1:43 ..l 57 Shown below is the curved section of:

Q: A drain pipe is to be laid between two points. One point is 13'0" higher in elevation than the other…

A:

Q: Describe about Flow Nets and Seepage.

A: Flow net is a graphical representation of two-dimensional steady-state groundwater flow through…

Q: Define the term capillary fringe.

A: The capillary fringe is characterized as the saturated zone of water immediately just above the…

Q: Topic: Rockfall Netting and Guard Rail System Details and abstract and background about i

A: Solution:   Rock fall netting protection systems are the element that are used in the design and the…

Q: Problem I. A steel beam cross section is assembled as shown by bolting the channel, C200 x 27.9,…

A:

Q: Gate (AB) is hinged at (B) with 8 = 53.3°, having (1.8m) wide and (92.5kN) weight, find water level…

A:

Q: water flow by an angle 0 = 45° from the flow direction while accelerating it. The elbow the inlet…

A: To Determine What is the magnitude of the resultant force in the x direction FRx  What is the value…

Q: Define dilatometer test.

A: Dilatometer test is an in situ test method used to assess the strength and deformation of…

Q: Profile Level Notes: The elevation of BM A = 366.65' BS (plus sight) on BM A = 3.85' IFS (minus…

A:

Q: An sewer pipe (n=0.015) is designed to carry a flowrate of 83.5 cfs when the pipe flows 0.90 full.…

A:

Q: Write design steps and design considerations for the design of the groin field.

A: Groin Field: The groin is a structure which is a small structure constructed at a beach to prevent…

Q: Define Flood loads

A: The load expected to occur in case of floods due the the flood waters is called flood load. This…

Q: No.1 What is the purpose of sieving?

A: Sieving is used for various important purposes, That includes:1. Particle Size Analysis: Sieving is…

Q: 5. According to Fig. (a), (b), (c), specify what principle or relevant requirement is used on…

A: Dynamic tolerance diagram: Dynamic tolerance diagram 2 equal planes portray the volume of room used…

Q: Describe about the water table or phreatic surface.

A: Water table mark the topmost surface of water level.

Q: What is the minimum dimension of septic tank in residential building?

A:

Q: verity of seismic forces.

A: The sudden release of energy from the Earth's crust leading to production of waves which cause…

Q: 1/ For the plan and section of the wall shown below. Calculate quantities for each of the following…

A:

Q: Define about Prefabricated Vertical Drains ?

A: In construction of various structures on compressible, saturated soils like soft clay, excessive…

Q: What is gravity dam?

A: The gravity dam can be defined as it is a mass concrete structure which is made up of stone or…

Q: Briefly describe the vertical drainage method with an illustration

A: to find the vertical drainage method with an illustration.

Q: Describe, in detail how you would do the following, as a site engineer constructing a water…

A: A sequence of execution work for water retaining structure is asked for the detailed point wise…

Q: mune void ratio ven peresity 0-347

A: Given data : Porosity (n)=0.347

Q: How to get the vertical clearance on the center and location of the drain cover?

A: Vertical Clearance : The vertical clearance of bridge is the distance measured from road surface to…

Q: Q:Explain the difference between “suspended” and “ground” floors. Describe any two types of ground…

A: The surface with their necessary supports that provides accommodation to the individuals to reside…

Q: Define the term Drainage.

A: Drainage is defined as an artificial process of removing excess water from surface and sub-surface…

Q: Write brief notes on the following: a, the technique of estimating mean depth and mean area; and b,…

A: Step 1: Arithmetic Mean: When the basin's area is less than 500 x 10^3 m2, this approach entails…

Q: draw depth of stair landing = 1200 mm  floor to stair landing height = 1500mm

A: Given depth of stair landing = 1200 mm  floor to stair landing height = 1500mm To draw a staircase…

Q: Define Water-Retaining.

A: Water retention in soil can be understood as the water retained by the soil after it runs through…

Q: 350 mm 45 KN B 500 mm 9 kN C 9kN FD KN 400 mm D Wall

A:

Q: The level of the floor is (10m) and the staff reading on the floor is (1.505m) . If the inverted…

A:

Q: Define Exfiltration.

A: Exfiltration in civil engineering is a way to manage the  water collected during and after the storm…

Q: Describe hydraulic fill in detail.

A: Hydraulic fill is material that is dredged from from a borrow area or borrow pit and placed at a…

Q: What purpose does a sealant backup rod serve?

A: sealant is a substance used to block the passage of fluids through the surface or joints or openings…

Q: draw the layout of the custom pumping system, labeling all components

A: It is a bulk of pipe which used to flow the liquid from one place to other

Q: Describe the procedure of Blanket Drains.

A: Procedure of Drainage blanket:

Q: Given all information above Find the flow rate

A: Answer We are given  upstream depth of water y1 = 7 ft downstream depth of water y2 = 0.8 ft width…

Q: What would the minimum gutter size and slope for a roof that is 40 feet x 20 feet with a design…

A: Given data- Dimensions of the roof =40 feet×20 feetDesign rainfall=4 inch To Find- The minimum…

Q: Describe the statement unforeseen underground conditions?

A: unforeseen underground conditions These usually refers to the conditions when the underground is not…

Q: Define influence line diagram. Give a brief answer about uses of influence line diagram,

A: The given Question is Related to Influence line Diagrams.  Our aim is to Define what is mean by…

Q: What is the process to uncloggrd sand drain?

A: Sand Drain is based on principles of rapid and centrally dewatering system.Sand Drain is a process…

Q: Show step by step solution

A: FINAL ANSWER:-       Therefore,the minimum coefficient of friction is 0.2167.Explanation:

Components of Hydroelectric Power Plant

A hydro electric power plant derives the energy from the force of fast moving water to harness energy. The demand for energy needs has impacted the environment resulting in global warming. Extensive use of non-renewable energy sources like petrol and diesel is the primary reason for environmental pollution. A major shift from non-renewable energy sources to renewable energy sources is the only solution to encounter the rising issue of environmental damage.