1.5 Use KCL to find the values of i, for the circuit of following Figure, in which i=4, i *=3. Which elements are connected in series in this circuit? 2

A circuit has one 10 Ohm resistor and you want to drop the current by a factor of two. Which of the methods below would allow this? You could add: (Choose any that apply. )     two 5 Ohm resistors   another 10 Ohm resistor   ten 1 Ohm resistors   one 20 Ohm resistor

can someone show me how to do this problem step by step please a device can be modeled as a current source in parallell wih a resistance

4-5) Before the advent of ohmmeters (even the analog ones), unknown resistances (Runk) were measured using a Wheatstone bridge. The unknown resistance is placed into the circuit at right as shown. The values of R1 and R2 are extremely well known. The resistance of Rvar is adjusted until the meter Runk. Rvar R1. R2 reads no current in the cross branch. The value of Rvar is then read from a dial. Show that Runk can be found from R1 -Ry Rukn

Consider the circuit in (Figure 1) with 120 VV.   Figure 1 of 1   Part A Use the node-voltage method to find the power developed by the voltage-controlled current source in the circuit. Express your answer to three significant figures and include the appropriate units.   Activate to select the appropriates template from the following choices. Operate up and down arrow for selection and press enter to choose the input value typeActivate to select the appropriates symbol from the following choices. Operate up and down arrow for selection and press enter to choose the input value type   pVCCS�VCCS =