11-3. A water treatment plant is designed to treat a flow of 20,000 m³/day. The chlorine dosage is 1 mg/L. What size containers should be used in this plant? What is the minimum weight of chlorine which should be kept on hand? 11-4. If chlorine for the plant in Prob. 11-3 can be provided only in 68-kg (150-lb) cylinders and the minimum temperature is 4°C, how many cylinders must be connected to provide the required supply?

11-3. A water treatment plant is designed to treat a flow of 20,000 m³/day. The chlorine dosage is 1 mg/L. What size containers should be used in this plant? What is the minimum weight of chlorine which should be kept on hand? 11-4. If chlorine for the plant in Prob. 11-3 can be provided only in 68-kg (150-lb) cylinders and the minimum temperature is 4°C, how many cylinders must be connected to provide the required supply?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Hello, I have an equalization tank with the following dimensions: Tank Dimensions: Height: 5.15 meters Length: 10.3 meters Width: 30.48 meters Total volume calculated: 1616.8116 m³ The design flow is 2.5 MGD. I want to treat the pH and alkalinity with soda ash. pH: 4.9 (desired: 7) Alkalinity [mg/L]: 44 mg/L (desired: 200 mg/L) How can I calculate how much soda ash I need to treat the pH and alkalinity in the equalization tank?
A flocculator that is 100 ft long, 50 ft wide, and 20ft deep houses four, horizontal paddlewheels. Each paddlewheel has four symmetrical arms with fibre glass boards, 6.5 ft from the shaft to the centre of the board rotating at 1.5 rpm. Paddles are 42 ft long and 8 inches wide. The water treatment plant processes 25 MGD of water. Assume that the mean water velocity is 25% of lb-s² the paddle velocity and Co equals 1.8 and μ and p are equal to 2.735 x 10-5 ¹3 and 1.936¹ ft² respectively. Determine: a) Velocity of paddle blades (ft/s). b) Total power input (hp). c) Velocity gradient (s-¹). d) Detention time (min) e) G₂
An ion exchanger treats 1 MLD of water using an exchanger of capacity 100 kg/day/m3 with rate of flow being 0.5 m3/min/m2. Choose the correct statements assuming total hardness of water equal to 84 mg/1 as Cao. Total hardness of water is equal to 150 mg/l as CaCO3. Correct Option B Sodium Alumino - Silicates may be used as ion-exchanger. Correct Option lon exchanger can result in removing complete hardness. Correct Option Correct Option The height of ion exchanger required is 1.08 m if hardness of water is taken as 150 mg/1 as CacO3.
A treatment plant treats water at an average daily flowrate of 2.7 m3/s. The water is chlorinated before it flows into a 15000 m3 reservoir. The water flowing into the reservoir has a chlorine concentration of 3 mg/L. Chlorine decays at a rate of 0.24 h-1. Assume the reservoir is well-mixed and the system is at steady-state condition. (a) Determine the chlorine concentration at the discharge point of the reservoir. (b) The treated water flows from the reservoir into a transmission main. The pipe carrying the water has a diameter of 2 m and flows full. In the transmission main, chlorine decays at a rate of 0.19 h-1. Determine the concentration of chlorine 2 km from the treatment plant.
1. A CM reactor receives influent containing 10 mg/L of tracer dye for 2 hours. The tracer addition is terminated but the flowrate of water is maintained. The volume of the reactor is 10 L and the flowrate is 2 L/hr. What is the concentration of tracer in the reactor 1 hr after the dye addition is terminated? The reactor had an initial concentration of tracer of 1 mg/L when the tracer addition commenced.
Liquid alum is delivered to a water treatment plant which contains 642.3 milligrams of alum per milliliter of liquid solution. Jar tests indicate that the best alum dose is 8 mg/L. Determine the setting on the liquid alum chemical feeder in milliliters per minute when the flow is 2.2 MGD.
The shake-deflate baghouse on the power plant has 12 compartments, each with 100 bags (cylindrical) that are 0.2 meter in diameter and 7 meter long. Total gas flowrate is 300,000 m3/h which carries 60 g/m3 of particulate matter concentration. The pressure drop of a freshly cleaned baghouse is found to be 250 Pa, while the bags are operated until the pressure drop of 750 Pa. The cleaning frequency is twice per hour. The particle collection efficiency is 95%, and filter
11-11. Sodium fluoride has a solubility of 4 percent over the temperature range com- monly encountered in water treatment. A water containing 0.3 mg/L F is to have its concentration increased to 1.2 mg/L F. For a flow of 10,000 m³/day, determine the weight of sodium fluoride used per day. If the chemical is fed as a 4 percent solution, what is the appropriate flow rate?
Q2) A tank is initially filled with 100 gallon of salt solution containing 100 Hb of salt. Fresh brine containing 2 Ib of salt per gallon runs into the tank at the rate 5 gal./min. and the mixture, assumed to be kept uniform by stirring, runs out at the same rate. Find the amount of salt in the tank at any time, and determine how long it will take for this 5 galimin 2b saligal 100 gal 100 b salt 5 galimin amount to reach 150 b.
(I) Chlorine usage in the treatment of 22,000 cubic metre per day is 8.5 kg/day. The residual after 10 min. contact is 0.21 mg/l. Calculate the dosage in milligrams per litre and chlorine demand of the water.
N 5)( rat ala SIL O 23-A) An activated sludge system is to be used for treatment of 10000 m/day of municipal wastewater. A rimary clarification, the value of BOD, is 150 mg/l, and it is desired to have not more than 5 mg/l. in. ffluent. Assume that Y- 0.5; K, 0.05/day; and ML.VSS-3000 mg/l; Return sludge concentration 10 ng/L. 0 10 days. Determine: Treatment efficiency and the volumetric organic loading. 3) Microorganism ratio 5) The quantity of sludge that must be wasted each day i 2) Reactor volume and detention time. 4) the recycle ratin
concentration of (1.5 mg/liter). 3- The pump of waste water of concentration (1.5 mg/liter) treatment plant system is powered by a (15 kw) electric motor whose efficiency is (90%). The water flow rate of the pump is (50 L/sec).The diameter of the inlet and outlet pipes are the same, and the elevation difference across the pump is negligible. If the pressure at the inlet and outlet of the pump are measured to be (100 Kpa) and (300 kpa) absolute, respectively. Determine the mechanical efficiency of the pump. 19 (41:13