12 ID 12 Draw the Mohr's circle. Find the stresses on the plane shown. Fill in the blanks and table. Show the stresses on the plane shown. Stresses are in ksf. Sigma-yp is 30 ksf. Does this fail? Show Tresca and the point. center = √₁ = J3= Imax= B= √₂5⁰ = I 150 25° -show stresses here fails? yes no

Define a logic loop.

Write a few lines on RFI?

A preliminary drawing which is typically hand drawn, with measurements of all the locations of items to be collected and reference points is called a: Group of answer choices Finished Sketch Diagram Rough Sketch Layout

How can CAD assist design engineers?

When are the punch lists needed?

As described in the Data and Results part of , all tables and graphs must have descriptive information such as titles, column or row headings, units, and axis labels, and data points must be clearly marked. All figures must be numbered and have a descriptive title. The figure number and the title should be placed below the figure. All tables must be numbered and have a descriptive title as well. However, for tables, the table number and the title should be placed above the table. Plot the following data. Use two different y-axes. Use a scale of zero to 30º C for temperature, and zero to 9 km/h for wind speed. Present your work using the ideas discussed in this chapter and engineering papers.

How to use architect (USA), engineer(USA) and metric scales?  Task: draw horizontal lines to scales or sizes indicated. 1. Architect scale: a. 4 9"/16 (Full Scale) b. 12 3"/8  (6"=1'-0) c. 21 7"/8 (3"=1'-0) 2. Engineer scale a) 13.4" (half size) b)5.85" (1=1) c) 63.5 ' (1"=10'-0) 3. Metric scale a) 715 mm (1=5) b) 33 cm (Half size)

Which side of a particular scale should I use if I want to draw these lines on a paper . For example I have 1) architect scale with the following dimensions : 1; 1 1/2; 16 ; 3/32; 3/4;1/8.  2. Engineering scale : 10; 20; 30; 60; 40;50 3.  metric scale : 1:100; 1:20; 1:50; 1:75;1:25;1:125

Drawing projections top front side on sheet