16.) Calculate the inductance or capacitance in series for the impedance 60240° ohms. Assume the frequency to be 50 Hz. Express in four decimal places.

Q: ne the overall gain, V/V₁ of the circuit shown What value of V₂ will result in V = 150 mV? e details…

A:

Q: * As BJT transistor property is that the small emitter current control the much larger collector…

A:

Q: You look at an AM signal with an oscilloscope and see that the maximum Vpp is 100 volts and the…

A: For an AM signal with an oscilloscope Given : Vppmax=100 VoltsVppmin=25 Volts calculation of…

Q: A balanced delta-connected load with impedance per phase of 30/30 is connected to an abc-sequence…

A:

Q: Q1) Find lo using current division Show work clearly Q2) Find RAB in the circuit given? 6 ΚΩ 12 mA A…

A:

Q: if an input signal ranges from 20-40 UA * (microamps), with an output signal ranging from .5-1.5 mA…

A:

Q: The maximum power dissipation of a transistor is 100mW. If VCE = 20V, what is the maximum collector…

A: Given, Pdmax = 100 mW VCE = 20 V

Q: Assembly language: O is easier to program in than high-level languages. O All of these are correct.…

A:

Q: Using Nodal Analysis, solve for the values of the voltages VÃ and V. 2 A 5Ω 3Ω Va ww V₂ 4Ω 6 A 12 V…

A:

Q: 3. The figure below displays a three-phase delta-connected motor load which is connected to a line…

A: Delta connection is used in a electrical system . In delta connection three element in a triangle .…

Q: The Laplace transform of f(t) = sin() is: Select one: O F(s) = 2 (28)²+1 O F(s) = 2+1 28 O F(s) =…

A:

Q: The main element of AM peak detector is: Select your answer. BJT Op-amp Diode FET

A: The give problem is from Amplitude modulation The solution is given in the next step

Q: Show the graph Three unbalanced DELTA connected loads are connected across a balanced source of 220…

A:

Q: 2. If A = 2x²,-3yz, xz² and p = 2z - x³y. Evaluate A. Vo and Ax Vo at the point (1, -1, 1).

A:

Q: Find the Transfer Function of the system modeled by the following diff dy(t) d³y(t) dt3 +3- d²y(t)…

A:

Q: There are two basic types of radio receivers: coherent and noncoherent. The difference between the…

A: Option- 3 is correct

Q: mathematically functioning of gate is given as Z = X.Y *

A:

Q: Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the…

A:

Q: For the circuit sown, using the transistor values of: B = 200, Ic = 4mA and lb = 20uA, find the…

A: The given circuit diagram is a transistor switching circuit.based on the value of input the relay…

Q: A coil of resistance 20 02 & inductance 0.2 H is connected in series with 100µF capacitor across a…

A:

Q: The piezoelectric effect is demonstrated by ceramic filters built of lead zirconate- titanate.…

A: According to the question, we need to choose the correct option The piezoelectric effect is…

Q: What is the use of DC-DC boost module 0.9-5v to 5v? How does it work?

A: A DC-DC boost converter module (boost converter) is a DC-DC power converter module that boosts…

Q: 4.) A voltage v = 220 sin (110t + TT/2) is applied to an inductor rated 40 mH. Find the r.m.s. value…

A:

Q: For the circuit of Figure 24–48, if Iab = 10 A ∠21°, determine all the line voltages.

A: In this question we need to find a line voltage of the given three phase system

Q: Find the Transfer Function of the system modeled by the following diffe dy(t) d³y(t) dt3 +3- d²y(t)…

A: Given: Differential equation d3ytdt3+3d2ytdt2+2dytdt=d2xtdt2+3xt

Q: Which is a unit of power? a. kWh b. W/s c. A×W d. J/s

A:

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: It is given that: Va=380 3∠0°V=VRNVb=380 3∠120°V=VYNVc=380…

Q: a) Calculate resonant frequency  b) Calculate system Q c) Calculate bandwidth d) Calculate the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: use nodal analysis to find the Ix

A: The required parameters can be calculated by taking three unknown nodes and one reference node. The…

Q: A 10-KVA, 2400/240-V. 10 transformer has the following resistances and reactances: Rp = 3 2. Xp = 15…

A: A transformer is a machine that is used to step up and step down the voltage level while keeping the…

Q: You have been asked to design an intruder alarm circuit using logic gates. Compare TTL and CMOS…

A: Intoduction - TTL technologies - TTL is an abbreviation for Transistor-Transistor Logic. Every logic…

Q: The full-load copper losses and iron losses of a transformer are 6400 W and 5000 W respectively. The…

A: Given, Full load copper loss, Pcufl=6400 W Full load Iron loss, Pifl=5000 W Load factor at half…

Q: What is the range of the upper sideband of an amplitude modulated signal whose carrier is 2.5 MHz…

A: The sideband of a signal is described as the spectral component produced after the modulation of a…

Q: 9.26. Draw the schematic of a four-input ECL NOR gate. 9.27. Draw the schematic of a five-input ECL…

A: Logic Gate:  A logic gate is a virtual or physical device that performs a Boolean function, which is…

Q: A superheterodyne receiver has an IF of 455 kHz,

A: Frequency modulation-When modulation is done by taking frequency of information signal modulated and…

Q: (₂ X(s) For the given system, find: 1- Transfer function H(s). 2- Differential equation. -2t 3-The…

A:

Q: Item #: TLO #: Points: 1 TLO 12 A balanced delta-connected load with impedance per phase of 30/30⁰…

A: Since the given system is balanced we can analysis the system on per phase basis.

Q: 1. Determine the value of R, that will establish maximum power conditions for the Zener Diode. At…

A: In this question,  We need to determine the value of resistance RL  if power dissipate in the zener…

Q: • Choose the correct answer for the power of element 2 and identify if the power is consumed or…

A: Power consumed: If any element has current and the current is entering at the positive terminal of…

Q: With a PNP circuit, the most positive voltage is probably: O ground VC VBE VCC

A:

Q: 7.) The figure below shows a series-parallel circuit. Compute for the angle of the total circuit…

A:

Q: Q2/ Find the state-space representation of the electrical network shown in Figure 3.8. The output is…

A: State Space Representation:  A state-space representation is a mathematical model of a physical…

Q: For the circuit below, find the forced response for væ(t) assuming that the indepen- = = 2…

A: Solution is as follows using Nodal Analysis

Q: Find the Transfer Function of the system modeled by the following differential equation: dy(t)…

A:

Q: In this analog amplifier the input is in phase with the output.

A:

Q: An electron travelling at a speed of 105 ms 1 approaches perpendicularly a long wire in which a…

A:

Q: What are the similarities and differences between a diode and a silicon controlled rectifier? You…

A:

Q: Point charges q₁ = +2.00 μC and q2 = -2.00 μC are placed at adjacent corners of a square for which…

A: The SI unit of electric potential energy is joules per coulomb. It is the measure of magnitude of…

Q: The effective resistance seen looking into the primary of a 15 : 1 transformer connected to an 8 Ω…

A: Given: Load resistance, RL=8 Ω Turns ratio, a=N1N2=151

Q: 12.) A voltage v = 220 sin (110t + π/2) is applied to a resistor of 45 ohms. Find the r.m.s. value…

A: We need to find out RMS value of current