2 kN B 2 m C D 2 m 2 m As 4 kN G 3 m F E

Q: State the depth of improvement ?

A: Soil engineering improves techniques to enhance the soil or ground. Vibro- compaction could be a…

Q: What kind of documentation should be done by the field personnel?

A: Few accurate notes were maintained, and all of the contractor 's correspondence was informal in…

Q: Why is cordless landline more convenient for a small construction site?

A: For small construction sites, where the site area is small, cordless landline is most effective…

Q: Where does PMBOK sit within TOGAF?

A:

Q: AZ Prose #3 डा S 하다 10 HWGE 10' IL Mc RA RB

A:

Q: Glven the technical description of a certain lot, complete the tables below: DIST 29.732 LINE AB BC…

A:

Q: Is the land-to-building ratio and parking relative to market standards? O No, there is a deficiency…

A: The developer wants to build a 100,000-square-foot (GBA) anchored center and has an option on an…

Q: Indicate the total project duration and Critical Path.

A:

Q: Define the applicability of check level on construction site?

A: Answer:- Level :- A level is an optical instrument used to establish or verify points in the same…

Q: missing value

A:

Q: The weights of the two boxes are W₁ = 50 lb and W₂ = 50 lb. The coefficients of friction between the…

A:

Q: Define Lateral Capacity

A: Lateral capacity:

Q: Draw figures to show N60E, S15E and S30W .

A: The figure showing N60E is given below.

Q: The parents want to subdivide their inner lot into two equal area for their two sons such that the…

A:

Q: Question 1 A draw schedule is typically proposed by a contractor. O True False

A:

Q: What instructions are given to the field personnel?

A: - Field personnel is a position of an employee who need to work at non office place, mostly at work…

Q: Define the assumptions of Boussinesq Equtions?

A: This equation is to predict the amount of stress over the material. It predicted the stresses in an…

Q: hat exactly is meant when the term "scope" is used?

A: The term "scope" describes the total set of goals and demands necessary to finish a project.

Q: Define the By Bowle's method ?

A: Joseph bowle presented a method/Formula to Determine Modulus of Subgrade Reaction .The Mehod is…

Q: Give atleast 5 hazardous structures/facilities

A: The top ten risks and the various hazards from the working on construction sites are as follows…

Q: What is the use of the Line of Balance Chart?

A: A line of balance chart can be defined as it is a graphical explanation of the schedule of projects,…

Q: Explain what is Morganstern Charts for Rapid Drawdown?

A: The introduction to Morganstern's stability charts for earth slopes during rapid draw down is as…

Q: Explain the term as drawdown curve.

A: In the given question explanation about drawdown curve has been asked. The explanation about the…

Q: Define Earth surcharge loads

A: Surcharge can simply be defined as additional or in extra.

Q: How many separate fields should be included in a single RFI, and what are their purposes

A: This question is related to the Building design and drawing from civil engineering.

Q: Define Settlement loads

A: A settlement is the ground's downward movement whenever a load applied to it.

Q: ftware Orcad cadence in detail?

A: A schematic editor (Capture), an analog/mixed-signal circuit simulator (PSpice), and a PCB board…

Q: I x,0= 10 " I yo = r x,0 = 4"X6"X ½" r yo = 12" 4"X 8"X 1" | 1" 12 "

A:

Q: What is the PreProposal meeting?

A: Pre-proposal meetins:

Q: Give any one reason for the weakness of an Inspector?

A: Construction Inspector has a very crucial role in the Project. He has to check each and every thing…

Q: PROBLEMS, DETERMINE To ALL FOR AFD, SFD, THE AND BMD MAKING SURE SHOW AU WORK REQUIRED To OBTAIN…

A: We will find reactions at A and D and draw FBD to solve

Q: Draw the precedence diagram for the following project (The network that represents the project).…

A: Answer:-

Q: Define the uses of Bore log report ?

A: Soil boring: In the geotechnical investigation, soil boring is the practice that is used to…

Q: “Solve for the support reactions and draw and label the SFD and BMD

A: Calculating support reactions:

Q: Which of the following does not represent an activity?

A: Answer is option a. Site located

Q: Define the term Underabsorption of Over-Head?

A: Let’s first understand the definition of overhead: Overhead refers to the continuing business…

Q: What is S-curve scheduling?

A: To define the S-curve scheduling we need to understand the S-curve. An S-curve could be a…

Q: Techniques

A: The single sideband technique is a technique which is used for transmitting information like an…

Q: build the sequence to be followed for preparing estimate of project work for 3 ph load

A: Estimate- It is a detailed document that provides information regarding the total expected cost of…

Q: Wht is design requirements

A: Whatever requirements that somehow a designer should usually have to follow while establishing the…

Q: Question 5 of 20 2 FOmu An aluminum tube of outer diameter R, = 50 mm is heated such that it is…

A:

Q: e differenc batween the apartment and cilla hous

A: A structure with roof and wall supporting roof is known as a building.

Q: What is NPSH ? What is the difference NPSH available and NPSH required

A: This question is from Fluid Mechanics and Hydraulic Machines.

Q: What do you mean by Antistripping agents ?

A: Antistripping (not comparable) (not comparable) preventing asphalt from peeling away from the…

Q: A circle of diameter d = 200 mm is engraved on a brass plate (see Figure 2). The plate has…

A:

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land.  Zoning is done or can be understood with the help of a site plan.