(2) (b) (c) R₁ R₂ ειναι ενα | 560 Ω 220 Ω R₁ να • 27 ΚΩ R₂ 56 ΚΩ Send message R₁ Μ 1.5 ΚΩ R₂ Μ 2.2 ΚΩ

Q: What is Vo for this circuit?

A:

Q: 32. For the circuit in Figure 5-63, draw the wave forms at the numbered points in the proper rela-…

A:

Q: +20 V 6.8Q 30 LO 6.8 k 30 ka 0.5pF 0.5 F B-150 B-150 S 15 kG 50 uF 15 kG 50HF

A:

Q: The oscilloscope outputs are asymmetrical and in voltage, and we connect them in parallel in the…

A: An oscilloscope is a device which is used to measures and displays the requires output (mostly in…

Q: For the following circuit, Vsrc=1.5 V and Rload=225 Q. What is the power dissipated in Rload? Is…

A:

Q: For the following circuits, solve for the values as indicated. Round your answers to the nearest…

A: here we have to find the Total Resistance.

Q: V, V2=

A:

Q: 4. A peak voltage of 150 V is measured with a handheld meter. What is the peak to peak voltage? 150…

A: The solution is given below

Q: A 12 V potential difference is applied across a series combination of four 6 Q resistors. The…

A: Given: Four resistors each of resistance 6 Ω is connected in series. Potential difference V=12 V

Q: 3) When two resistors RA and Rg are connected in series, the total resistance is 360. when connected…

A:

Q: The merging of a free electron and hole is called recombination bonding charge balancing none of…

A:

Q: In the electrodynomometer (Wattmeter), a high value resistance is connected in Parallel with the…

A: In electro dynamo meter type watt meter there are two coils , fixed coil and moving coil. Fixed coil…

Q: B. Use this graphic for questions 3, 4, and 5. ТОР 11 V2 0.03A 9V R5 4kQ R6 >2kQ R4 2kQ R7 5000…

A:

Q: Calculate equivalent inductance of the circuit if N number of inductances are connected in (a)…

A: In the question,  Calculate equivalent inductance of the circuit if N number of inductances are…

Q: B-6–7. Plot the root loci for the system shown in Figure 6–100. Determine the range of gain K for…

A:

Q: alculate the value two resistan which when connected in series give 50 and 8 when in parallel

A: let two resistors are x and y. So equivalent resistance when connected in parallel is xyx+y and when…

Q: Q6 In following circuit a resistor of 10k Q and inductor 2 mH is connected across 240 V and 50HZ…

A: Given data: R= 10 KΩ= 10×103ΩL=2 mHV =240 Vf= 50 Hz

Q: 53. Find RT in Figure 5-87. FIGURE 5-87 R₂ 12 V www <-5.6 Mn R₁ 4.8 V Ry P = 21.5 μW +6

A: Given circuit:Asked to find the total resistance RT =?

Q: 1-) I 4+7 i solve the complex number 2.) 5+ 3i transform to rtan dard Form

A:

Q: Determine the output voltage of the unbalanced bridge in Figure 6-81 for a temperature of 65°C. The…

A:

Q: Combination of resistor and capacitor in series forms a                  circuit.

A: If a series combination of resistor and capacitor is connected across a switch then it is known as a…

Q: I need answer for part d

A: given

Q: Determine the signal voltage at the base of Figure 6-13 if the source resistance is 750 and another…

A:

Q: 5. In a 10 V source a 2F and 1F capacitors are connected in parallel. If the voltage across 2F is 10…

A: To solve above problem, one should know how to find equivalent capacitance for series and parallel…

Q: 22. A 7-segment decoder/driver drives the display in Figure 6–78. If the waveforms are applied as…

A:

Q: :10.2 8.23 3.2 V +,

A: Since 6Ω and 3Ω are in parallel their voltage will be same and current in them is given as:…

Q: Capacitive Comparison Bridge and inductive Comparison Bridge

A: Capacitance Comparison Bridge Ratio arms R1, R2 are resistive.   C3 is in series with R3 Cx is the…

Q: to generate high power, the solar cell must be connected in None of the above 1 series and Parallel…

A: We need to answer to generate high power what will be the arrangement of the solar cells.

Q: draw a simple three reisistor series voltage divider that provides equal voltage division of a 180…

A:

Q: In an A.C. circuit, the true power can be measured directly by means of

A: True power is also called Average power of the circuit.

Q: +5 V 1.0 kl Vin 0V 1.0 kN -5 V Figure 4

A:

Q: A DC source has an open circuit voltage of 30 V and an internal resistance of 1.5 ohm. A resistive…

A: Given, A dc source has open circuit voltage, Vs=Vth=30 V Internal resistance, Rs=1.5 Ω

Q: For the circuit to the right, what is value of the voltage v? a 1,57 b) IN c) d) N e) None of the…

A:

Q: 1 = R, V,

A: The given circuit diagram in the question is as follows.

Q: In bridges, under balanced condition current flows through the galvanometer(detector).

A: Consider the bridge and galvanometer (G)connection shown in the following figure.

Q: Determine the unknown voltage drop, 5, in Figure 5-35. FIGURE S-35 12 V 50 %23:

A: Consider the given circuit diagram. Given that: VS1 = 50 V  VS2  = 15 V  V1 = 12 V  V2 = 6 V  V3 = ?…

Q: 22. A 7-segment decoder/driver drives the display in Figure 6-78. If the waveforms are applied as…

A: Here truth table for BCD to seven segment display ,

Q: Example #1 When the system shown in Figure 5-56(a) is subjected to a unit-step input, the system…

A:

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.