17.86 A 65-lb uniform circular plate of radius r is supported by a ball- and-socket joint at point A and is at rest in the vertical xy plane when a bul- let weighing 0.03 lb is fired with the velocity vo = -(700 ft/s)k and hits the 28 in., determine (a) the plate at point C. Knowing that r= 16 in. and h angular velocity of the plate immediately after the bullet becomes embed- ded. (b) the impulsive reaction at point A, assuming that the bullet becomes embedded in 1.1 ms. Fig. P17.86 C

17.86 A 65-lb uniform circular plate of radius r is supported by a ball- and-socket joint at point A and is at rest in the vertical xy plane when a bul- let weighing 0.03 lb is fired with the velocity vo = -(700 ft/s)k and hits the 28 in., determine (a) the plate at point C. Knowing that r= 16 in. and h angular velocity of the plate immediately after the bullet becomes embed- ded. (b) the impulsive reaction at point A, assuming that the bullet becomes embedded in 1.1 ms. Fig. P17.86 C

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

PROBLEM 3.4 A projectile is fired with a muzzle velocity of 250 m/s from a gun aimed upward at an angle of 20° with the horizontal, from the top of a building 40m high above a level ground. With what velocity will it hit the ground in m/s? 241.56 m/s 271.56 m/s 5. c. 251.56 m/s d. 261.56 m/s а. b.
Members ABC has a mass of 2.4 kg and is attached to a pin support at B. An 800-g sphere D strikes the end of member ABC with a vertical velocity v1 of 3 m/s. Knowing that L = 750 mm and that the coefficient of restitution between the sphere and member ABC is 0.5, determine immediately after the impact (a) the angular velocity of member ABC (b) the velocity of the sphere.
1. Derive the equation of projectile motion for the maximum range of the projectile fired at an angle equal to 90 deg.
A 45-g bullet is fired with a velocity of 400 m/s at 0 = 30° into a 9-kg square panel of side b = 200 mm. Knowing that h = 150 mm and that the panel is initially at rest, determine (a) the velocity of the center of the panel immediately after the bullet becomes embedded, (b) the impulsive reaction at A, assuming that the bullet becomes embedded in 2 ms.
A 2-kg solid sphere of radius r 40 mm is dropped from a height h 210 mm and lands on a uniform slender plank AB of mass 4 kg and length L 500 mm which is held by two inextensible cords. Knowing that the impact is perfectly plastic and that the sphere remains attached to the plank at a distance a 40 mm from the left end, determine the velocity of the sphere immediately after impact. Neglect the thickness of the plank 30 30 B. The velocity of the sphere immediately after Impact is m/s
Determine the height h at which the bullet of Prob. 17.108 should be fired (a) if the disk is to roll without sliding immediately after impact, (b) if the disk is to slide without rolling immediately after impact.
L B A bullet weighing 0.5 kg is fired with a horizontal velocity of 650 m/s into the lower end of a slender 7 kg bar of length L=0.90 m. Knowing that h=0.4 m and that the bar is initially at rest, determine (a) the angular velocity of the bar immediately after the bullet becomes embedded, (b) the impulsive reaction at C, assuming that the bullet becomes embedded in 0.001 s.
The ABC bar has a mass of 2.4 kg and is connected to a support on B. An 800 g D sphere reaches the end A of the bar with a vertical velocity v1 of 3 m / s. Knowing that L = 750 mm and that the coefficient of refund between the sphere and the ABC bar is equal to 0.5, determine immediately after the shock, the angular velocity of the ABC bar and the velocity of the sphere.
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Two spheres A and B (of mass m each) were fired vertically from the ground with different initial velocities at different times. When sphere A reached its summit, sphere B, with an upward velocity of 10.76 m/s, created a head-on collision with A. The impact caused sphere A to break into two pieces, each of mass m/2. Knowing one-piece reached Point C and the other piece reached point D after the collision, determine: (a) the velocity of sphere B after the collision; (b) the angle θ and the speeds of the two pieces after the collision; and (c) the force exerted by sphere A on B if the collision occurred in 0.001s.
A 45 g bullet is fired with a velocity of 400 m/s at an angle ø = 5 ° into a square panel whose sides measure b = 200 mm and has a mass of 9 kg. Knowing that h = 150 mm and that the panel is initially at rest, determine a) The distance h required if the horizontal component of the impulse reaction at A is to be zero. b) The corresponding velocity of the center of the panel immediately after the bullet is embedded. Please include the free body diagram if necessary
14 in. 18 in. VB 1500 ft/s -18 in. A 0.05-lb bullet is fired into the side of a 20-lb square panel which is initially at rest. Determine a) the angular velocity of the panel immediately after the bullet becomes embedded and b) the impulsive reaction at A, assuming that the bullet becomes embedded in 0.0006 s. B
ww. E L d Vo В A bullet weighing 0.08 lb is fired with a horizontal velocity of 1800 ft/s into the lower end of a slender 15-lb bar of length L = 30 in. The slender bar is attached at E to an initially unstretched spring of constant k= 40 lb/ft as shown. Knowing that h=10 in and d= 25in. and that the bar is initially at rest. Using the impulse - Momentum principle, determine: %3D (a) the angular velocity of the bar immediately after the bullet becomes embedded. (b) the impulsive reaction at C Assuming that the bullet becomes embedded in 0.001s and the stretch distance of the spring is 2 in immediately after impact of the bullet.