1.Do the polarities of the sources matter as to the resulting voltages? Will the magnitudes of the voltages be the same if one or both sources have an inverted polarity?

Q: 1= 20/70° A E = 80/40⁰ V

A: W need to find out reactance for given current and voltage

Q: pothesis an expression for square wave generator with the help of circuit diagram

A: Working:-  The circuit given below is an astable multivibrator also known as a square wave…

Q: 9. [(2260)/(15Z-75)]+[(1.2+j1.2)/(4.2+j2.4)]

A:

Q: Based on the phasor diagram of a voltage and a current shown below, which of the following statement…

A:

Q: The bridge method commonly used for measuring mutual inductance is: A. wheat stone bridge B. Wien…

A: Given Bridges, A. wheat stone bridge B. Wien bridge C. De Sauty bridge D. Heaviside campbell bridge

Q: Capacitance changes when ______________.   a. Dielectric changes   b. Distance between plates…

A:

Q: Impedance of AC circuit and Admittance of AC circuit SHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN…

A:

Q: In stormy weather, Corona occurs at a much higher Voltage compared to fair weather. Select one: True…

A: In the stormy weather, the number of ions is more than normal, and corona occurs at much less…

Q: purely capacitive O a. Current lags the applied voltage by 90 degree O b. Current is directly…

A: Here I have described it. In pure capacitor current always leads voltage or voltage lags current by…

Q: Determine the rms current I as shown in figure 3. Source voltage is already in RMS value(Answer must…

A:

Q: In the experiment what is the given AC supply R=1500 set-up, Inductance in the 2.300 V L=?

A: Given circuit diagram is,

Q: 115 V ms 220 1 lll

A:

Q: In an inductive circuit, What is the value of the instantaneous current if t-40 s.L= 10mH and v(t) =…

A:

Q: admittance Y=0.06 - j0.08 mho, then conductance is

A: Given:- AdmitanceY=0.06-j0.08 mho To find:- Conductance

Q: Explain briefly why is the source (total) voltage almost the same as the voltage across the…

A:

Q: Find I andli?

A: It is given that: using the given information the modified circuit is drawn below:

Q: for 下e energy FiND Tellowing Synal ン(り- loe もろ0 the -ヒ loe くo

A:

Q: TOPIC:  Ohm's Law, Power and Generating Direct Current Direct Current Circuit Analysis Inductor,…

A:

Q: eactance of this circuit? what is the inductive 12 when a inductor and resistor are connected in…

A:

Q: If a load is leading, which statement is NOT true? a. The load is capacitive. b. It’s reactive…

A: We are given a MCQ and we need to select the correct option out of four given option.

Q: A polar vactor is one which?

A: POLAR VECTOR: A vector is known as polar vector if on the reversal of the coordinate axes the sign…

Q: 11 an R-L circuit contains a resistor and an inductor in series. The resistor has a value of 6.5…

A:

Q: Find the current through the capacitor of (-j5) capacitance reactance using NODAL ANALYSIS. Current…

A:

Q: ()Analyze the caremnt beluwe Assune the capacitiovs are anchurged befure the sintch is clored. At…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Equation of an AC voltage with frequency 100 Hz and RMS value 100 V is

A: Given an AC voltage with, Frequency, f = 100 Hz RMS value, Vrms=100 V

Q: Does Ohm's Law apply to an AC circuit containing an inductor?

A: According to ohm's law, current pass through any linear and passive element is directly proportional…

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A:

Q: 8/0 10 NE -/5 N

A: Parallel Connection: In parallel connection, voltage developed across all the impedances in the…

Q: 2 The conductors in a single phase ine are 6m above the guünd. Each conductors are spaced 3m a pant.…

A:

Q: A 1 kV, 50 Hz underground cable has a capacitance of 0.38 µF/km per/phase. How much reactive power…

A:

Q: A 3V sinusoidal signal with frequency 100 Hz amplitude is applied to channel A of an oscilloscope. A…

A:

Q: ?What is the function of exciter It absorbs reactive power O It generates reactive power None of…

A:

Q: What is the difference between an inductive load and a capacitive load of an alternating current…

A: The solution is given below

Q: Find the phase angle between i = -4 sin(377t + 25°) and iz = 5 cos(377t – 40°) %3D Does i lead or…

A: Given: The phasor are i1=-4sin377t+25°i2=5cos377t-40°

Q: Q.) Figure below divider bras amplifier Circult. Givent the model Parameter : gm = 5omS emitter (CE)…

A: Brief description: In the above given question they have mentioned an NPN common emitter amplifier…

Q: What is the equation of this voltage waveform? V(t) = ?

A: The given voltage waveform can be converted into its equivalent voltage expression by observing the…

Q: Problem 3 a) In Figure 1, the current through a 550 nF capacitor is i = 12 x 10-3 A sin(2000t +…

A: Find the voltage in the first circuit and current in the second circuit?

Q: There is a 110 Vac -60hz generator in series with a 48Vdc battery. For this series connection…

A: In this question, we need to determine the reading of coil voltmeter and iron voltmeter for the…

Q: ODULE 4: INDUCTANCE AND CAPACITANCE dent Name: Date: ROBLEM ES1-4-2 Directions: Calculate the total…

A: Given: L1=0.25HL2=0.65HL3=1.75H

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per…

A: Given data, D=42 feet Standard data, For Falcon ACSR(steel) Diameter=0.5150 inch

Q: 6. Determine the rms current I as shown in figure 1. Source voltage is already in RMs value (Answer…

A:

Q: Two parallel wires conduct the same amount of current and in the same direction. The wires are L…

A: According to question We need to calculate magnetic field at point P which is the middle point of…

Q: 148 Determine the rms value of the voltage waveform shown in Figure vt) WW 4. 18 24 12

A:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.