10- What is the BOM and how is it arranged on a format?

Q: QUESTION 2 120 8 22- 14 - 40 70 56 34 44 R8 024 e 12 O8-2 Holes 64 26 34 22- STEPS: 56 1) Draw the…

A: For given isometric view, we identify the direction of the view. after identify that we can able to…

Q: Which of the following is the largest scale? O 1cm:1mile O 1 mm:10m O. 1:1000 1cm:1km

A: to check largest or smallest scale firstly convert all numerator and denominator in same unit of all…

Q: What types of sculpture are commonly available?

A: Sculpture is a generally a form of artwork used in interior as well as exterior locations.

Q: Principles of Design Pattern Contrast Emphasis Balance Proportion/Scale (Find out the difference…

A: Principles of Design Principles of design are fundamental guidelines that help create visually…

Q: 13.1500 13.1500 4 0000 - -2.0000 4.0000 -3.3500 0.0000 2.0000- 3.8000 -3.3500 2.0000 2.0000 2.0000…

A: We need to find out One Way Slab and Two way slab If Ly/Lx is equal to or more than 2 then One way…

Q: Please find the centroid x and y bar, and Ixx for the following shapes. Show all work with neat…

A:

Q: Identify the length of line A, B, and C. Create/Draw top view, left view, front view, and bottom…

A: Answer  Length of line A = 9.0-4  Length of line A = 5 Length of line B = 13.5-11.52 Length of line…

Q: Where

A: Required : To explain the number of cycle in 1 hour

Q: No.2 What is grain size classification？

A: According to ASTM standards.Coarse-Grained Soils: More than 50 percent retained on a 0.075 mm (No.…

Q: What is Dimensional Lumber often used for in construction projects?

A: Dimensional lumber is a wood lumber that is cut to pre defined standard sizes These are structural…

Q: Explain basic differences of rivets, unfinished bolt, High strength Bolt connections in terms of…

A: Rivets : Rivet is a headed pin which is used for connecting two or more pieces by passing the shank…

Q: Define the following words Tesserae Kline  Klismos Chai

A: These three terms give various elements that are important in design and art. Learning these will…

Q: For the given structures, determine the degree of indeterminacy. 3. 3

A: The given structure has two fixed supports at ends and one roller support in the middle. The fixed…

Q: what is the recommended thickness of outline

A: Answer Answer of the above question is in second step

Q: Q) Draw the following with scale 2:1: 1. Front Sectional View on A-A 2. Side View 3. Top Sectional…

A:

Q: Define Structural Analysis

A: Answer  Structural Analysis refers to the determination of the axial forces, shear forces, bending…