1. Draw the internal design of a microcontroller and explain each block diagram. 2. What are the design considerations or appropriate criterion in choosing the right microcontroller for your project?

1. Explain how the controlled rectifier circuit can be used in industry. 2. Why triggering is required for SCRS. 3. What will happen if SCRS replaced with BJTS in contolled rectifier circuit 4. Why it is called controlled rectifier. 5. If the load is RL, how will the output change

4) Choppers is a a. AC - DC converters b. AC - AC converters c. DC - AC converters d. DC - DC converters 5) A single phase dc ac converter is also known as a. Rectifier b. Inverter c. Chopper d. Regulator

What are fuses in the context of microcontrollers, and how do they impact device operation?

3. Calculations and Discussion 1. Calculate the theoretical output DC voltage of the half-wave rectifier circuit and compare it with measured value. For the capacitive filter, obtain the theoretical values of the DC output voltage and the ripple voltage and compare these values with the measured quantities. Determine also the practical and theoretical values of the ripple factor. 2. Calculate the theoretical output DC voltage of the center-tapped full-wave rectifier circuit and compare it with measured value. For the capacitive filter, obtain the theoretical values of the DC output voltage and the ripple voltage and compare these values with the measured quantities. Determine also the practical and theoretical values of the ripple factor. 3. Repeat the calculations for the full-wave bridge rectifier and filter circuit. 4. Determine the peak inverse voltage (PIV) on each diode in the three rectifier circuits. Experiment 2 - 15- Rectifier Circuits 5. If diode D4 in the bridge rectifier…