1. A projectile is launched from point A with an initial velocity v, =100 m/s, the projectile hits the inclined hill at point B. determine (a) the distance d, (b) the velocity before the projectile hits point B. (c) the radius of curvature at B, and (d) the minimum radius of curvature of the trajectory. For a 2D motion of a projectile: v, - (v,), 10000 m

1. A projectile is launched from point A with an initial velocity v, =100 m/s, the projectile hits the inclined hill at point B. determine (a) the distance d, (b) the velocity before the projectile hits point B. (c) the radius of curvature at B, and (d) the minimum radius of curvature of the trajectory. For a 2D motion of a projectile: v, - (v,), 10000 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.47P: A rifle at A is fired at a target at B. If the speed of the bullet is 1400 ft/s, determine the...

See similar textbooks

Similar questions

PROBLEM 2.18 The trajectory of an object is given by the equation x(t) = (5m) + (26m/s)t – (12m/s² )t² 22. For which time t is the displacement x(t) at its maximum? 2.083s b. c. 4.083 s d. 1.083 s а. 3.082s 23. What is this maximum value? c. 20.08 m d. 21.08 m а. 18.08 m b. 19.08 m
4. Two particles, A and B, are moving in a straight line. Take this to be the r-axis. At t = 0, particle A is trailing particle B, initially at some distance z behind B. Particle B is accelerating at a constant 2.00 m/s² and particle A is constantly accelerating at 3.00 m/s². Particle A was able to overtake B after B has moved 50.0 m. (a) How long does it take for particle A to overtake B? (b) Initially, how far was A behind B? (c) How fast are the two particles moving as soon as they're at the same position?
A projectile is launched at a rate of 4.4 m/s at an angle of 55 . State the projectiles position every 0.1 s starting at t=0 s. keep going until the height of the projectile goes negative. (The shot of Odysseues...)
P2. A ball is kicked from the origin with an initial speed of v1, = 25.0 m/s, at an angle 0 with the horizontal. At the same time, a second ball is thrown vertically upward from the ground at point P, at x, = 40.0 m with an initial speed of v, = 15.0 m/s as shown in the figure below. Assume that both balls are shot at time t= 0 a) If the two balls are to hit each other, what must 0 be? b) At what time the two balls will hit each other? y 40 m
1. Two mobile containers, A and B, carries raw materials for concrete batching plant. The containers' motions are defined by their velocity vectors: for container A, A = 6i + 4k (km/hr) and for container B, B = -4i +7k (km/hr). What is the angle between the line of action (path) of both containers? Express your answer in units of degree. 2. Two cables A and B are attached to a hook. Cable A exerts a pull with a magnitude and direction defined by the vector A = 6i + 4k (kN). Cable B is also attached to the same hook where cable A is attached, cable B exerts a pull with a magnitude and direction defined by the equation B = -4i +7k (kN). What should be the magnitude of pull exerted at cable B such that the line of action of resultant force is along the positive z-direction (the resultant lies along the positive z-axis)? Express your answer in unit of kN.
Q2: The particle P starts from rest at point A at time and changes its speed thereafter at a constant rate of 2g as it follows the horizontal path shown. Calculate the magnitude and direction of its total acceleration for the following: (1) just before point B, (2) just after point B, and (3) As it passes point C. તd PDOW State your directions relative to the x-axis shown (CCW positive). P 3 m B 3.5 m Q
I Suppose an autonomous surface vessel (ASV) traveling with velocity TvG/O= vi₁ begins to make a turn by adjusting the thrust of its left and right thrusters, TA and TB, respectively. The center of mass of the ASV is located at G and the ASV is symmetric about its vertical axis. The ASV also experiences a drag force that is proportional to its speed and opposes its velocity. At the instant shown, the drag force is D = -kvi₁ where k is a drag coefficient. 1. To model the mass moment of inertia, approximate the ASV as consisting of three rigid bodies: a flat plate as a center body of mass 6m and two slender rods housing the propulsion assemblies, each of mass m, at the outboard sides of the vehicle. Determine the mass moment of inertia, IG, about the vertical axis passing through the center of mass G. (Hint: Use the parallel axis theorem.) 2. At the instant shown, determine the inertial acceleration vector ac/o = axi₁ + ayi2 of the center of mass and the angular acceleration a of the…
1) Near the end of its takeoff roll, the airplane is "rotating" (nose pitching up) just prior to liftoff. The velocity and acceleration of the aircraft, expressed in terms of the motion of the wheel assembly C, are Vc and ac, both directed horizontally forward. The pitch angle is 0, and the pitch rate w = ė is increasing at the rate a = w . If a person A is walking forward in the center aisle with velocity L and acceleration L , both measured forward relative to the cabin, calculate the components of the position, velocity and acceleration vectors in the inertial frame shown as OXY (ground-fixed). Y Y Xc Xc Origin of the Bxy frame is at the point B, and the point C of this frame has a position Xc, velocity Vc, and acceleration ac with respect to the inertial frame OXY. L W = 0 (DEGREE/S) . (DEGREE/S²) XC Vc ac L a = ) (m) (km/h) (m/s²) (m) (m) | (m/s) . (m/s²) (DEGREE) 3,6 16 1660 235 22 20 10 3
4. 2) The hydraulic cylinder D extends, moves the rigid rod ABC, and causes the collar A to move with velocity and acceleration both to the left. If the dimensions 4 1.0 ft, and 2 = 1.7 ft, VA = 4.9 ft/s, aa = 2.6 ft/s2, and the angle 0 = 27°, determine the speed of point B. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. В 12 D a Your Answer: Answer units 1,
4(a) A particle which moves with curvilinear motion has coordinates in millimeters which vary with the time t in seconds according to x = 5.6t2 - 3.7t and y = 5.7t2 - t3/1.7. Determine the magnitudes of the velocity v and acceleration a and the angles which these vectors make with the x-axis when t = 5.5 s.
Q4 2. A ball is launched with an initial velocity of Vo = 4.5 m/s from point P at a 30° sloped surface with an angle of 0. The ball lands at point B, which is 0.6 m higher than point A. Determine the launch angle 0 of the ball, the impact velocity at B (vB), the angle vg makes with the horizontal and the duration of the flight. Also determine the radius of curvature of the path and the rate of change of the speed of the ball at point C, where its trajectory makes an angle of 60° with the negative x-axis. g 9.81 m/s-.
A truck carries a crate which can slide. Suppose that the truck and the crate are initially traveling to the right with velocity Vo, and the distance between the front of the crate and the front of the trailer given as do. The brakes are applied so that the truck decelerates with constant acceleration and stops in time t a.) Express the truck's acceleration ar ts e.) Integrate equations (1) once and use initial velocity and the continuity of the relative velocity function d dot(t) at t, to find the velocity of the crate at the moment when the truck stops: d dot(t,)--Vats.Express it in terms of given quantities [see the list in (b)]. f.) Let the initial distance be given as do. Integrate the equations for velocities from (e) and use the initial conditions and continuity of d(t) at ts, to find the crate stopping time tcs and the crate stopping distance des g.) Using the results from (f), determine the minimum value of μ (in terms of do, ts, g, and v ) so that the crate does not hit the…