1. A cylindrical water tank with depth of 4 feet and radius of 8 feet has one circular base on the ground. If the tank is full, how much work (in ft-lbs) is required to pump all the water in the tank 5 feet above the top of the tank (9 feet above the ground). Note: Water weighs 62.4 lbs/ft^3. [Answer: 351,295 ft-lbs] [Hint: Follow Example 4, but notice the radius is a constant 8 in this question.]

1. A cylindrical water tank with depth of 4 feet and radius of 8 feet has one circular base on the ground. If the tank is full, how much work (in ft-lbs) is required to pump all the water in the tank 5 feet above the top of the tank (9 feet above the ground). Note: Water weighs 62.4 lbs/ft^3. [Answer: 351,295 ft-lbs] [Hint: Follow Example 4, but notice the radius is a constant 8 in this question.]

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter65: Achievement Review—section Six

Section: Chapter Questions

Problem 42AR: Solve these prism and cylinder exercises. Where necessary, round the answers to 2 decimal places...

See similar textbooks

Similar questions

A seamless brass tube and brass flange assembly is shown. The tube is pressed fit into the full 1.250-inch plate thickness. The brass used weighs 0.305 pound per cubic inch. Find the total weight of the assembly. Round the answer to the nearest tenth pound.
Find the volume of a steel shaft that is 18.64 cm long and has a radius of 1.75 cm. Round your answer to 2 decimal places.
A combination of gage Nocks is selected to provide a total thickness of 0.4573 inch. One block 0.250 inch thick and one block 0.118 inch thick arc selected. What is the required thickness of the remaining blocks?
Solve these prism and cylinder exercises. Where necessary, round the answers to 2 decimal places unless otherwise specified. Find the volume of a right circular cylinder that has a height of 4,600 inches and a base area of 53.00 square inches.
A shaft is turned in a lathe at 120 revolutions per minute. The cutting tool advances 0.030 inch per revolution. How bong is the length of cut along the shaft at the end of 3.50 minutes?