1. A rectangular footing 2.0 m by 3.0 m is built in a homogeneous bed of sand of having bulk unit weight 20 kN/m3 and saturated unit weight 21 kN/m³ with an angle of shearing resistance of (30+Y)°. The depth of the base of footing is 1.8 m below the ground surface and water table is located at a deth of 1.0m below the base of the foundation.

1. A rectangular footing 2.0 m by 3.0 m is built in a homogeneous bed of sand of having bulk unit weight 20 kN/m3 and saturated unit weight 21 kN/m³ with an angle of shearing resistance of (30+Y)°. The depth of the base of footing is 1.8 m below the ground surface and water table is located at a deth of 1.0m below the base of the foundation.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Determine the rectangular representations of the vector F. F-750 N 45 60

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: NOTE MY ID NUMBER 20-3994-175 - Don’t round off answers unless it is already the final answer.…

A: To find reaction at all joints

Q: Why do we need to know the term ‘allowance’ when comes to measurement?

Q: Earned Value is needed because O There are different measures of progress for different types of…

A: Using the project management method known as Earned Value Management (EVM), a project's progress in…

Q: Convert the following distances given in feet to meters: Part A 521.80 sft Express your answer in…

A: convert the following distances given in ft to meters :-Part A)521.80 sftPart B)2100073.9 sftPart…

Q: Research for the following question. Should be more than 10 sentences and attach formulas: 1.)…

A: Brief concept introduction- Bernoulli's equation- It is applicable to a complete, non-abrasive,…

Q: Fill in the following Leveling Notes. In your handwritten notes, perform a page check and calculate…

A: Surveying is a very important branch of civil engineering as it is mainly dealt with the measurement…

Q: Determine the horizontal reaction at A. (N) Determine the vertical reaction at A. (N) - Determine…

A: To determine the reactions for the given beam. Given, Y = 75 A = 9 B = 9 To solve the beam for…

Q: х (N) C A (m) - 2 m 2 m- A 60° 11. Determine the horizontal reaction at A. (N) 12. Determine the…

A: X = 175 A = 9

Q: Instruction: Solve the following questions. Write legibly. Copy and Answer. Avoid erasures. Rounding…

A: Step 1: Step 2: Step 3: Step 4:

Q: that isn't it, maybe if you review your answer

Q: I think each question should solve three parts.

A: As per Bartleby guidelines only first three subparts of a given question should be answered. Here,…

Q: fill in the graph and color critical path red please help

A: To fill in the boxes in the graph, we need to calculate the Early Start (ES), Early Finish (EF),…

Q: Question 24 Resource is a situation in which more resources than available are assigned to an…

A: Answer Resource Allocation Resource allocation is the way or process used to assigning and…

Q: Calculations are not right. incorrect forward pass and backward pass. there are incorrect numbers.…

A: Detailed explanation:(First Image)1. Forward PassThis calculates the earliest start (ES) and finish…

Q: 2. An individual is planning to take an 800-mile trip between two large cities. Three possibilities…

A: Given: Distance between two cities=800 mile Mode-1: Air Trip cost=$ 600 Travel time=8 hours.…

Q: d. e. f. Using a ruler to measure a box in front of you is an example of an indirect observation.…

A: Answers (d) Using a ruler to measure a box in front of you is an example of an indirect observation…

Q: blem #1: в (m) 800 + A (N) 200 + Y (N/m) 2 m 60° B Determine the horizontal reaction at A. (N)…

A: 1. Determine the horizontal reaction at A. 2. Determine the reaction at A. (N) 3. Determine the…

Q: Show complete solutions and write on the blanks provided. Include drawings/figures if needed. All…

Q: Note: Replace all zero digits of your ID number by number "2" Problem #3: y-axis Use X = Last 3…

Q: 13. Determine the horizontal reaction at A. (N) 14. Determine the vertical reaction at A. (N) 15.…

A: ∑MB=0 (Taking left part)VA×6 - 75×4=0VA=50 N ↑∑V=0VA+VD=75+175VD=200 N ↑

Q: oh no! it appears that you copied this answer from a similar question. The answer is wrong btw.

Q: 3. Compute the approximate area, in square meters, of a rectangular shaped tract of land whose sides…

Q: Note: 1)There is no more extra data. 2) This is not writing assignment question.

A: Whenever writing the research or the thesis regarding construction and the main purpose. There are…

Q: 1. Apparent Specific Gravity 2. Soil Structure

A: 1) Apparent specific gravity:- The weight in air of a unit volume of aggregate's impermeable…

Q: Answer the following four questions for the following information Time (min) Discharge (m³/s) disch…

A: The table given is of flood hydrograph. Since at the end and beginning of the observation flow is…

Q: Icasting corporation purchased an equipment for P53,000.0 and delivery charges to the job site. The…

A: Data given - Total cost = P53,000+P1,500=P54,500 Interest rate = 6.5%=0.065 Time = 10…

Q: Generally, there are 2 types of walls, Structural Walls, which are designed to carry loads and are…

A: A Walls Walls are structural elements that enclose, divide, or support buildings or other…

Q: The weight of the crate is 50 kg and the spring constant is 200 N/m in DB. Use g= 9.81 m/s2.

A: The Force system is classified according to the shape of the lines or the effect of the action of…

Q: Calculate the end areas for depths of fill from 0 to 20 ft using increments of 2 ft for level…

Q: a. b. C. d. ÏÏ The most important If a mistake is found Regarding surveying having too much…

A: There are three main sources of error arise: 1) Natural error - climate, wind, humidity etc. 2)…

Q: Multiple Attempts Not allowed. This test can only be taken once. Force Completion This test can be…

Q: Q1)Fill in the blanks with a suitable verb to do or verb to be. 1- where- you live? 2- Where- -you…

A: 1 Where do you live? 2 Where are you from? 3 Are you watching movei now?

Q: 3)Determine the Greenwich Civil Time when it is: a) 6:50 AM at 60° West longitude b) 10:00 AM at…

Q: How long after leaving the pier will the boats be 1600 ft apart?

Question

100%

1. Please I want answer of this question. Thanks

Note: Y = 8

1. A rectangular footing 2.0 m by 3.0 m is built in a homogeneous bed of sand of having
bulk unit weight 20 kN/m3 and saturated unit weight 21 kN/m³ with an angle of shearing
resistance of (30+Y)°. The depth of the base of footing is 1.8 m below the ground surface
and water table is located at a deth of 1.0m below the base of the foundation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Lateral earth pressure distribution against retaining walls

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

NOTE MY ID NUMBER 20-3994-175 ANSWER NUMBER 8 9 10 11 12 - Don’t round off answers unless it is already the final answer. -Final answers must be up to 3 decimal places only. PLEASE INDICATE THE NUMBER IN EVERY ANSWER.
Please use the image to answer the questions thank you!
What is the relationship between mass flow rate and volume flow rate?
Answer it asap i will upvote you
please help thann you
Question 4 Given that y= 5t3+7 and x =F-5 Find y" when x-6. Express your answer in whole number A Moving to another question will save this response. acer
Logged in as zenuh. Log Out webwork / mat228-rosen / homework 2/6 Homework 2: Problem 6 Problem List Next Problem Previous Problem (1 point). The distance d of a point P to the line through points A and Bis the length of the component of AP that is orthogonal to AB, as indicated in the diagram. So the distance from P = (4,0, –3) to the line through the points A= (2. –2. 4) and B = (-1, –5, –2) is Preview My Answers Submit Answers Show me another You have attempted this problem 15 times. You have 5 attempts left before new version will be requested Your overall recorded score is 0%. You have unlimnited attempts remaining. Reflect in ePortfolio Download Print Activity Details You have viewed this topic P Type here to search 立 Community
6. For the data in Problem 5 of Chapter 6, calculate 6 σ, Cp, and Cpk. Interpret the indices. The specification limits are 50 +/- 0.5. 225.00 226.00 227.00 226.00 227.00 228.00 228.00 229.00 222.00 223.00 224.00 226.00 227.00 228.00 225.00 221.00 227.00 229.00 230.00
fill in the graph and color critical path red. Check to see if it is all correct or if changes need to be done. Abbrevations are ES: early activity start LS: Late Activity Start Duration TF: Total Float EF: Early Activity Finish LF: Late Activity Finish
Please answer with explanation Thank you so much
All values should not be rounded off until the final answer.
Q2: Suppose a construction site is 35km away from the market area, Apply the knowledge of construction management which of the two theories I.e. “The just-in-time theory” or “The inventory buffer theory”, will you prefer for materials management and why? Civil Engineering Subject= Construction Management Answer in word format