1)(3,1|² |3,1) 2)(4,3|L,|4,3)
Q: Problem 4 The electron concentration in a Si sample is given by n(2) = n(0) exp(-2/L,), >0 vith n(0)...
A: Diffusion current is generated when charge carriers move from higher concentration to lower concentr...
Q: A rod of mass M = 3.25 kg and length L can rotate about a hinge at its left end and is initially at ...
A: Given: Mass of rod is M=3.25kg. Mass of putty ball is m=65g. Speed of ball is v=5.63ms. The angle at...
Q: Determine the volume charge density, in pC/m3 , at (-1,-8,-2) if the electric field present in the r...
A: Gauss's Law The surface integral of the electric field over any closed surface is 1εo times the tota...
Q: Based on the equation given below, sketch a diagram showing energy levels in helium atom. -13.6Z? eV...
A: level(n) Energy(eV) 1 -54.4 2 -13.6 3 -6.044 4 -3.4 5 -2.176
Q: A solid conducting sphere carrying charge q has radius a. It is inside a concentric hollow conductin...
A: Given: A figure representation is given as, As per rule, here allowed to answer only three subparts...
Q: material is not ceramic material. * O Aluminium oxide O graphite НА none
A: To answer: Which material is not ceramic?
Q: Why is optical density greater than 1.0 considered inaccurate? What should be done?
A: Given: To explain the optical density and things to be done is shown as,
Q: 2/34 The force of magnitude F acts along the edge of the triangular plate. Determine the moment of F...
A: Given, A triangular plate and force F acts along the edge of it
Q: The velocity of propagation c of surface waves in a shallow channel is assumed to depend on the dept...
A: Given, The velocity of propagation c of surface waves in a shallow channel is assumed to depend on t...
Q: initially stationary block of mass m on a floor. A force of magnitude F = 0.450mg is then applied at...
A:
Q: For the flow over a body completely immersed in a fluid, what is meant by the terms “pressure ...
A: Pressure drag: If there is an increased pressure in the frontal portion of a body and a decreased ...
Q: 45s5 is refer to * a) 45 cao ,s network former ,5 ratio of P205 b) 45sio2 , s network former , 5 rat...
A: Given that- 45s5, refers to -
Q: question in picture
A: Since, the element and resistance R of the LED are in series, the current IE through element is same...
Q: 4. The electrical capacity of a flat capacitor is equal to C = 100 pF. Dielectric - porcelain (E = 5...
A: Given : C=100×10-12F E=5 U=600V Initial energy of the capacitor : Wi=12...
Q: 1) A rectangular loop of wire is laying flat on a table. Sides of the loop are 25.0 cm (short sides)...
A: Let the diagram of the loop associated with the question is given below: given AB = CD = 75 cm =...
Q: shown in the figure. Find the following:1. What is the acceleration of the block perpendicular to th...
A: Newton's Second Law of Motion According to Newton's Second Law of motion, the rate of change of mome...
Q: Q3:- (a) Find the change in wavelength of 85 pm x-rays that are scattered 115° by a target. (b) Find...
A: 8.5Given, incident X-ray wavelength, λ=85 pm =85×10-12m mass of electron, m=9.1×10-31kg
Q: 1. A metal resistance Thermometer has a resistance = 80.0 Ω at = 20 ºC. The temperature coefficient ...
A: Given data: The initial resistance of the thermometer is Ro= 80.0 Ω. The initial temperature is To=...
Q: For the system shown below, a) derive the equation of motion using Lagrange's equations assuming sma...
A: let say kinetic energy T potential energy V Lagrange L Maximum radius of kT = a ano...
Q: the question is presented in the image below
A: 1. The free body diagram of the forces is represented in the following way. 2. The components of a ...
Q: Consider a car heading down a 6.5° slope (one that makes an angle of 6.5° with the horizontal) under...
A:
Q: Drop an object freely from a height of 490 m. Calculate the time required to reach the ground and th...
A: We have given that an object is freely dropping from a height of 490 m. We have to calculate the tim...
Q: Write the conclusion of full subtractor?
A: the figure above shows the block diagram of the Full substractor
Q: Point charges Q 1 nC, Q2 -2 nC, Q, 3 nC, and Q. -4 nC are posi- tioned one at a time and in that ord...
A: According to the question we need to position each charge one by one. Assume that the charge Q1 is p...
Q: in quantum mechanics calculate :
A: We can use pre defined results.
Q: Uniformly charged rod with length 2L0 is placed alone x-axis as shown in figure.Total charge , Q has...
A: The uniform charge density is given as, λ=dqdx Thus, dq=λdx The electric field at point A is given a...
Q: A spherical ball mass 5x10-4 kg is attached to a spring of force constant k = 0.05 N/m underwater. T...
A: Given: Mass attached to the spring is m=5×10-4kg. Spring constant k=0.05Nm. The damping coefficient ...
Q: A 2.5 kg block is initially at rest on a horizontal surface. A horizontal force of magnitude 5.8 N ...
A: Given that vertical and horizontal forces ( Fx,Fy) are applied to a block of mass 2.5 kg as shown, ...
Q: Consider a uniformly doped GaAs pn junction with doping concentrations of N,-5 X 1018 cm-3 and N, 5 ...
A:
Q: Q9)How is positioning done in GPS? / What is the minimum number of satellites required to determine ...
A: Answer: The positioning is done in GPS is explained as below: Explanation: Generally, GPS work...
Q: a car is driven at constant speed over a circular hill and then into a circular valley with the same...
A: a car is driven at constant speed over a circular hill and then into a circular valley with the same...
Q: See figure below: The left blue wire of length I is dragged to the right with velocity v over two co...
A:
Q: In the figure below, there is no friction on the two inclined planes but there is friction between t...
A: Forces acting on the block m1- Weight m1g downwards Normal reaction N1 upwards perpendicular to the...
Q: Problem 2: Two blocks of mass m, = 2 kg and m2 = 3 kg are connected by a rope that goes over a frict...
A: Now from Newton's 2nd law, we know that Net force provides net acceleration in the direction of the...
Q: The solenoid, shown below, carries positive current from left to right. The current is suddenly inte...
A: The initial direction of current is towards the right, thus the electrons are present at the left en...
Q: For the circuit shown at the right: A 12.02 1. Sketch and label the current flowing at the junction ...
A: Using the Kirchhoff law at node and in the loop,
Q: Use the method of separation of variables to construct the energy eigenfunctions for the particle tr...
A: Given equation, −ℏ −ℏ22m[∂2ϕ(x,y)∂x2 +∂2ϕ(x,y)∂y2] =Eϕ(x,y) ---------(1)To apply seperation...
Q: C. Two convex lenses are placed in series one after another as shown in the diagram below. Using the...
A: The ray diagram is given as,
Q: A plug made of brass is to be placed inside a ring made of quartz. At 20°C, the diameter of the plug...
A: Let consider the change in diameter as a change in length,Equations expressed in terms of diameters ...
Q: QI\ A 190'F bottle of milk left in 60'F room. At time initially the milk is cooling at 4 F per minut...
A:
Q: The Algol binary system consists of a 3.7 Msun star and a 0.8 Msun star with an orbital period of 2....
A: Given Mass of the sun M1 = 3.7 Msun Mass of the sun M2 = 0.8 Msun Orbital period (p) = 2.87 da...
Q: Question The wave function that describes any physical system must be multi- value and not infinite ...
A: Introduction: The state of a quantum mechanical system is completely specified by a wave function ψr...
Q: Calculate and plot the pressure as a function of radius in formations having permeabilities of 10, 1...
A: Oil well production system equation is given by, q0=4πkhkroμ0[ln(4ArcAr2ω)+25](p--pωf)4πkhkroμ0[ln(4...
Q: What is the effect of temperature and pressure on viscosity in a liquid
A:
Q: Table 1. Increasing Clench Force Data (Motor unit recruitment) Dominant forearm Non-dominant forearm...
A: The given clench force data have been used to answer the following questions !.
Q: In the problem of a particle in one-dimensional Infinite Square well, the number of nodes in , (x) i...
A: One Dimensional Potential Well A one-dimensional infinite well can be considered as a region where t...
Q: E8P9
A: Using the Gauss’s law, in the region R1 < r < R1, first we will draw the Gaussion surface at r...
Q: If a swimming pool is 5m depth and the water has absorption coefficient of 2m'. What factor is the i...
A: Given data, Depth of the swimming pool = 5 m Absorption coefficient = 2m-1
Q: An atomic power reactor can deliver 200 MW. If due to fission of each atom of U235, the energy relea...
A: Power delivered by atomic reactor due to Fission=200 MW=200×106 W Energy generated for a span of 500...
in
calculate
Step by step
Solved in 2 steps
