11. A strip of magnesium weighing o.200 g is added to 3.00 mL of 5.00 M hydrochloric acid. During the reaction, the test-tube becomes hot. Which one of the following statements about this reaction is INCORRECT? Select one: a. The salt produced is soluble in water b.4.52 x 1021 molecules of the gas are produced c. Gas bubbles are produced d. The magnesium strip reacts completely to release a colourless gas e. The enthalpy change for this reaction is negative

Q: [Evaporation] A triple effect evaporator concentrates a 10% caustic soda solution from 10% to 50%…

A: Introduction  Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: Q1. A. From the following table, estimate the energy content based on organic components once and on…

A:

Q: Methane diffuses from a gas phase onto a catalytic surface where it undergoes the following reaction…

A:

Q: Differentiate the evaporation and drying processes Determine the boiling point rise of a 20% NaCl…

A: Difference between evaporation and drying Evaporation means removing a part of solvent from a…

Q: B) Calculate the mass percentage of hydrogen in ethanol C,H;OH. C) Calculate the POH of 2×10 M of…

A: We are asked to find the mass percent of hydrogen in ethanol. first we will calculate the molar mass…

Q: 4. How many grams of ethylene glycol (C2H602) must be added to 1.00 kg of water to produce a…

A: Mass of water, mW = 1.0 kg Final temperature of the solid solution, Tf = -5.0°C

Q: . A distilling column is fed with a solution containing 0.45mass fraction of benzene and 0,55 mass…

A: Given  Feed contain 0.45 mass fraction benzene and 0.55 mass fraction toluene

Q: At 103 kPa and 300K , Xylene vapour and Argon mixture gets saturated, contains xylene vapours that…

A:

Q: What happens when a small amount of sodium hydroxide is added to a mixture of ammonia and ammonium…

A: The given mixture of ammonia and ammonium chloride is a buffer solution.

Q: A) What factors might lead to failure of the reactor and/or rupture disk?  B) Associate each factor…

A: Silane SiH4 analogues to methane with silicon. This is used in decomposition of silicon with…

Q: 3.138 A sample of 10.0 g of sodium reacts with oxygen toform 13.83 g of sodium oxide (Na2O) and…

A: Given: Mass of sodium that reacts with oxygen is MNa = 10 g The mass of product formed is MP =…

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid…

A:

Q: An iron-carbon alloy initially containing 0.255 wt% C is exposed to an oxygen-rich and virtually…

A: Given data: Initial concentration of C = 0.255 wt % Surface concentration = 0.0 wt % Temperature =…

Q: An iron-carbon alloy initially containing 0.200 wt% C is exposed to an oxygen-rich and virtually…

A: Given data:The initial carbon concentration is The carbon concentration at the surface is The carbon…

Q: An evaporator is fed with 17400 kg/h of a solution containing 12.1% NaCl, 19.9% NaOH, and the rest…

A:

Q: An industrial chemist is studying small organic compounds for their potential use as an automobile…

A: Given, Volume of water=25 mL density of water=1 g/mL So, mass of water =density×volume mass of water…

Q: In a particular process, 2000 kg of crystalline Na2SO4.10H2O are obtained and the mother liquor was…

A:

Q: After the addition of 24 g of ethanol (C2H5OH) to 1 kg of water, the freezing point of the solution…

A: 24 g of Ethanol (C2H5OH) dissolve in 1 kg of water. Freezing point of water at normal pressure= 0°c…

Q: Degree-of-freedom analysis Question 1 Strawberries contain about 15 wt% solids and 85% water. To…

A: Content of solids in strawberries = 15 wt%Content of water in strawberries = 85 wt%The residue…

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Given thatfeed contains solid = 15 %wt water = 85 % wt heat is added and water is evaporated residue…

Q: Two distillation columns in series are used to enhance the recovery of a desired component. In one…

A: Given that, The mole fraction of benzene in the feed xB,F = 0.2641 The mole fraction of toluene in…

Q: A 5,000-lb batch of 20 wt% aqueous MgSO4 solution is fed to an evaporative crystallizer operating at…

A: Given data: Amount of feed = 5,000 lb Composition of MgSO4 in the feed = 20 wt%  Operating…

Q: The humidity of a humid solid (dry basis) decreases from 80% to 5% in dryer. i) Calculate the amount…

A:

Q: An iron-carbon alloy initially containing 0.255 wt% C is exposed to an oxygen-rich and virtually…

A:

Q: (i) The amount of CO₂ being removed from the gas stream. (ii) The composition of gas leaving the…

A: Answer.

Q: Air is a homogeneous mixture of nitrogen and oxygen gases. The molar percent composition of air…

A:

Q: Calculate the molarity of a solution prepared by dissolving 1,56 g of gaseous HCI in enough water to…

A: Mass of gaseous HCl  = 156 g Volume of solution = 268 mL

Q: An iron-carbon alloy initially containing 0.308 wt% C is exposed to an oxygen-rich and virtually…

A: Given:D=5.5×10-10m2sC0=0.308%Cs=0%Cx=0.231%t=6 h=21600 s

Q: Steel surface can be hardened by carburization. Such process is done at 1000°C and the concentration…

A:

Q: A 100 mol liquid mixture contains 50 % Benzene, 30 % Toluene and 20 % Xylene on a mole basis. On…

A: Given, initial moles of mixture is 100 mol. mole% of benzene is 50% mole% of toluene is 30% mole% of…

Q: This gas produces pungent odor * CO2 О Н20 O NH3 О со

A:

Q: For coal combustion, the oxygen in the stack gas is a combination of surplus oxygen provided and…

A: Coal burn when they react with oxygen in the air. If there is plenty of air, complete combustion…

Q: calculate the molar and mass composition of the gas on a wet basis, as well as the molar mass of the…

A:

Q: test 1 A flame test was carried out on solid G. red colour test 2 Dilute nitric acid was added to…

A: G goes through a flame test -----------> Red color Nitric Acid + G -----------> Rapid…

Q: A petroleum gas mixture containing 65% propane, 25% of propylene and 10% of butane (mole percent) is…

A:

Q: 5. Another student dissolves a 5.25 g sample of solid NaOH in 100.00 g of water at 25.00 °C in the…

A: Write the reaction as follows: NaOHs + H2Ol → NaOHaq    Given, The mass of solid NaOH, m1 = 5.25 g…

Q: he highest element that is solid at room temperature, lithium, absorbs hydrogen to form LiH. Compare…

A: