13. Figure Q25.13 shows conducting loops next to each other. We will define a counterclockwise current (viewed from above) to be positive, a clockwise current to be negative. The graph shows the current in the left loop as a function of time. Sketch a graph that shows the induced current in the right loop. Explain.

13. Figure Q25.13 shows conducting loops next to each other. We will define a counterclockwise current (viewed from above) to be positive, a clockwise current to be negative. The graph shows the current in the left loop as a function of time. Sketch a graph that shows the induced current in the right loop. Explain.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 46A

See similar textbooks

Similar questions

(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
A circular coil with 200 turns Las a radius of 2.0 cm. (a) What current through tire coil results in a magnetic dipole moment of 3.0 Am2? (b) What is the maximum torque that the coil will experience in a uniform field of strength 5.0102 ? (c) If tire angle between and B is 45°, what is the magnitude of tire torque on the coil? (d) What is the magnetic potential energy of coil for this orientation?
(a) What is the maximum torque on a 150-tum square loop of wire 13.0 cm oil a side that carries a 50.0-A current in a 1.60-T field? (b) Wliat is the torque when d is 10.9s?
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
A6. A 2 cm*2 cm square loop with resistance of 0.02 2 has one edge of the loop parallel to a long straight wire. The new edge of the loop is 1 cm from the wire. If the current in the sire is increasing at 50 A/s. What is the current in the loop?
1. A 1.50 V battery is connected in series with a capacitor and a 275Ω resistor. a. What is the charge and the voltage across the capacitor immediately after the switch is closed? b. At steady state, what will be the potential across the capacitor? 2. A loop of wire in the form of a square 1.50 m on each side, its plane makes an angle of 40.0° with a uniform magnetic field of 0.95 T. What is the magnetic flux through the loop?
3. A wire is moving on frictionless rails in a uniform magnetic field, as shown to the right. The wire is part of a complete circuit with a resistance R. a. If the magnetic field is 0.05 T and the wire is 5 cm long, what speed is necessary to produce an emf of 2 mV across the ends of the wire? b. If the resistance is 20 2, what is the current in the circuit?
The diagram shows a rectangular loop of wire moving away (in the direction of the blue arrow) from a long, straight wire carrying a constant current, I, in the direction of the red arrow. Which of the following describes the induced current in the resistor in the rectangular loop? a. There is no induced current flowing through the resistor. b. The induced current in the resistor is directed from B to A. c. The induced current in the resistor is directed from A to B.
A circular loop rotates at constant speed about an axle through the centerof the loop. Shown is an edge view and defines the angle Φ, which increases from 0° to 360° as the loop rotates.a. At what angle or angles is the magnetic flux a maximum?b. At what angle or angles is the magnetic flux a minimum?c. At what angle or angles is the magnetic flux changing most rapidly?
The metal rod (shown below) moves to the right on essentially zero-resistance and zerofriction rails at a speed v = 3.0 m/s. The magnetic field B = 0.75T everywhere in the region.a. What is the current through the 5.0-Ω resistor? b. Does the current circulate clockwise or counterclockwise?c. What is the rate at which the resistor produces heat (i.e., the power dissipated bythe resistor)?d. The rod moves 3.0 m/s to the right because an external agent is exerting a constantforce on it to the right. What is the magnitude of this force? e. Use your answer to part (d) to find the rate at which the external agent does workon the rod.f. Discuss the significance of your results for parts (c) and (e).
ΦΕΝ IN sp.g= 6H-AL=1, B = µH d p n I E
The figure shows a 10-cm-diameter loop in three different magnetic fields. The loop's resistance is 0.10 ΩΩ.(Figure 1) A. For case (a), what is the induced emf? In mV B. For case (a). what is the induced current? C. For case (a), what is the direction of the current? a. clockwise b. counterclockwise c. no current c. no current