2. 0.23 kg of gas is taken through a Carnot cycle whose temperature limits are 300 °C and 50 °C. If the volume ratio of the isothermal processes is 2.5:1, determine for the сycle the thermal efficiency (a) (b) (c) Take R= 0.28 kJ/kg K, y = 1.4. the net work done the work ratio [(a) 43.6%; (b) 14.75 kJ; (c) 0.2]

2. 0.23 kg of gas is taken through a Carnot cycle whose temperature limits are 300 °C and 50 °C. If the volume ratio of the isothermal processes is 2.5:1, determine for the сycle the thermal efficiency (a) (b) (c) Take R= 0.28 kJ/kg K, y = 1.4. the net work done the work ratio [(a) 43.6%; (b) 14.75 kJ; (c) 0.2]

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Fast ,Do not hold. Two heat engines receive heat from a source at temperature of 550◦C. Heat engine "A" receives 200 kJ of heat and rejects the waste heat to a sink at 180◦C. Heat engine "B" receives 180 kJ of heat and rejects the waste heat to a sink at 120◦C.(a) Caclualte the generated entropy, Sgen, in both processes.(b) Based on your answer in part (a), identify the heat transfer that is more irreversible.
Air goes through a Brayton cycle gas turbine, entering the compressor at 11 °C and 108 kPa. When it reaches the turbine inlet, the air is at 1,061 °C and 1.23 MPa. What is the net change in specific enthalpy of the working fluid after going through the compressor and heat addition processes? You may assume that the specific heat capacity c, is a constant 1.005 --1. kJ-kg 1.K1 throughout the whole cycle. Give your answer in kJ-kg1 to one decimal place.
(Topic: Carnot cycle) Two and a half kg of an ideal gas with R = 296.9 J/(kg)(K) and cv = 0.7442 KJ/(kg)(K) at a pressure of 827.4 kPa and a temperature of 667 ̊C reject 132.2 kJ of heat at constant pressure. The gas is then expanded according to pV1.25 = C to a point where a constant volume process will bring the gas back to its original state. Determine P3 , QA , and the power in kW for 100 Hz.
Air (Rair = 0.287 ) as an ideal gas flows through the turbine and heat exchanger arrangement kg-K, shown below. Steady-state data are given on the figure. Stray heat transfer and kinetic and potential energy effects can be ignored. Sketch a T - s diagram of processes 1-4 and determine: (a) The entropy production of turbine 1 [3.2 kW /K] (b) The isentropic efficiency of turbine 1 [75%] (c) The exit temperature of turbine 2 if its isentropic efficiency is nr, = 0.85 [960 K] (d) The entropy production within the intermediate heat exchanger [3.2 kW/K] W1 = 10,000 kW Wn= ? Turbine Turbine P3= 4.5 bar T3 = ? T = 1100 K P2=5 bar P4 = 1 bar Air wwww www 2 4 T = 1400 K Pi = 20 bar Ts = 1480 K 5 Ps = 1.35 bar ms = 1200 kg/min Heat exchanger V T = 1200 K P6 =1 bar %3D Air in
Q3//A// In a gas turbine plant compression is carried out in one stage and expansion in one stage turbine. If the maximum temperature (T3K) and minimum temperature (T,K) in the cycle remain constant, show that for maximum work of the plant, the pressure ratio is given by:
COMPLETE SOLUTION. FINAL ANSWER ARE IN ENGLISG SYSTEMS. DRAW A DIAGRAM IF NECESSARY. A gaseous Ammonia actuates a Carnot power cycle in which the respective volumes at the four corners of the cycle, starting at the beginning of the isothermal expansion, are V1 = 12, V2 = 15, V3 = 330.25 and V4 = 264.20. Determine (a) the overall expansion ratio and (b) the thermal efficiency.
1. Calculate the work done for a non-flow quasi-static process represented by P=( -3V + 20 )bar where V is the volume in m3 and chages from 2 to 8 m3. 2.A Carnot cycle operating on a 2 kg of Methane have the following properties given at the beginning of isothermal expansion p=2070 Kpaa , t= 280 deg C .The ratio of isothermal expansion rt = 1.8 isentropic compression rs = 7.2 . Find the net work in KJ
A gas with specific volume v₁ 1 m³/Kg and pressure p₁=6bar in a closed system undergoes a thermodynamic cycle which consists of the following three separate processes: 1->2: Isobaric compression to V₂=0.25 m³/Kg 2->3: Isometric heating. 3->1: Isothermal expansion (pV constant) to the initial volume. - Calculate the specific work produced by the gas per cycle. Present your answer in kJ/kg. =
The first step of a thermodynamic cycle is an isobaric process with increasing volume. The second is an isochoric process, with decreasing pressure. The last step may be either an isothermal or adiabatic process, ending at the starting point of the isobaric process. Sketch a graph of these two possibilities, and comment on which will have greater net work per cycle.
An electric resistance heater submerged in 4-kg water (T, = 20 °C, C, = 4.18 kJ/kg.K) is turned on and kept ON for 15 minutes. During the process 300 kJ of heat is lost from the water and final temperature reached was 48 °C. What is the change in entropy "AS" (in kJ/ K)? Select one: O 1.6875 O 1.2105 O 2.1397 O 1.0128 O 1.8356 O 1.5260
In a cycle, a 4kg ideal gas(MW=3g/mol and k=2.3) confined in a controlled mass system went through three processes.the gas was started at 20kPa and 310K in the first process, and it was isometrically increased by 30kPa. The gas subject to 400Kusing a process defined by PV^3=C.It returns to its original state polytropically.Calculate the entropy change for each process.
Show the COMPLETE SOLUTIONS including the derivation of formula and interpolations/extrapolations: NO Calculator Technique and Applications. 1. Steam at 228 °C and with a specific entropy of 6.1351. undergoes a poly tropic kg-K process with n=1.81 until the pressure becomes 7.98 MPa (a) what is the final temperature of the stem? (B) What is the work and the process? 2. 5kg of steam has an initial enthalpy of 2711.5 kJ at 0.222 MPa. Isentropic compression gives a final pressure of 0.29 MPa. Find (a) the initial and final temperatures and (b) the work of a steady and nonflow processes?