15-19. Using the corrected/adjusted latitudes and departures below. Determine the coordinates of the points if the Northings and Eastings on point 1 are 991422.35 meters, 785547.11 meters, respectively. Dep (m) -185.48 Lat (m) -321.18 LINE 1-2 2-3 165.75 172.97 -153.24 -44.08 3-4 0.29 4-1 364.97

Q: 4- Find the Adjusted Coordinates of points B.C.D, and E

A: First we need to find the Latitudes and Departures following which the co-ordinates can be found…

Q: Explain the dynamic cone penetrometer concept?

A: - A dynamic cone penetrometer test (DCPT) is a rapid and economical test to determine underlying…

Q: What does inclinometer can be used to monitor?

A: Inclinometer:

Q: Elevation is same as R.L. O Н. С.Р. * T.P. has Both F.S B.S.

A:

Q: Steps that could help make surveying fieldwork easier (closed compass traverse)

A: Field work     Field work is used in almost all the types of surveys so it is important learn tips…

Q: The elevation of points O and a is 267ft, that of point is B and C is 52 4ft and that of D is 820ft…

A: The scale is defined as the ratio of the distance on the map to the distance on the ground.  Scale…

Q: A section line AB appears to be 10.16 cm on a photograph for which the focal length is 16 cm. The…

A: Length of a line on a map = 2.54 cm Scale = 1/50000 Actual length on a ground = 50000 * 2.54 cm…

Q: Subject : Fundamentals of surveying Question: A reference line along which the magnetic declination…

A: Answer: Agonic line   More Explanation is in next step.

Q: Q4/ Points A and B are at elevation 400 m and 200m above datum respectively. photographic…

A: Given                Elevation of point A (ha)  - 400m                Elevation of point B (hb)…

Q: What are the methods that are involved in n observing angles or directions of traverse lines?

A: Angles can be measured more accurately than distances. This requires that you always measure the…

Q: Question 1 Table1 shows the summary of a closed loop traverse carried out in campus by a group of…

A: To Determine :- a) the linear misclosure b) the coordinates of stations 2, 3, 4, 5, 6, 7, 8, and 9

Q: Differentiate between the following: (i) (ii) (iii) Plane Surveying and Geodetic Surveying Obstacle…

A:

Q: What type of survey is of vast extent and considers the earth's spherical shape? a. plane surveying…

A: The given statment is: The survey is of vast extent and considers the earth's spherical shape. To…

Q: B- What the deference between particle imaging velocimetry and laser doppler velocimetry with…

A:

Q: Examples of indirect measurement in surveyin

A: Solution: Indirect measurement is basically the method in which proportions are used in order to…

Q: Define application of gps,totalstation and levelling in water resources engineering

A: Applications of GPS in water resource engineering are as follows: 1. Water Resource Management. 2.…

Q: A line of sight taken to any point to determine its elevation is called:

A: Bench Mark is a point of known elevation . All elevation to be measured by taking refrence from…

Q: Why are external focusing telescopes used?

A: Throughout the wider definition, a tacheometer is a movement theodolite consists of a stadia…

Q: Differentiate between the following. a. Profile leveling and cross sectioning (with the help of…

A: Difference between  a) Profile levelling and cross sectioning will be  Profile levelling Among the…

Q: Kindly answer this, this is in the surveying subject. Thankyou in advance have a nice day! (your…

A: BENCH MARK: For developing a topographic or contour map, the details and data collected by the…

Q: What is the classification of Cone penetrometer?

A: - Cone Penetrometer Test (CPT) is a type of test used to determine engineering parameters of soil…

Q: The total station instrument requires a barcoded staff to allow measurements. O a False O b. True

A: The total station instrument requires a barcoded staff to allow measurements. Given Statement is…

Q: The elevation of points L is 260ft, that of point is k is 300ft and point M is 800ft, that of point…

A:

Q: Question-. The vertical photograph was exposed with a 50 cm focal length camera at a flying height…

A: Given data- Focal length f=50 cm = 0.50 m, Flying height H=5000 m, Photo scale S=1:2500, To Find-…

Q: Thefundamental principle of surveying is to work from the (a) whole to the part (b) part to the…

A: Surveying is art of determining the relative position of a particular with respect to datum with…

Q: write about close levelling surveying: 1- Introduction and object. 2-procedures  3-discussion .

A: Close leveling surveying- 1. Introduction and object- The objective of leveling is to determine,…

Q: Explaining nouns: (a) elevation difference (b) mid-sight (c) standard point

A: Surveying is generally the activities that involved in the planning and execution of surveys for the…

Q: Hn plane surveying (a) the curvature of the earth is taken into consideration (b) the curvature of…

A: To Determine The Definition of the given type of surveying (Plane surveying).

Q: Briefly describe how a GPS receiver determines its location.

A: GPS means Global positioning system

Q: * Plus Sight is called also as I.S. O B.S. O F.S. O * F.S. is also called Station point O…

A:

Q: Subject: Fundamentals of surveying Question: It is a fixed line of reference which lies parallel…

A:

Q: Q1) a) Define the following terms:- (1) Image: (2) High oblique acrial photo; (3) Topographic map;…

A: Image: An image is a visual representation of something which maybe a photo or any data.   High…

Q: MAKE AN ORIGINAL PROBLEM SOLVING (QUESTION AND SOLUTION) REGARDING TRAVERSE SURVEY IN THE…

A: Traverse survey: - It is a method of survey in which place a survey station along a path of…

Q: BACKSIGHT FORESIGHT DE im) ELEVATION (m) STA RR (m) VD (m) RR (m) VD (m) (m) (m) BM- I01.245-4° 25'…

A:

Q: How to enclose a close traverse? -What is traversing in surveying and what is the importance of…

A: It has been asked in the question that how to enclose a close traverse and What is traversing in…

Q: When conducting traverse surveys, what are the two laws that are often used to correct the…

A: A traverse is a series of connecting lines or paths. This process is called traversing. Open…

Q: Question 1 Table 1 shows the summary of a closed loop traverse carried out in campus by a group of…

A:

Q: MAKE AN ORIGINAL PROBLEM SOLVING (QUESTION AND SOLUTION) REGARDING HORIZONTAL AND VERTICAL ANGLES IN…

A: numerical are based on WCB (whole circle bearing) or horizontal angle & vertical angle

Q: Describe how readings are determined on a digital level when using a bar-coded rod.

A: Bar coded rod: The bar code electronic theodolite or total station scale which are used for digital…

Q: There are two points, A and B, whose elevations above datum are h=1380 ft and hg = 930 ft and whose…

A:

Mapping

Mapping is the process of representing the surface of the earth, objects on it, and the relative positions of the objects, to a suitable scale. In mapping, a large area of land is measured, surveyed, and plotted. The details of the objects present in the nearby surrounding area are located using conventional signs. All these processes are carried out on a flat paper known as a map.