1. Determine if the following assumptions are correct and briefly support your answer based on the voltage and current obtained.   a. D1 and D3 are forward and D2 is reverse b. D1 D2 and D3 are direct

Q: The current in a 120 V reading lamp is 2.6 A. You may want to review (Page 739). Y Part A If the…

A: Given data, In a reading lamp, Current I=2.6 A Voltage V=120 V Cost of electricity $0.075 /kWh Time…

Q: B. Find, graphically, y(t) = f(t) * h(t) where h(t) = 8(t)- 8(t-1) and f(t) is the signal shown in…

A: According to the question, we need to calculate y(t)= f(t)*h(t). Here, f(t) is given as and…

Q: You have a wire of length L = 2.3 m for making a square coil of a dc motor. The current in the coil…

A:

Q: A current of 8 A in coil A produces a flux of 0.04 Wb. If the coefficient of coupling between the…

A:

Q: Question 36 What size TW copper conductor should be used for the branch circuit? (Show all of your…

A: The term "ampacity" is a portmanteau for "ampere capacity," which is prescribed by national…

Q: A DAC has a 10v range and 8 bits of resolution. What is the step size?

A: Given: A DAC has Voltage range, Vrange=10 V Number of bits, n=8

Q: 3. Determine Thevenin's and Norton's equivalents at P-Q for the given circuit 5 A RTH VTH = 6V IN =…

A:

Q: 6-36For the differential equation: 1 vo(t) = 10 vs(t) + 10 dus(t) dt 1 d'us(t) 20 dt² a. Draw a…

A: The given differential equation is vOt=10vSt+110dvStdt+120d2vStdt2. We need to draw a block diagram…

Q: A 480-V, three-phase, six-pole, 60Hz induction motor is running at slip of 3%. Find the speed of the…

A: Given: A 480 V, 3-phase induction motor with Number of poles, P=6 Supply frequency, f=60 Hz Slip,…

Q: 2. Draw the input and output waveform for the following clipper circuits if input signal is triangle…

A: Given data, Frequency f=1 kHz  =1×103 Hz Input triangular wave is given by 10 V. Given circuit,

Q: 2-bit by 2-bit binary multiplier using ROM VHDL code

A: A multiplier is an electrical circuit that multiplies two binary integers in digital electronics,…

Q: A balanced delta connected load contains 8 + j4 ohms per phase, while a balanced wye connected load…

A:

Q: 10.C-Which part of the NEC standard proposes the switches requirements?   D-If the branch circuits…

A: The Given General living space is

Q: An RC High-pass filter consists of 5 nF capacitor and a 50 K 2 resistor. The output voltage is taken…

A: Given: An RC high-pass filter consists of  Capacitor, C=5 nF Resistor, R=50 kΩ

Q: Branch-Circuit Sizing What's the demand load for the oven this circuit? (Again, show all of your…

A: Given data, Rated Power P=15 kW or 15000 W Rated Voltage V=240 V

Q: Two coils, A and B having 1200 and 800 turns respectively are placed near to each other.60 % of flux…

A: Given data: Number of turns in coil A=NA=1200 Turns Number of turns in coil B=NB=800 Turns…

Q: In Canada, the AC power line voltage is nominally 115 V Vrms at 60 Hz. What are the peak voltage and…

A: Given, In Canada, the AC power line has Vrms=115 Vf=60 Hz

Q: Explain the principles of servomotors and discuss their different types.

A: Servomotor: The basic principle of servo motor is based on Pulse Width Modulation (PWM) concept, in…

Q: 6. How many cycles will an AC signal make in 2 seconds if its frequency is 100 Hz?

A: The correct option along with the explanation is provided in the following section.

Q: Calculate the average (P) and reactive (Q). Consider, v(t)=3.5 cos(600t−120∘) V and i(t)=2.3…

A:

Q: For the given oscillator circuit, a) State its name. It is ♦ oscillator msec 555 Timer Relaxation b)…

A: It is given that:

Q: A 4-pole DC generator runs at 650 rpm and generates an EMF of 200 V. The armature is wave wound and…

A: Given a DC generator with, Rated emf, E = 200 V Total number of pole, P = 4 Speed, N = 650 rpm Wave…

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes.

A: The correct option along with the explanation is provided in the following section.

Q: Why would an oscillator of the closed-loop model be expected toprovide a more stable rhythmic output…

A: Oscillators and their property: Oscillators are the circuit which are used to convert the DC voltage…

Q: The cutoff frequency, in Hz, for a low pass filter with R = 105 kiloOhms, and C = 20 nanoFarads is…

A: Given: A low pass filter has R=105 kΩC=20 nF

Q: 2. When the demand curve is P = -0.5Q+ 12, the Marginal Revenue curve is MR =>

A: Given- P=-5Q+25

Q: 3. In the given circuit, the switch is closed for a long time. At t=0, the switch is opened. Find…

A:

Q: Using Karnaugh map, simplify the expression F(W, X, Y, Z) = Σm(0, 1, 2, 4, 5, 6, 8, 9, 12, 13, 14).…

A:

Q: 50 2430 2-12 822 mom + 1-2 1040° 10_2 32 soo 'R'_₂ Using Mesh Analysis, determine the mesh currents…

A:

Q: A plane wave propagate through a lossless medium with = 3 and μ = 1, the magnitude of the magnetic…

A: Given, A plane wave propagate through a lossless medium with, Hz,t=4 cos 4×107t-βz Am εr=3μr=1

Q: b) Sketch four (4) types of possible connections for a three-phase transformer bank.

A: Three-phase transformer bank is in the transmission line and is studied in the power electrical…

Q: Consider the circuit shown below, find the current is. Τ 5Ω Μ 10 Ω Μ 15 Ω M 30 V

A: Given,

Q: The capacitive reactance in an RLC circuitis determined to be 31 Ω when the inductive reactance is…

A: (a)  The graph between the frequency and the impedance of the circuit is shown below:  XC>XL As…

Q: A student is planning to make changes to a circuit. Which change will increase the voltage? A. Add…

A: In option a it is given that adding other bulb if other bulb will be added to the circuit then it…

Q: A voltage wave having an equation e = 220 sin(314t+45°) + 100 sin(942t - 45°) is impressed across a…

A: Given parameters: Voltage wave expression- e =220sin314t + 45° + 100sin942t - 45° Resistance, R = 10…

Q: For unity feed back system with a forward transfer function K G(s) = s(s+50)(s + 120) Use frequency…

A: A system's steady-state reaction to sinusoidal inputs of different frequencies is referred to as its…

Q: When a pure semiconductor is heated, its resistance.. 1. Goes up 2. Goes down 3. Remains the same 4.…

A: Semiconductor: A substance with specialised electrical properties, known as semiconductor, can be…

Q: Use the 2 figures to calculate the experimental value of the permeability constant. Provide the…

A: The given graphs are shown below. We need to calculate the permeability constant.

Q: I need all steps answer    A 3-phase overhead transmission line delivers a load of 80 MW at 0.8 pf…

A:

Q: A3-phase, 220 KV, 50 Hz transmission line consists of 1.2 cm radius conductors spaced 2m at  The…

A:

Q: Question 4 a) For the circuit given in Figure Q4a, the source voltage is 240V, 50 Hz. R1 V1 8 Ω R2 3…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: In a tansistor, I = 70 mA and I = 70.2 mA. The value of B is Select one: a. 50 b. 350 c. about 1 O…

A:

Q: 3. If an electric current of 5A flows through a conducting wire having a cross-sectional area of 2…

A: Given, Current (I)=5A Area of Crossection=2mm2=2×10-6m2 Time (t)= 2 hours=2×60×60=7200 seconds

Q: Find total resistance in Fig Assume each element is 1ohm

A: It is given that:

Q: How do I build this circuit?

A: Circuit elements of given circuit: PSB 5V D1 RED SW1 R1 330 ohm D2 BLUE SW2   We are required to…

Q: Obtain the waveform of output states Q and Q for the D latch when the input condition as in Figure 2…

A: The latch is a device that stores a bit of data in it. It is a level-triggered device and it changes…

Q: 1. Two resistors, each of magnitude R1 = 100Ω and R2 = 200Ω If the two resistors are connected to a…

A:

Q: Sine wave is a a. Periodic signal b. Aperiodic signal c. d. Both a and c Deterministic signal

A: The correct option along with the explanation is provided in the following section.

Q: estion 4, Given the equation below: i. Show the simplified Boolean equation below by using the K-Map…

A:

Q: 14-ELECTRONICS LAB..-5 In the half wave rectifier circuit, if the maximum output signa 12.3 volts,…

A: Given a half wave rectifier with, The maximum output signal, Vm=12.3 V