14-116E The relative humidity of air at 80°F and 14.7 psia is increased from 25 to 75 percent during a humidification process at constant temperature and pressure. Determine the percent error involved in assuming the density of air to have remained constant.

14-116E The relative humidity of air at 80°F and 14.7 psia is increased from 25 to 75 percent during a humidification process at constant temperature and pressure. Determine the percent error involved in assuming the density of air to have remained constant.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A vertical piston-cylinder arrangement with a diameter of 120 mm contains water with a quality of…

A: The objective of the question is to understand the changes in the piston-cylinder arrangement when…

Q: What is the ang. velocity and acceleration of the disk when it rolls down the slope freely? Collar A…

A: Collar-A:Write expression for velocity of collar A in vector form.Here is magnitude of slider-A…

Q: 5. Water is being heated in a closed pan on top of a range while being stirred by a paddle wheel.…

Q: Data: the length of X(mm) its 237, and the length on Y(mm) its 175. The angle α is worth 30°.

Q: Required information Two kilograms of saturated water vapor at 600 kPa are contained in a…

A: Mass, m=2 kg.The initial pressure is P1= 600 KPa.The pressure at expansion is P2= 150…

Q: An old composite product of a company is comprised of 40 vol% fibre with the Young's modulus (E =…

A: Objective:Identify which of the following statement is false regarding the replacement if Young's…

Q: In the device shown in the figure, calculate the gage pressure of the gas in the tank. Tank Gas at P…

Q: The composite wall of a furnace consists of three different materials, two of which have known…

A: Given:The thermal conductivity at A is The thermal conductivity at C is The thickness at A is The…

Q: f I am given two thermodynamic properties of a material as equations with units that are unknown,…

A: There are two thermodynamics properties with unit.

Q: Determine the reactions at supports A and B. A 500 lb/ft -6 ft 6 ft- 700 lb/ft -8 ft- 9 ft 6 ft

A: To find reactions at A and B

Q: The number of vacancies in FCC nickel is 15 times higher at 1250°C than at 450°C. Find the…

A: Given-Let number of vacancies is denoted by Boltzmann constant To find-The activation energy for…

Q: 6-39. The tongs consist of two jaws pinned to links at A, B, C, and D. Determine the horizontal and…

Q: Determine the reactions at supports and then draw the shear force and bending moment diagrams for…

A: The bending stress is The height is 3 times the width.

Q: The tine ABC of the fork lift is subjected to a uniform distributed loading as shown. If it is pin…

Q: Determine the speed of block in Q1 when it moves 2m up the slope using the Work and Energy method…

A: Given:To find:(a) Speed of the block.(b) Power of force P.

Q: Determine the maximum angle a with the vertical that the ladder can make without falling on the…

A: L = length of the wall

Q: For the state of stress shown, determine the value of Txy for which the maximum shearing stress is…

Q: For the given loads, determine the reactions at the supports of the beam.

A: The FBD of the given force systemDetermine the support reaction at A and B.

Q: Two cylinders are to be press-fitted together so that the principal stress with the greatest…

Q: 2. Determine the force in each member of the truss, and state if the members are in tension or…

Q: can you do the SF and BM calculation with explanations

Q: 1. A 50-kg box has an initial speed of 7 m/s along the floor. The coefficient of kinetic friction is…

Q: a) In extreme cases, the filled bucket of water is dropped from rest (see the figure above). Help…

Q: A projectile is to be launched at an angle of 30° so that it falls beyond the pond of length 20…

Q: 1. If the built-up beam is subjected to an internal moment of M = 50 kN.m, determine the maximum…

A: *The internal moment acting on the structure is M=50 kNm.*The total length of the T section is L=320…

Q: Required information Problem 02.008-Stress and strain in a member loaded in tension - DEPENDENT…

Q: Calculate the heat transfer between two (50*40 cm) parallel plates at constant temperatures of 71 =…

Q: 1. A drawbridge is being raised by a cable EI and pin supported at A. The three joint loadings at B,…

A: A drawbridge is being raised by a cable El and pin supported at A. The three joint loadings at B, C…

Q: 4) The homogeneous rod AB weighs 96.6 lb and is at rest in the vertical position when an impulsive…

A: The weightof AB rod is The length of rod is The impulse applied at B is The time interval is

Q: There are four stations in a process: Station-1, Station-2, Station-3, and Station-4. They process a…

A: To Find:the average time in this process.Given:

Q: Calculate the compressive strength for a ceramic containing crack of size100 µm. Let μ be the…

Q: Q2. An Aluminum cube 5cm side length (rho=2700,C=0.896 KJ/Kg.C and k-204 (W/m. C) initially at 20 C,…

Q: The motion of a damped spring-mass system is described by the following ordinary differential…

Q: Determine the temperature distribution in a spherical layer of a body whose inner surface of radius…

Q: Which of the following power spectra was taken for a non-periodic data set (note the difference in…

A: Non periodic system are non repeatative in nature, these dont show same characteristic after certain…

Q: Mechanics question 1: Figure 1.1 shows a rod, AB, 1 m long, and with weight W, which is held in…

A: Given data:The length of the rod is, The rod is held in equilibrium by a vertical wall, the…

Q: 9-61. Determine the location y of the centroid for the beam's cross-sectional area. Problem 9-61 15…

Q: **** A wood beam carries a bending moment of 15 500 lb-in. It has a rectangular cross- section of…

Q: The velocity of water is 1.2 m/s. The minor losses due to these bends are equivalent to a pressure…

A: Velocity of water V = 1.2 m/s

Q: An air-conditioning system operates at a total pressure of 1 atm and consists of a heating section…

A: The inlet temperature of air is The inlet relative humidity is .The flow rate is .The temperature of…

Q: WHEN SEAWATER FLOWS INTO THE BOTTOM OPENING AT 10 M/S, CALCULATE THE VELOCITY OF THE SEAWATER LEVEL…

A: The objective of this question is to calculate the velocity of the seawater level inside the ballast…

Q: A reversed cycle operating as a heat pump uses R-134A as the working fluid. It is designed to…

Q: Calculate the degree of imbalance in each year based on the data given in the table below for a…

A: Given:To find:Degree of imbalance for each year.

Q: LEASE PLEASE HELP SOLVE THIS, A swimming pool is 30 ft wide and 60 ft long and its bottom is an…

Q: A 1.86-m³ rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and the…

A: Given:The volume of the rigid tank is the temperature of steam is The volume of the liquid phase is…

Q: Which moment has a greater magnitude? 10 m F 70° A B 7 kN A. The moment of the force F about A The…

A: Which moment has a greater magnitude?A. The moment of the force F about A.B. The moment of the force…

Q: Cylinder A weighs 206 lb and has mass moment on inertia about its centre of mass of 4.6 lb-ft-sec².…

A: Given,Weight of cylinder A = 206 lbMass moment of inertia I = 4.6 lb-ft-sec2Weight of block B = 85…

Q: 2. A cylindrical tank 5 ft high has a constant diameter of 4 ft is full of water. The tank has a…

A: Here we will apply the mass conservation theory.

Q: ) A cylindrical rod of constant shear modulus, G is of length L and located between z=0 and z=L. It…

A: Differential equation:

Q: The tank below is filled with a fluid with density 857 kg m³ If the outlet at the bottom of the tank…

Question

14-116E The relative humidity of air at 80°F and 14.7 psia
is increased from 25 to 75 percent during a humidification
process at constant temperature and pressure. Determine the
percent error involved in assuming the density of air to have
remained constant.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the percent error involved in assuming the density of air to have remained constant.

VIEW

Step 2: Find the percent error involved in assuming the density of air to have remained constant.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 13 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

room contains air at 30 degrees * C and a total pressure of 96.0 kPa with a relative humidity of 75 percen ermine (a) the partial pressure of dry air and (b) the specific humidity.
Calculate theoretically the relative humidity of moist air at a dry-bulb temperature of 15.2019123751 degree C and a moisture content of 0.00734 kgper kg dry air for a barometric pressure of (a) 101.325 kPa and (b) 95 kPa.kindly graph it on the given image
At an altitude of 1,600m, the atmospheric pressure is 81.49kPa. What is the specifichumidity and relative humidity at this altitude when the dry and wet bulb temperaturesare measured to be 10ºC and 5ºC respectively? Note, due to the low atmosphericpressure at 1,600m, the 1atm psychrometric chart is not valid for this problem. You willreceive no points if you use it
If the specific humidity of an environment is 20 g / kg and the dry bulb temperature is 31oC, indicate the dew point temperature, relative humidity and wet bulb temperature of the air in the table below.
A moist air sample has dry bulb temperature of 30°C and specific humidity of 11.5 g water vapour per kg dry air Assume molecular weight of air as 28.93 . If the saturation vapour pressure of water at 30°C is 4.24 kPa and the total pressure is 90 kPa, then the relative humidity (in %) of air sample is, (a) 50.5 (b) 38.5 (c) 56.5 (d) 68.5
Determine the relative humidity and dew point temperature of moist air at 95 F dry bulb temperature, 80 F thermodynamic wet bulb temperature, and 13.2 psia pressure. Regarding in this answer pls provide the necessary solution like the psychometric diagram or the psychrometric drawing in solving this problem. this problem is already been solve but I think it is lacking thankyou
Humid air at 25 °C and 80% relative humidity is cooled and dehumidified at atmospheric pressure, and then reheated and brought to 20 °C and 40% relative humidity. Analysis will be done by drawing on the psychometric diagram. a) What is the amount of water (kg/kgimnhavn) removed from the humid air? b) What is the heat extracted from moist air (kJ/kgkuair)? c) What is the heat (kJ/kgumair) given from the heater to the humid air?
At an altitude of 1,600m, the atmospheric pressure is 81.49kPa. What is the specific humidity and relative humidity at this altitude when the dry and wet bulb temperatures are measured to be 10ºC and 5ºC respectively? Note, due to the low atmospheric pressure at 1,600m, the 1atm psychrometric chart is not valid for this problem. You will receive no points if you use it Result Relative humidity should be greater then 1 if we use 1600m altitude in solution not 1 atm
20h AD Air enters a 30 cm diameter cooling section at 1 atm, 35 C°, and 60 % relative humidity at 120 m/min. The air is cooled by passing it over a cooling coil through which cold water. flow. The water experiences a temperature rise of 8 C° The air leaves the cooling section saturated at 20 CO Determine:. tuly: a- The rate of heat transfer. b- The mass flow rate of the water c- The exit velocity of the air stream. Assume specific heat capacity of water is 4.18 kJ/kg. Cº cuétems?
6 bales of cotton, each weighing 490 lb, were held for conditioning in a humid warehouse kept at a relative humidity of 95%. Calculate the total mass of water, in Ib, held within these bales at the end of the conditioning period. Provide your answer with two (2) decimal positions and no unit. Answer:
Proper indoor ventilation is important to lower the risk of infection from the SARS-CoV-2 virus. The air in a room (28.0°C and 30% humidity) with a volume of 96.6 m3 must be replaced every 5 minutes. Outside air at 38.0°C and 70% humidity is chilled to remove some of its water content and then dehumidified to the required temperature. What is the volumetric flow rate (in m3/min) of the humid air entering the chiller? How many kg of water per kg of dry air is removed from the dehumidification process? To what temperature (in °C) should the outside air be chilled?
Air at 30 ºC with a dew point of 14ºC enters a textile dryer at a rate of 15.3 m3/min and leaves saturated. The dryer operates adiabatically. Use the psychrometric chart to determine the absolute humidity and humid volume of the entering air, and then use the results to determine the flow rate of dry air (kg/min) through the dryer, thefinal temperature of the air, and the rate (kg/min) at which water is evaporated in the dryer.