10) From the following calamine lotion formula, calculate the quantity of each ingredient required to make a pint of calamine lotion. 80 g 80 g 20 g 250 mL calamine zinc oxide glycerin bentonite magma calcium hydroxide topical solution q.s. 1000 mL

Q: A 75-gallon vessel is prepared for placing into service. Use a sweep-through purging method, to…

A:

Q: If the mass of a solution is 80g and the mass ratio of the solute is equal to 20%, calculate the…

A: Given, Mass of solution is 80 g. Mass ratio of solute to the solution is 20%. It represents for…

Q: [Evaporation] A triple effect evaporator concentrates a 10% caustic soda solution from 10% to 50%…

A: Introduction  Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: Does a solid have a vapor pressure?

A: The existence of vapor pressure for solid is to be mentioned.

Q: Make a flow chart of the process, showing all the steps in the process and labeling all of the input…

A:

Q: Calculate the stoichiometric air to fuel ratio for the combustion of butane (C4H10).

A:

Q: What happens when a small amount of sodium hydroxide is added to a mixture of ammonia and ammonium…

A: The given mixture of ammonia and ammonium chloride is a buffer solution.

Q: What is graphene?

A: Given: What is graphene?

Q: In industrial process engineering, mixing is a unit operation that makes a heterogeneous mixture…

A: Mixing : Mixing is a unit operation in which two or more components are treated in such a way to…

Q: Differentiate between bioethanol and biodiesel. (Any two points)

A: Difference between bioethanol and biodiesel is

Q: 3. An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of a solution…

A:

Q: Alum is used as a coagulant. The best dry alum dose from the jar tests is 10 mg/L. Assume dry alum…

A: Given that, The dose of alum = 10 mg/L Converting into kg/L, the dose is = 10 mg = 10×10-6 kg = 1×…

Q: Plot the the attached data - Absorbance vs. Time

A: According to the Beer-Lambert law, a linear relationship between the concentration and the…

Q: Wet bulb temperature 95 degrees Fahrenheit, RH 35%. Calculate dry bulb temperature, dew point,…

A: Wet bulb temperature = 95°F =35°C Hence, C5=95-329 or, C=35°C Therefore, diabetic saturation…

Q: Calculate the critical pressure and critical temperature of the below gas natural. Calculate the…

A:

Q: Typical data on the ultimate analysis of the combustible components in residential MSW Percent by…

A:

Q: 80% RH, specific volume 16.5 Cu-ft of air / lb of dry air. Calculate what is wet bulb temperature,…

A:

Q: In oil industries, the separation of crude oil into gasoline, kerosene, fuel oil etc., are typical…

A: The answer and explanation are given below.

Q: Provide an explanation for the chemical reaction of using Cream of Tartar as a mordant in natural…

A: The cream of tartar is used as an assistant in the preparation of the wool , in which alum is used…

Q: If any chemical gets into the eyes, wash the eyes with plenty of running water wash the eyes with…

A:

Q: Glasses may be shaped by a variety of processes which include pressing, blowing, drawing, casting,…

A: HI, thank you for posting the question. As there are two questions asked in a single submission, our…

Q: What are chloroguaiacols used for in the pulp and paper industry?

A:

Q: A 50 mL mineral oil (HLB 10) emulsion is prepared by mixing Span 40 (HLB 6.7) and Tween 40 (HLB…

A: GivenTotal volume of the mineral oil emulsion, Vem=50mLVolume % of emulsifying agent  in solution…

Q: Dissolve 2g of table salt in 8 g of distilled water. Calculate the percentage of solvent and solvent

A:

Q: How much water must be added to potato granules containing 13.0% moisture (dry basis) to give a…

A: The moisture in material or food is reported on a wet basis and dry basis. The dry basis water…

Q: A 1200 mole charge of 30 mole % naphthalene and 70 mole % dipropylene glycol it is separated in a…

A: Given, The moles of the feed to the vaporizer, F = 1200 mol The mole fraction of naphthalene in…

Q: 4. Calculate the change in pH that results from adding 25 ml of 0.010F HCI to 500ml buffer solution…

A:

Q: Produce a scatter plot for windshield water distillation, Vapor temperature along y-axis and volume…

A: Given: Data for distillate volume (mL) and vapor temperature (°C) are as given below: Distillate…

Q: When you rub the NaOH, KOH, NH4OH, and milk of magnesia solution between your fingers, how does it…

A: The touch of the given compounds is to be mentioned.

Q: NAME OF CHEMICAL PERCENTAGE USES COMPOUNDS FORMULA COMPOSITION a. Acetone b. Toluene c. Ammonia

A:

Q: By using the given picture as a reference, please do safety and health concern for following…

A: We are gieven the reference chart. using that chart we have to provide the safety and health…

Q: NAME OF CHEMICAL PERCENTAGE USES COMPOUNDS FORMULA COMPOSITION Formaldehyde f. Benzene g. Carbon…

A:

Q: Classify each of the following materials whether it is metal, ceramic, or plastics. (Copper,…

A: Metals ----> copper, Magnesium Oxide, MgO

Q: Calculate the O2 mole flow rate in 10 kg/min flow of air.

A: Assuming molar composition of air is O2=21% and N2= 79% Molecular weight of O2 = 32 g/mole Molecular…

Q: What are the factors that effect the moisture content of food stuff ?

A: Food moisture content = Food moisture content is the quantity of water present in the food stuff.…

Q: 5.3 The laboratory test data for a standard Proctor test are given below. Find the maximum dry unit…

A: Determine the moist unit weight  of the soil using the formula. Here, W is the weight of the…

Q: A new drier was tested by drying a wet material with 52.8% moisture (db). It was found that 561.85…

A:

Q: Calculate the mass percentage of carbon and hydrogen in propane (C3Hs).

A: Let the mass of carbon in propane (C3H8) be mC and that of hydrogen by mH.   The molecular mass of…

Q: How did you calculate the percentage of organic matter according to fresh material

A: To clarify how to calculate the percentage of organic matter according to fresh material, based on…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.