11 Which of the following statements is true? A) The internal resistance of an ammeter is very high. B) The internal resistance of a voltmeter is very low. C) An ammeter measures current and should not be connected in parallel. D) A voltmeter measures voltage and should be connected in series. E) None of the above. 12 Given an analog signal with highest frequency of 30 KHz, what is the minimum sampling rate needed in order to make the signal can be reconstructed perfectly? A) 15 KHz B) 30 KHz C) 40 KHz D) 50 KHz E) 60 KHz answer in typing format please all subpart is compulsory please 13 What is the equivalent resistance between terminals a and b? A) 28 ohms B) 11.4 ohms C) 12 ohms D) 15 ohms E) 10 ohms 1292 www 20 Ω 60 Ω 30 52 4052 oa ob please answer all questions, much appreciated. Thank you.

11 Which of the following statements is true? A) The internal resistance of an ammeter is very high. B) The internal resistance of a voltmeter is very low. C) An ammeter measures current and should not be connected in parallel. D) A voltmeter measures voltage and should be connected in series. E) None of the above. 12 Given an analog signal with highest frequency of 30 KHz, what is the minimum sampling rate needed in order to make the signal can be reconstructed perfectly? A) 15 KHz B) 30 KHz C) 40 KHz D) 50 KHz E) 60 KHz answer in typing format please all subpart is compulsory please 13 What is the equivalent resistance between terminals a and b? A) 28 ohms B) 11.4 ohms C) 12 ohms D) 15 ohms E) 10 ohms 1292 www 20 Ω 60 Ω 30 52 4052 oa ob please answer all questions, much appreciated. Thank you.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Question No. 2a. In an Experiment, a high speed diode is to be used. The experimentalist has the liberty to make the diode with Si, Ge or GaAs. Which one would you prefer and why? b. Design a circuit for 5V DC from 12 V DC. Explain your circuit. c. Figure ‘a’ represents the input signal to a circuit which gives the output as the waveform ‘b’. Design the circuit and explain the working in detail
C6
4- Why do we need three RC network for phase shift oscillator? Can it be two or four ? and why?
If the frequency of the input signal applied to a full wave rectifier is 120 Hz, then what will be the frequency of the output signal?
B1
11. A conductor carries a current that is equivalent to a 2.5 amp continuous current *A conductor carries a current that is equivalent to a 2.5 amp continuous current m one direction and a superimposed full-wave rectifier in the opposite direction. What is the maximum value of the latter if the average conductor current is zero?
Consider two amplififiers with the following parameters: Amplififier A: Gain = 20 dB; Noise ratio, NR = 1.05 Amplififier B: Gain = 20 dB; Noise ratio, NR = 4.1 Identify the amplififier that adds the least internal noise to the input signal and determine its noise fifigure in dB.
The diodes that are not operated in the reverse biased mode are O a. Varactor diode O b. Tunnel diode only O C. LED O d. Photo diode and varactor diode
19/ The Capacitor in C-filter discharges when _______________________. a. the diode is reverse biased b. the diode is ON c. the diode is forward biased d. input voltage is more than the capacitor voltage
The average output value of half wave rectified voltage with a peak input of 200V is equal to -(assume silicon diode) a) 63.66 V b) 127.32 V c) 63.47 V d) 127.101 V