determine the coefficient of performance of the air conditioner. Determine the power input required, in hp, and the coefficient of performance for a reversible air conditioner providing the same cooling effect while operating between the same cold and hot temperatures. Refrigerant loop Compressor Outside Q + Condenser
3.) When a gas surrounded by air is compressed or expands adiabatically, its temperature rises or decreased even though there is no heat input or dissipated to the gas. Where does the energy come from to raise or lower the temperature? 4.) Why must a room air conditioner be placed in a window rather than just set on the floor and plugged in? Why can a refrigerator be set on the floor and plugged in?
Modern (latest) innovation in domestic refrigerators and air conditioners.
Refrigerators and air conditioning systems perform the same function of maintaining cool or cold conditions in an environment. However, refrigerators are place inside while air conditioners are usually placed outside because Question 13 options: refrigerators function better when in a small enclosed space. air conditioners need to release heat to the outside. air conditioners need to use air from the outside to function. refrigerators need to be placed in an environment of constant temperature and pressure.
Refrigeration Engineering. What is the rate of refrigeration in kW of an ideal heat-operated refrigeration cycle that receives the energizing heat at a rate of 1 kW from a solar collector at a temperature of 70 K, perform refrigeration at 15 K, and rejects heat to atmosphere at a temperature of 35 K?
-Gas supply line- Gas A 1.5 m3 tank initially contains a gas at 140 kPa, 340 K. The tank is connected a line carrying same gas at 1400 kPa and 340 K. What should be heat transfer during this process, in kJ, so that the final pressure and temperature are 1400 kPa and 340 K, respectively. (cp=0.72 kJ/kg.K, cv=0.48 kJ/kg.K).
Thermodynamics, Fill in the blank: 1) Which component of an air-source heat pump allows it to be used for both heating in the winter and cooling in the summer? 2) The coefficient of performance of a refrigeration cycle is the ratio of the (______________) effect to the net work input required to achieve that effect. 3) For a Carnot vapor refrigeration cycle, the refrigerant passing through the condenser undergoes a constant (_____________) process. 4) A gas refrigeration application is often used to cool the interior cabin of a(n) (_____________) 5) A property diagram commonly used in analyzing refrigeration systems in which the evaporating and condensing processes appear as horizontal lines is the (____________) diagram.